2006 YAMAHA GRIZZLY 660 clock

4-11 1. Speedometer 2. Fuel meter
3.“H” button 4.“M” button
5. Clock/Hour meter
6. Odometer/Tripmeter A/Tripmeter B
7. TRIP/ODO button
8. Clock/Hour “”/“” button
1. Compteur de vitesse
2. Afficheur du niveau de carburant
3. Bouton de réglage des heures “H”
4. Bouton de réglage des minutes “M”
5. Montre/compteur horaire
6. Compteur kilométrique/totalisateurs journaliers A et B
7. Bouton TRIP/ODO
8. Bouton de sélection montre/compteur horaire “”/“”
1. Velocímetro 2. Medidor de combustible
3. Botón “H”4. Botón “M”
5. Reloj/contador de horas
6. Cuentakilómetros/cuentakilómetros parcial A/
cuentakilómetros parcial B
7. Botón TRIP/ODO
8. Reloj/Botón “”/“” de la hora
EBU15100
Speedometer unit
The speedometer unit is equipped with the follow-
ing:

a speedometer (which shows the riding speed)


an odometer (which shows the total distance
traveled)


two tripmeters (which show the distance trav-
eled since they were last set to zero)


a clock


an hour meter (which shows the total time the
key has been turned to “ON”)


a fuel meter
U2C660.book Page 11 Monday, April 11, 2005 10:29 AM

4-13 1. Speedometer 2. Fuel meter
3.“H” button 4.“M” button
5. Clock/Hour meter
6. Odometer/Tripmeter A/Tripmeter B
7. TRIP/ODO button
8. Clock/Hour “”/“” button
1. Compteur de vitesse
2. Afficheur du niveau de carburant
3. Bouton de réglage des heures “H”
4. Bouton de réglage des minutes “M”
5. Montre/compteur horaire
6. Compteur kilométrique/totalisateurs journaliers A et B
7. Bouton TRIP/ODO
8. Bouton de sélection montre/compteur horaire “”/“”
1. Velocímetro 2. Medidor de combustible
3. Botón “H”4. Botón “M”
5. Reloj/contador de horas
6. Cuentakilómetros/cuentakilómetros parcial A/
cuentakilómetros parcial B
7. Botón TRIP/ODO
8. Reloj/Botón “”/“” de la hora
Odometer and tripmeter modes
Pushing the “TRIP/ODO” button switches the dis-
play between the odometer mode “ODO” and the
tripmeter modes “A” and “B” in the following order:
ODO
→TRIP A
→TRIP B
→ODO
To reset a tripmeter, select it by pushing the
“TRIP/ODO” button, and then push the
“TRIP/ODO” button for at least three seconds. The
tripmeters can be used to estimate the distance
that can be traveled with a full tank of fuel. This in-
formation will enable you to plan future fuel stops.NOTE:_ Holding in the “TRIP/ODO” button and then turning
the key to “ON” switches the display between
“mph” and “km/h”. _
U2C660.book Page 13 Monday, April 11, 2005 10:29 AM

4-15 1. Speedometer 2. Fuel meter
3.“H” button 4.“M” button
5. Clock/Hour meter
6. Odometer/Tripmeter A/Tripmeter B
7. TRIP/ODO button
8. Clock/Hour “”/“” button
1. Compteur de vitesse
2. Afficheur du niveau de carburant
3. Bouton de réglage des heures “H”
4. Bouton de réglage des minutes “M”
5. Montre/compteur horaire
6. Compteur kilométrique/totalisateurs journaliers A et B
7. Bouton TRIP/ODO
8. Bouton de sélection montre/compteur horaire “”/“”
1. Velocímetro 2. Medidor de combustible
3. Botón “H”4. Botón “M”
5. Reloj/contador de horas
6. Cuentakilómetros/cuentakilómetros parcial A/
cuentakilómetros parcial B
7. Botón TRIP/ODO
8. Reloj/Botón “”/“” de la hora
Clock mode
Pushing the “”/“” button switches the dis-
play between the clock mode “CLOCK” and the
hour meter mode “HOUR” in the following order:
CLOCK
→HOUR
→CLOCK
To set the clock1. Set the display to the clock mode.
2. Push the “”/“” button until the clock
starts flashing.
3. Set the hours by pushing the “H” button.
4. Set the minutes by pushing the “M” button.
5. Push the “”/“” button, and then re-
lease it to start the clock.
U2C660.book Page 15 Monday, April 11, 2005 10:29 AM

4-16
Montre
Appuyer sur le bouton “”/“” pour alterner l’affi-
chage de la montre “CLOCK” et du compteur horaire
“HOUR” comme suit:
CLOCK→HOUR→CLOCK
Réglage de la montre1. Afficher la montre à l’écran.
2. Appuyer sur le bouton “”/“” jusqu’à ce
que l’affichage de la montre se mette à clignoter.
3. Régler les heures en appuyant sur le bouton “H”.
4. Régler les minutes en appuyant sur le bouton “M”.
5. Appuyer sur le bouton “”/“”, puis le relâ-
cher afin d’activer la montre.
Modo de reloj
Presionando el botón “”/“” se cambia la vi-
sualización entre el modo del reloj “CLOCK” y el
modo del contador de horas “HOUR” en el orden si-
guiente:
CLOCK
→HOUR
→CLOCK
Para poner el reloj en hora1. Ajuste la visualización al modo del reloj.
2. Presione el botón “”/“” hasta que el reloj
empiece a parpadear.
3. Ajuste las horas presionando el botón “H”.
4. Ajuste los minutos presionando el botón “M”.
5. Para poner en funcionamiento el reloj, presione
el botón “”/“” y suéltelo.
U2C660.book Page 16 Monday, April 11, 2005 10:29 AM

4-47 1. Fuel tank cap
1. Bouchon du réservoir de carburant
1. Tapón del depósito de combustible
EBU00092
Fuel tank cap
Remove the fuel tank cap by turning it counter-
clockwise.
U2C660.book Page 47 Monday, April 11, 2005 10:29 AM

8-133 1. Main fuse 2. Spare main fuse
3. Headlight fuse 4. Ignition fuse
5. Auxiliary DC jack fuse 6. Four-wheel-drive fuse
7. Signaling system fuse
8. Backup fuse (for odometer and clock)
9. Spare fuse (× 3)
1. Fusible principal 2. Fusible principal de rechange
3. Fusible de phare 4. Fusible d’allumage
5. Fusible de prise pour accessoires
6. Fusible du système quatre roues motrices
7. Fusible du système de signalisation
8. Fusible de sauvegarde (compteur kilométrique)
9. Fusible de rechange (× 3)
1. Fusible principal 2. Fusible principal de repuesto
3. Fusible del faro
4. Fusible del sistema de encendido
5. Fusible de la toma de CC auxiliar
6. Fusible del sistema de tracción en las cuatro ruedas
7. Fusible del sistema de señalización
8. Fusible de reserva (para el cuentakilómetros)
9. Fusible de repuesto (× 3)
EBU07454*
Fuse replacement
1. The main fuse and the fuse box are located
under the seat.
2. If a fuse is blown, turn off the main switch and
the switch of the circuit in question. Then, in-
stall a new fuse of the specified amperage.
Turn on the main switch. If the fuse immedi-
ately blows again, consult a Yamaha dealer.
Specified fuses:
Main fuse: 30 A
Headlight fuse: 15 A
Ignition fuse: 10 A
Auxiliary DC jack fuse: 10 A
Four-wheel-drive fuse: 3 A
Signaling system fuse: 10 A
Backup fuse: 10 A
E-8.fm Page 133 Wednesday, April 13, 2005 11:54 AM

8-139 1. Headlight bulb holder
1. Fixation d’ampoule de phare
1. Portabombillas del faro
1. Do not touch the glass part of the bulb.
1. Ne pas toucher le verre de l’ampoule.
1. No tocar la parte de cristal de la bombilla.
3. Remove the headlight bulb holder by pushing
it in and turning it counterclockwise.
4. Remove the defective bulb by pulling it out.
WARNING
_ A headlight bulb is hot when it is on and imme-
diately after it is turned off. Wait for the bulb to
cool before touching or removing it. You can
be burned or a fire could start if the bulb touch-
es something flammable. _5. Insert a new headlight bulb into the bulb hold-
er by pushing it in.CAUTION:_ Do not touch the glass part of the headlight
bulb to keep it free from oil, otherwise the
transparency of the glass, the luminosity of the
bulb, and the bulb life will be adversely affect-
ed. Thoroughly clean off any dirt and finger-
prints on the headlight bulb using a cloth
moistened with alcohol or thinner. _6. Install the headlight bulb holder by pushing it
in and turning it clockwise.
7. Install the bulb holder cover and cover at the
rear of the headlight.
U2C660.book Page 139 Monday, April 11, 2005 10:29 AM

8-141 1. Headlight beam adjusting screw
1. Vis de réglage du faisceau de phare
1. Tornillo de ajuste de la luz del faro
1. Tail/brake light bulb holder
1. Fixation d’ampoule de feu arrière/stop
1. Portalámparas de la luz de freno/piloto trasero
EBU01089
Headlight beam adjustmentCAUTION:_ It is advisable to have a Yamaha dealer make
this adjustment. _To raise the beam, turn the adjusting screw in di-
rection
a.
To lower the beam, turn the adjusting screw in di-
rection
b.
EBU15050
Tail/brake light bulb replacement
1. Remove panel G. (See pages 8-35–8-37 for
removal and installation procedures.)
2. Remove the bulb holder (together with the
bulb) by turning it counterclockwise.
3. Remove the defective bulb from the bulb
holder by pushing it inward and turning it
counterclockwise.
U2C660.book Page 141 Monday, April 11, 2005 10:29 AM