2006 YAMAHA FX HO reset

2-32
E
The following operation buttons are on the
right side of the multifunction meter.
1
“Mode/Reset” button
2
“Start/Stop” button
To switch the display mode, push the
“Mode/Reset” button 1
for less than 1 sec-
ond. The display mode changes in the fol-
lowing order.
Compass → Average speed → Tr i p m e t e r
→ Trip timer → Fuel consumption per hour
→ Fuel consumption per kilometer/mile →
Water temperature → Air temperature
NOTE:@
To switch the display units between kilo-
meters/liters/degrees Celsius and miles/
gallons/degrees Fahrenheit, push the
“Vo l t / H o u r” button 3
for at least 1 second,
within 10 seconds after the multifunction
meter starts operating.

The “SPEED” indicator light blinks three
times if miles/gallons/degrees Fahrenheit
are selected as the display units when the
multifunction meter starts operating, or if
the display units of the meter are switched
to miles/gallons/degrees Fahrenheit.
@
E_F1X-70.book Page 32 Friday, August 26, 2005 11:00 AM

2-33
E
Compass
This display shows the current direction of
the watercraft using the 8 major compass
points.
NOTE:@ The accuracy of the compass varies
depending on the operating conditions. Use
this function as a reference only.
@
Average speed
This display shows the average speed in
miles per hour “AV M P H” or kilometers per
hour “AV K M H” since it was reset.
Tr i p m e t e r
This display shows the distance traveled
in miles “MILES” or kilometers “KM” since it
was reset.
Trip timer
This display shows the hours of operation
“TRIPTM” since it was reset.
E_F1X-70.book Page 33 Friday, August 26, 2005 11:00 AM

2-35
E
Average speed/Tripmeter/Trip timer
modes
Average speed, distance traveled, and
trip time are recorded once measurements
have started, regardless of the current dis-
play.
To start the measurements, push the
“Start/Stop” button 2 for less than 1 sec-
ond. The beeper sounds once.
To stop the measurements, push the
“Start/Stop” button for less than 1 second.
The beeper sounds once. To restart the
measurements, push the “Start/Stop” button
for less than 1 second. The beeper sounds
once.
To reset the displays, push the “Mode/
Reset” button 1 for at least 2 seconds while
the measurements are stopped. The beeper
sounds twice.
NOTE:@ The displays can be reset only when the
measurements are stopped.
@
E_F1X-70.book Page 35 Friday, August 26, 2005 11:00 AM