Tightening torque:
Spark plug:
20 Nm (2 m•kgf)
NOTE:
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is
1/4–1/2 turn past finger tight. Howe-
ver, the spark plug should be tighte-
ned to the specified torque as soon
as possible.
EAU19950
Transmission oil
1. Oil level window
2. Maximum level mark
3. Minimum level mark
The transmission oil level should be
checked before each ride. In addition,
the transmission oil must be changed
at the intervals specified in the perio-
dic maintenance and lubrication
chart.
To check the transmission oil level
1. Place the vehicle on a level surfa-
ce and hold it in an upright posi-
tion.
NOTE:
Make sure that the vehicle is positio-
ned straight up when checking the oil
level. A slight tilt to the side can result
in a false reading.
1. Plug to fill with oil
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil
settles, and then check the oil
level through the check window
located at the right side of the
crankcase.
NOTE:
The transmission oil should be at or
above the minimum level mark.
4. If the oil is below the minimum
level mark, remove the oil filler
cap, add sufficient oil of the
recommended type to raise it to
the correct level, and then install
and tighten the cap.
To change the transmission oil
1. Drain bolt
6
PERIODIC MAINTENANCE AND MINOR REPAIR
6-7
2
3
11
1
1D0-F8199-E2.qxd 20/9/04 11:32 Página 38
