2006 YAMAHA CYGNUS 125 stop start

Parts list of ZY125T-3 motorcyclePARTS LIST AND OPERATION
3-1
rearview mirror
storage
compartment
taillight
exhaust piperear wheel
accu-
mulatorfuse
front turn signalfront brake leverfront headlight
front wheeldish brake
handlebar switch
odometerrear brake lever
main switch
rear luggage carrier
rear light/stoplightrear vibration damperair filterkick-startercrankcase filter
front vibration
damper
side-standcenter-standfront stor-
age com-
partment

1.Turn the switch to
position "ON", the
electric system will
be powered and the
engine can be
started.
2.The key can not be
removed.
1.Turn the switch to
position "OFF",
power off the elec-
tric system and the
engine will be
stopped.
2.The key can be
removed.
ON
OFF
LOCK
1.Power off the
engine, and turn the
key counterclockwise
to position "OPEN",
unlock the seat lock ;2.When the steering
system and the cen-
ter-stand are
locked, turn the key
counterclockwise to
position "OPEN",
unlock the seat lock;
3.The key can not
be removed.
1.Turn on electric door lock
2.Turn off electric door lock
4.
Lock the steering system and center-stand3.Open the rider seat
NOTE:
When you do not operate the
motorcycle, you should turn the key
to position "OFF" or "LOCK", and re-move the key.
1.Turn the handlebar, push the key in-
ward and turn to position LOCK
2.Remove the key(1.)If you do not ride the motorcycle, you can
turn the handlebar to left till the end of
travel, and lock the handlebar as per
following instructions to prevent your
motorcycle from being stolen:NOTE: When you lock the handlebar, you
should lock it when turning, do not push
the key inward to lock the handlebar
by force, it will cause inner core
broken.
When operating motorcycle, you
should not turn the key to positionLOCK.
OPEN
■ ■■ ■
■Switch operation
1.Push the key inward
and turn counterclock-
wise to position "LOCK",
lock the steering system
and center-stand ;2.If the center-stand is
not in position, you
cannot lock it. Once the
center-stand is in
position, it will be
locked automatically.
3.The key can be
removed.
PARTS LIST AND OPERATION
(2.)
3-3

WARNING

1.Never start the engine in a closed
environment. The exhaust fumes are
poisonous which may cause loss of
consciousness and death within a
short time. Operate the motorcycle
always with adequate ventilation.
2.Make sure that the side-stand has
been back to its original position be-
fore riding; otherwise, serious acci-
dent may occur when turning.
3.After warming the engine, hold the
fixed bracket by right hand and push
the motorcycle off the center-stand.
4.Sit astride the seat and adjust the
rear view mirrors.
5.Check the oncoming traffic; switch
on the turn signal before starting off.
RUNNING AND OPERATION
6.Turn the throttle grip on the right
handlebar slowly to take off, switchoff the turn signal.■ ■■ ■
■Shut-down the engine and
park the motorcycleWhen stopping, turn the main switch
to position OFF.
WARNING

Since the exhaust pipe of muffle
may become extremely hot, you
should park the motorcycle in a
place where pedestrians or children
are unlikely to come in contact with
the vehicle. Do not park on a slope
or soft ground, otherwise the mo-torcycle may overturn.
5-2

■ ■■ ■
■Tyre1.Tyre pressure:
Adjust the tyre pressure to value
specified before riding.
2. Tyre casing
Check the situation of the tyre before
riding. If the tyre casing is over worn,
or there are pins or broken glasses, or
the tyre casing has crackles, ask the
agency to repair it, replace if
necessary.
■ ■■ ■
■Petrol levelMake sure that there is sufficient petrol
in the fuel tank.
WARNING

Do not splash or overfill the gaso-
line to the exhaust pipe when
fueling. There are agents equipped
in the exhaust pipe. The surface
temperature is very high, and it mayburn when the gasoline is spilled.■ ■■ ■
■Throttle gripPlace the throttle grip to check the
operation and free gaps. Make sure
that the grip will return to the original
position by spring force when releasing.
Ask the agency to adjust if necessary.Specified
fuel
CapacityOnly with unleaded petrol (#93 unleaded
fuel recommended)
5.4L totally
front tyre: 175Kpa
rear tyre: 200Kpa
front tyre: 175Kpa
rear tyre: 225Kpa 1 person Tyre pressure
2 persons
NOTE: Check the tyre pressure when the tyreis cooled.
WARNING

Never overload at any time,
otherwise, it may cause hazardbecause of tyre bursting.Check the front headlight, position light,
turn signal, rear light, stoplight, instru-
ment light and all the other indicator
lights, and make sure that they run
well.
■ ■■ ■
■SwitchesCheck the operation of the switches
for front headlight, position light, turn
signal, stoplight, horn and starter, main
switch.■ ■■ ■
■Lights and signal light
PRE-OPERATION CHECKS
6-3
foreign material (pin,gallet)
alligatoring, broke
wear limit indicator
3-5mn