192
HomeLink® Universal Transceiver (option)
8901344e
HomeLink®® Universal
Transceiver
Indicator light
Hand-held transmitter
HomeLink® Universal Transceiver
HomeLink® is an advanced system that can be programmed to learn the
codes of three different remote controlled-devices (e.g., garage door
openers, remote lighting, entry door lock). HomeLink®’s sun visor-
mounted transceiver, powered by your car’s electrical system, may then
be used in place of your hand-held remote controls.
@ GY=
Programming the transceiver
%
:
; ,1
GY =
*
<
-
, %
-
1
GY=
*2
GYC
-
,
8
1
*F
,F%*1
GY
@
GY % &22 -FF -F%F , #
G
1
/
=
C
"
GY
"
F
,
1 :9
; 8
"
-
/
GY=
C
GY % &22 -FF -F%F
, #
G
1
WARNING!
•If you use HomeLink® to open a garage door or gate, be sure no
one is near the gate or door while it is in motion.
•Do not use the HomeLink® Universal Transceiver with any garage
door opener that lacks safety “stop” and “reverse” features as
required by federal safety standards. (This includes any garage door
opener model manufactured before April 1, 1982). A garage door
opener that cannot “detect” an object, signalling the door to “stop”
and “reverse” does not meet current federal safety standards. Using
a garage door opener without these features increases the risk of
serious injury or death. For more information on this matter, call
toll-free 1-800-355-3515 (Internet: www.HomeLink.com).
193 5
During programming, your hand-held transmitter may automatically stop
transmitting. To successfully train HomeLink®, continue to hold the
HomeLink® button. At the same time, repeatedly press and hold your
hand-held transmitter’s button at two-second intervals until HomeLink®
has learned your transmitter’s code. The HomeLink® indicator light
will flash first slowly, and then rapidly to indicate that the button has
been successfully programmed.
Determining if your garage door uses a rolling code
Determine, in one of the following ways, if your garage door uses a
rolling code system and is manufactured after 1996:
•"
C
•
GY
=
•9
GY
GY
8
*
To train a rolling code garage door opener, follow these instructions
after programming the desired transceiver button according to “Program-
ming the transceiver.” The help of a second person may make training
easier.
%
G
,$
C
% &22 -FF -F%F , #
G
1
*
9 :
;
:
;
-
9
GY
9
GY
)
$
GY=
The remaining two HomeLink® buttons can be programmed in the
same way. In the event of any problems in programming the
HomeLink® Universal Transceiver, call toll-free 1-800-355-3515
(Internet: www.HomeLink.com).
Operating the HomeLink® Universal Transceiver
Once programmed, the HomeLink® Universal Transceiver can be used
in place of your hand-held transmitters.
To operate, the key must be turned to the “accessory” position (II) or
the engine must be running. Press the programmed HomeLink® button
to activate the garage door, driveway gate, security lighting, home
security system, etc.
Your original hand-held transmitters may, of course, be used at any
time.
Erasing programmed buttons
Individual buttons cannot be erased. To erase all three programmed
buttons:
%
:
; ,1
*
GY=
*2 GYC
-
"
The HomeLink® buttons can be reprogrammed using the procedures
described on the previous page.
,GY
8
1
HomeLink® Universal Transceiver (option)
