104
8901671d
Load carriers (models with rails)
Load carrier cover
The car's ignition key or the stud on the edge
of the supplied torque wrench can be used to
undo or tighten the cover. Turn a quarter turn
(90 degrees). See illustration.
Fitting the load carriers
(accessory)
Make sure that the load carrier is pressed
firmly out against the roof rail. Screw the load
carrier in place. Use the supplied torque
wrench and tighten to the mark on the wrench
(corresponding to 6 Nm). See illustration.
Position of load carriers
Make sure that the wing-shaped load carriers
are installed on the roof rails with the rounded
edge forward (see the inset illustration above).
The load carriers are identical and can be
placed anywhere along the roof rails.
Reducing wind noise and
improving fuel economy
8A
A
6
8901878m
8901672m
107
Towing a trailer
•"
•6
WARNING!
•Bumper-attached trailer hitches must not be used on Volvo’s, nor
should safety chains be attached to the bumper.
•Trailer hitches attaching to the vehicle rear axle must not be used.•Never connect a trailer’s hydraulic brake system directly to the
vehicle brake system, nor a trailer’s lighting system directly to the
vehicle lighting system. Consult your nearest authorized Volvo
retailer for correct installation.
•When towing a trailer, the trailer’s safety wire must be correctly
fastened to the hole or hook provided in the trailer hitch on the car.
The safety wire should never be fastened to or wound around the
drawbar ball.
NOTE:
•When parking the car with a trailer on a hill, apply the parking
brake before putting the gear selector in (P)ark or reverse on
models with a manual transmission. Always follow the trailer
manufacturer's recommendations for wheel chocking.
•When starting on a hill, put the gear selector in (D)rive before
releasing the parking brake.
•If you use the manual (Geartronic) shift positions while towing a
trailer, make sure the gear you select does not put too much strain
on the engine (using too high a gear).
•The drawbar assembly/trailer hitch may be certified for trailers that
are heavier than the car is designed to tow. Please adhere to Volvo’s
recommended trailer weights.
* When driving for prolonged periods at temperatures above 86° F
(30° C), the maximum recommended weight is 2000 lbs (900 kg).
When preparing for trailer towing, observe
the following:
Volvo recommends the use of Volvo trailer hitches which are specially
designed for the car.
•7
8
6 #
"
$%0F2 ,.F21
"
$--22 N,%F221
+
$
•(6
#
•
) ;4
;
•4
0*2 ,%2221
•"
#
"*0F2 ,%*221 %%2 ,F21
&*0F2 ,%*221 %0F ,.F1
•7
8
#F2,&2$1
•H
>
=
•
8
•(
•
•
,
$
1
•'
C
C
•7
120
Wheels and tires
=
:;
8
>
=
8903767a8903767j
TIRESIZE
*
TIREANDLOADINGINFORMATION TIREANDLOADINGINFORMATIONSEATINGCAPACITY
SEATINGCAPACITY
TOTAL5 TOTAL5FRONT2FRONT2REAR3 REAR3ThecombinadwaightofoccupantsandcargoshouldneverexeedxxxkgorxxxpoundsCOLDTIREINFLATIONPRESSURE
COLDTIREINFLATIONPRESSUREFRONT200KPA,29PSI
200KPA,29PSI REAR
COMPACTSPARETIREP195/70R14ORGINALTIRESIZE
T125/70D15
420KPA,60PSI8903541j
Tire inflation
5
(
%**
C <
,
C 1
5
=
=
=
4
(%2
% ,.9
1
5
>
C
Checking tire pressure
"
& (
*
3
#
-
Tire inflation placard on Canadian models, 1. XC70, 2. V70 Tire inflation placards on U.S. models
7700591p
160
Engine oil
Changing engine oil and oil
filter
)
%.2
"
4
) "
•6
•)
8
9
6
Checking and adding oil
•
•
%2 %F
Checking the oil
%
9
*
"
-
(
Oil level should be between the MIN and MAX
marks on the dipstick
77(J 7
8
%=)
,%1
/
"
F
)
%2 %F
7(J
CAUTION!
•Not checking the oil level regularly can
result in serious engine damage if the oil
level becomes too low.
•Oil that is lower than the specified quality
can damage the engine.
•Always add oil of the same type and
viscosity as already used.
•Never fill oil above the MAX mark. This
could cause an increase in oil consump-
tion.
R-models
R-models are equipped with an oil level
warning system. If the engine oil level
becomes too low, the warning light in the
instrument panel will come on and a warning
will be displayed in the text window.
8++D+
+E)+++
%,%1
5
8++D++E
0 )+?55H0 55H
1+
,
%
0
,%
F 1
5
A
6
WARNING!
'
8
1661 Loads and Tire Pressures
, 1#5
2 Child safety latch label
3 Federal Motor Vehicle Safety Stan-
dards (FMVSS) specifications (USA)
and Ministry of Transport (CMVSS)
standards (Canada)
6
C
@
6
4 Loads and Tire Pressures - U.S.
models only
5
5 Vehicle Identification Number (VIN) *
6
6
6 Model plate
6
,61
5
Label information
N 6
,61
(
!
2
"
(
#
EXHAUSTEMISSIONArialS ArialCATEGORY5APPLICABLETO1996MODELYEARNEWTLEVPASSENGERCARS. THISVEHICLECONFORMSTOUSEPAANDCALIFORNIAREGULATIONSOBDIICERIFIED TUNE-UPSPECIFICATIONS:NOADJUSTMENTSNEEDEDIN-USE CERTIFICATION
6
TLEV
TLEV
9430236CATALYSTEXHAUSTEMISSIONCONTROLSYSTEM:SFI,HO2S(2),TWC,AIR EVOPARATIVEFAMILY:TVV1143AYPEA(86.130-96PROCEDURES)VEHICLEEMISSIONCONTROLINFORMATIONENGINE:B5254S MANUFACTURER:VOLVOCARCORP.,SWEDEN
ENGINEFAMILY:TVV2.4VJGKEK ENGINEDISPLACEMENT:2435cm149cuin
7
VACUUMHOSEROUTING8
24VJGKEF
1
TARTSNRPO
MOTORVEHICLESAFETYANDBUMPERArialSIN THISVEHICLECONFORMSTOALLAPPLICABLEFEDERAL
EFFECTONTHEDATEOFMANUFACTURESHOWNABOVE.
MFD.BYVOLVOGOTHENBURGSWEDEN
N
VINDATE G.A.W.R.FRONTGV.W.RPASSCAR G.A.W.R.REAR
4
2
3
VCMSS984
CAANDA
VCANS
21kg kgkg
kg
0300399m
7 D
!
6
@
6
8 Vacuum hose routing
, 1
181
Steering wheel key pad
(option)
If the vehicle is equipped with the key pad in
the steering wheel press the right or left arrow
to switch between preset stations.
Scan
Press the SCAN button to start the station scan
function. When a station is found, scanning
stops for approximately 10 seconds, after
which scanning will continue.
Press the SCAN or SOURCE button when a
station has been found if you would like to
listen to that station and to discontinue the
scan function.
Station seek up/down
Press or to start the seek function. The
radio seeks the next audible station and tunes
it in. Repeat the procedure to continue the seek
function.
Radio functions HU-650/HU-850
3905010m
Manual station search
Press or and hold it down. MAN will
be shown in the display. The radio scans
slowly in the selected direction and will
increase the scanning speed after a few
seconds. Release the button when the desired
frequency appears in the display.
The frequency can be fine-tuned by short
presses on the
or keys.
The system will remain in manual search
mode for 5 seconds after the button is released,
after which it will return to seek mode.V70/XC70 V70 R3902452d3905086m
187
HU-850 - internal CD changer
Starting the CD changer
The HU-850 is equipped with an internal, 6-
disc CD changer.
Please refer to the illustration on page 178 for
the location of the buttons referred to on this
page.
To load discs into the changer:
%
9 5')+="5H
5'
*
)
G+('')5
-
If there are discs in the player when CD mode
is selected, the changer will resume playing the
disc and track that were most recently played.
Selecting a disc position
(number)
Use the station setting buttons 1-6 to select the
disc to be played. The number of the disc and
the track being played are shown in the
display.
Changing tracks
Briefly press the or keys (or the
corresponding keys on the optional steering
wheel keypad) to skip to the previous or next
track. The track number is shown in the
display.
Fast forward/back
Press and hold down the or keys to
search within a track or the entire disc. The
search continues for as long as the buttons are
held in.
$
Random play
This function plays the tracks on a CD in
random order (shuffle).
•)5'
"'
"'
"
•9 "'
Scan
This function plays the first 10 seconds of each
track on the CD.
•9 )5(
•9 )5(
HJ
)
CD eject
This function makes it possible to eject a
single disc, or to eject all of the discs in the
changer.
•9 >>
•( ,
1
>
•HEH5(GG
•@
%*
>
(
5'
•)
%.0
188
External CD changer (option)
External CD changer
The optional 10-CD changer is mounted in the
cargo compartment.
Please refer to the illustrations on pages 177
and 178 for the location of the buttons referred
to on this page.
Turn the SOURCE knob to select the external
CD changer.
To load discs into the changer:
%
)5'
*
9 >5'
-
9
A
, 1
/
9
A
3903125m
If there are discs in the player when CD mode
is selected, the changer will resume playing
the disc and track that were most recently
played.
Selecting a disc position
(number)
Use the station setting buttons 1-6 to select the
disc to be played. Continue to press button 6 to
select discs 7-10.
The number of the disc and the track being
played are shown in the display.
Changing tracks
Briefly press the or keys (or the
corresponding keys on the optional steering
wheel keypad) to skip to the previous or next
track. The track number is shown in the
display.
Fast forward/back
Press and hold down the or keys to
search within a track or the entire disc. The
search continues for as long as the buttons are
held in.
$
Random play
This function plays the tracks on a CD in
random order (shuffle).
•)5'
"'
"'
"
•9 "'
Scan
This function plays the first 10 seconds of
each track on the CD.
•9 )5(
•9 )5(HJ
)