2006 TOYOTA PRIUS child restraint

93
On vehicles with side airbags and
curtain shield airbags, do not allow
the child to lean his/her head or
any part of his/her body against the
door or the area of the seat, front
or rear pillar or roof side rail from
which the side airbags or curtain
shield airbags deploy even if the
child is seated in the child restraint
system. It is dangerous if the side
airbag and curtain shield airbag in-
flate, and the impact could cause
death or serious injury to the child.
22p036f
Do not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.
If the driver ’s seat position does
not allow sufficient space for safe
installation, install the child re-
straint system on the rear right
seat.
22p046c
1. Run the lap and shoulder belt throughor around the convertible seat following
the instructions provided by its
manufacturer and insert the tab into
the buckle taking care not to twist the
belt. Keep the lap portion of the belt
tight.

95
22p049c
CAUTION
Push and pull the child restraint sys-
tem in different directions to be sure
it is secure. Follow all the installation
instructions provided by its manufac-
turer.
22p050b
4. To remove the convertible seat, pressthe buckle release button and allow the
belt to retract completely. The belt will
move freely again and be ready to
work for an adult or older child passen-
ger.
22p051c
(C) BOOSTER SEAT INSTALLATION
A booster seat must be used in for-
wardfacing position only.

96
22p052a
Move seat
fully back
CAUTION
A forwardfacing child restraint
system should be allowed to be
installed on the front passenger
seat only when it is unavoidable.
Always move the seat as far back
as possible even if the front pas-
senger occupant classification indi-
cator light indicates “OFF”, because
the front passenger airbag could in-
flate with considerable speed and
force. Otherwise, the child may be
killed or seriously injured.
On vehicles with side airbags and
curtain shield airbags, do not allow
the child to lean his/her head or
any part of his/her body against the
door or the area of the seat, front
or rear pillar or roof side rail from
which the side airbags or curtain
shield airbags deploy even if the
child is seated in the child restraint
system. It is dangerous if the side
airbag and curtain shield airbag in-
flate, and the impact could cause
death or serious injury to the child.
22p053c
1. Sit the child on a booster seat. Runthe lap and shoulder belt through or
around the booster seat and across the
child following the instructions provided
by its manufacturer and insert the tab
into the buckle taking care not to twist
the belt.
Make sure the shoulder belt is correctly
across the child’s shoulder and that the
lap belt is positioned as low as possible
on the child’s hips. See “Seat belts” on
page 58 for details.

98
— U sin g a to p st rap
22p055c
Follow the procedure below for a child
restraint system that requires the use
of a top strap.
22p056e
Anchor brackets
Symbol
Use the anchor brackets on the back of
the rear seatback to attach the top strap.
Anchor brackets are installed for each
rear seating position.
This symbol indicates the location of the
anchor brackets.
22p063b
TO USE THE ANCHOR BRACKET:1. Remove the luggage cover (see “Luggage cover” on page 314.) and
raise the head restraint to the upper-
most lock position.

99
22p215
2. Open the cover of the anchor brack-et.
22p064e
3. Fix the child restraint system withthe seat belt.
Latch the hook onto the anchor
bracket and tighten the top strap.
For instructions to install the child re-
straint system, see “Child restraint” on
page 86.
CAUTION
Make sure the top strap is securely
latched, and check that the child re-
straint system is secure by pushing
and pulling it in different directions.
Follow all the installation instructions
provided by its manufacturer.

100
22p076f
The lower anchorages for the child re-
straint system interfaced with the
FMVSS225 or CMVSS210.2 specification
are installed in the rear seat.
The anchorages are installed in the clear-
ance between the seat cushion and seat-
back of both outside rear seats.
Child restraint system interfaced with the
FMVSS213 or CMVSS213 specification
can be fixed with these anchorages. In
this case, it is not necessary to fix the
child restraint system with a seat belt on
the vehicle.22p077h
Canada only
Ty p e A
22p078g
Canada only
Ty p e B
—Installation with child
restraint lower anchorages

101
CHILD RESTRAINT SYSTEM INSTALLA-
TION1. Widen the gap between the seat cushion and seatback slightly and
confirm the position of the lower an-
chorages below the symbol in the
seatback.
2. Type A—Latch the hooks of lower straps onto the anchorages and
tighten the lower straps.
Type B—Latch the buckles onto the
anchorages.
For owners in Canada
The symbol on a child restraint system
indicates the presence of a lower connec-
tor system.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see “—Using
a top strap” on page 98.) For installation details, refer to the instruc-
tion manual equipped with each product.
CAUTION
When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
Do not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.

437
Occupant restraint sys-tems
Toyota encourages you and your
family to take the time to read
Section 2−2 of this Owner’s Manu-
al carefully. In terms of helping
you understand how you can re-
ceive the maximum benefit of the
occupant restraint systems this ve-
hicle provides, Section 2 −2 of this
Owner ’s Manual is the most im-
portant section for you and your
family to read.
Section 2 −2 describes the function
and operation concerning seats,
seat belts, SRS airbags and child
restraint systems of this vehicle
and some potential hazards you
should be aware of. These sys-
tems work together along with the
overall structure of this vehicle in
order to provide occupant restraint
in the event of a crash. The effect
of each system is enhanced when
it is used properly and together
with other systems. No single oc-
cupant restraint system can, by it-
self, provide you or your family
with the equal level of restraint
which these systems can provide
when used together. That is why it
is important for you and your fam-
ily to understand the purpose and
proper use of each of these sys-
tems and how they relate to each
other.
The purpose of all occupant re-
straint systems is to help reduce
the possibility of death or serious
injury in the event of a collision.
None of these systems, either in-
dividually or together, can ensure
that there is no injury in the event
of collision. However, the more
you know about these systems
and how to use them properly, the
greater your chances become of
surviving an accident without death
or serious injury.
Seat belts provide the primary re-
straint to all occupants of the ve-
hicle, and every occupant of the
vehicle should wear seat belts
properly at all times. Children
should always be secured in child
restraint systems that are ap-
propriate for their age and size.
SRS (Supplemental Restraint Sys-
tem) airbags are, as their names
imply, designed to work with, and
be supplemental to, seat belts and
are not substitutes for them. SRS
airbags can be very effective in
reducing the risk of head and
chest injuries by preventing con-
tact of the head and chest with
interior portions of the vehicle.