2006 TOYOTA PRIUS display

108
Limitations of the
navigation system
This navigation system calculates the cur-
rent vehicle position using satellite sig-
nals, various vehicle signals, map data,
etc. However, the accurate position may
not be shown depending on the satellite
condition, road configuration, vehicle
condition or other circumstances.
The Global Positioning System (GPS) devel-
oped and operated by the U.S. Department of
Defense provides an accurate current vehicle
position using 3 to 4 satellites. The GPS sys-
tem has a certain level of inaccuracy. While
the navigation system will compensate for
this most of the time, occasional positioning
errors of up to 300 feet (100 m) can and
should be expected. Generally, position er-
rors will be corrected within a few seconds.
When your vehicle is receiving signals from
the satellites, the “GPS” mark appears at the
top left of the screen.
The GPS signal may be physically ob-
structed, leading to inaccurate vehicle posi-
tion on the map display. Tunnels, tall build-
ings, trucks, or even the placement of objects
on the instrument panel may obstruct the
GPS signals.
The GPS satellites may not send signals due
to repairs or improvements being made to
them.
Even when the navigation system is receiving
clear GPS signals, the vehicle position may
not be shown accurately or inappropriate
route guidance may occur in some cases.
NOTICE
The installation of window tinting may
obstruct the GPS signals. Most window
tinting contains some metallic content
that will interfere with GPS signal recep-
tion. We advise against the use of win-
dow tinting on vehicles equipped with
navigation systems.

109
(a) Accurate current vehicle position
may not be shown in the following cases:
When
driving on a small angled Y −shaped
road.
When driving on a winding road.
When driving on a slippery road such as
in sand, gravel, snow, etc.
When driving on a long straight road.
When motorway and surface streets run
in parallel.
After moving by ferry or vehicle carrier.
When a long route is searched during high
speed driving.
When driving without setting the current
position calibration correctly.
After repeating a change of direction by
going forward and backward, or turning on
a turntable in the parking lot.
When leaving a covered parking lot or
parking garage.
When a roof carrier is installed.
When driving with tire chains installed.
When the tires are worn.
After replacing a tire or tires.
When using tires that are smaller or larger
than the factory specifications.
When the tire pressure in any of the four
tires is not correct.
INFORMATION
If your vehicle cannot receive GPS sig-
nals, you can correct the current posi-
tion manually. For information on set-
ting the current position calibration, see
page 88.
(b) Inappropriate route guidance may oc-
cur in the following cases:
When turning at an intersection off the
designated route guidance.
If you set more than one destination but
skip any of them, auto reroute will display
a route returning to the destination on the
previous route.
When turning at an intersection for which
there is no route guidance.
When passing through an intersection for
which there is no route guidance.
During auto reroute, the route guidance
may not be available for the next turn to
the right or left.
It may take a long time to operate auto re-
route during high speed driving. In auto
reroute, a detour route may be shown.
After auto reroute, the route may not be
changed.
An unnecessary U− turn may be shown or
announced.
A location may have multiple names and
the system will announce one or more.
Some routes may not be searched.
If the route to your destination includes
gravel, unpaved roads or alleys, the route
guidance may not be shown.
Your destination point might be shown on
the opposite side of the street.

11 0
When a portion of the route has regula-
tions prohibiting the entry of the vehicle
that vary by time or season or other rea-
sons.
The road and map data stored in your nav-
igation system may not be complete or
may not be the latest version.
After replacing a tire, implement the op-
eration described in the “TIRE CHANGE
CALIBRATION”. (See page 89.)
This navigation system u ses tire turning data
and is designed to work with factory −speci-
fied tires for your vehicle. Installing tires that
are larger or smaller than the originally
equipped diameter may cause inaccurate
display of the vehicle’s position. The tire pres-
sure also affects the diameter of the tires so
please make sure the tire pressure of all four
tires is correct.
Map database information and
updates —
This system uses the maps of DENSO.
© GDT, Geographic Data Technology,
Inc.
© 2004 NAVTEQ. All rights reserved.
Data by infoUSA Copyright © 2004, All
Rights Reserved.
© 2005 VISA Corporation
National Research Bureau ©2004
The Bullseye Design is a registered
trademark of Target Brands, Inc.
END USER LICENSE AGREEMENT
PLEASE READ THIS AGREEMENT
CAREFULLY BEFORE USING THE
NAVIGATION SYSTEM
THIS IS A LICENSE AGREEMENT
FOR YOUR COPY OF THE MAP DA-
TABASE (“The DATABASE”), ORIGI-
NALLY MADE BY Geographic Data
Technology, Inc. (“GDT”), USED IN
THE NAVIGATION SYSTEM. BY US-
ING THE DATABASE, YOU ACCEPT
AND AGREE TO ALL TERMS AND
CONDITIONS SET FORTH BELOW.
OWNERSHIP
The DATABASE and the copyrights
and intellectual property or neighbor-
ing rights therein are owned by GDT or
its licensors.
LICENSE GRANT
GDT grants you a non−exclusive li-
cense to use your copy of the DATA-
BASE for your personal use or for use
in your business’ internal operations.
This license does not include the right
to grant sub− licenses.
LIMITATIONS ON USE
The DATABASE is restricted for use in
the specific system for which it was
created. Except to the extent explicitly
permitted by ma ndatory laws, you may
not extract or re−utilize any portion of
the contents of the DATABASE, nor re-
produce, copy, modify, adapt, trans-
late, disassemble, decompile, or re-
verse engineer any portion of the DA-
TABASE.

11 4
Indemnity. You agree to indemnify, de-
fend and hold DENSO and its licensors
(including their respective licensors,
suppliers, assignees, subsidiaries, affili-
ated companies, and the respective offi-
cers, directors, employees, sharehold-
ers, agents and representatives of each
of them) free and harmless from and
against any liability, loss, injury (includ-
ing injuries resulting in death), demand,
action, cost, expense, or claim of any
kind or character, including but not limit-
ed to attorney’s fees, arising out of or in
connection with any use or possession
by you of this information.END USER NOTICE
The marks of companies displayed by
this product to indicate business loca-
tions are the marks of their respective
owners. The use of such marks in this
product does not imply any sponsor-
ship, approval, or endorsement by
such companies of this product.
ENDUSER TERMS
The Map Data Disc (“Data”) is provided
for your personal, internal use only and
not for resale. It is protected by copy-
right, and is subject to the following
terms and conditions which are agreed
to by you, on the one hand, and DEN-
SO CORPORATION (“[LICENSEE]”)
and its licensors (including their licen-
sors and suppliers) on the other hand.
Such licensors include NAVTEQ North
America, LLC. Without limiting the
foregoing, you agree that NAVTEQ
North America, LLC shall have the
right to enforce these Terms directly
against you.
© 2004 NAVTEQ. All rights reserved.
The Data for areas of Canada includes
information taken with permission from
Canadian authorities, including: © Her
Majesty the Queen in Right of Canada,
© Queen’s Printer for Ontario, © Cana-
da Post Corporation, Geobase .
TERMS AND CONDITIONS
Personal Use Only. You agree to use
this Data for the solely personal, non
commercial purposes for which you
were licensed, and not for service bu-
reau, time−sharing or other similar pur-
poses. Accordingly, but subject to the
restrictions set forth in the following
paragraphs, you may copy this Data
only as necessary for your personal
use to (i) view it, and (ii) save it, pro-
vided that you do not remove any copy-
right notices that appear and do not
modify the Data in any way. You agree
not to otherwise reproduce, copy,
modify, decompile, disassemble or re-
verse engineer any portion of this
Data, and may not transfer or distribute
it in any form, for any purpose, except
to the extent permitted by mandatory
laws. You may transfer the Data and all
accompanying materials on a perma-
nent basis if you retain no copies and
the recipient agrees to these End−
User Terms. Multi −disc sets may not
be transferred on a divided basis.

11 6
Export Control. You agree not to ex-
port from anywhere any part of the
Data provided to you or any direct
product thereof except in compliance
with, and with all licenses and approv-
als required under, applicable export
laws, rules and regulations.
Entire Agreement.
These terms and
conditions constitute the entire agree-
ment between [LICENSEE] (and its li-
censors, including their licensors and
suppliers) and you pertaining to the
subject matter hereof, and supersedes
in their entirety any and all written or
oral agreements previously existing
between us with respect to such sub-
ject matter.
Governing Law.
The above terms and
conditions shall be governed by the
laws of the Illinois, without giving ef fect
to (i) its conflict of laws provisions, or
(ii) the United Nations Convention for
Contracts for the International Sale of
Goods, which is explicitly excluded.
You agree to submit to the jurisdiction
of Illinois for any and all disputes,
claims and actions arising from or in
connection with the Data provided to
you hereunder.
Government End Users. If the Li-
censed Data is being acquired by or on
behalf of the United States govern-
ment or any ot her entity seeking or ap-
plying rights similar to those customari-
ly claimed by the United States govern-
ment, (i) for acquisitions conducted by
the Department of Defense, the Li-
censed Data is licensed with “Limited
Rights” in accordance with the rights
set forth at DFARS
252.227 −7013(b)(3), TECHNICAL
DATA−NONCOMMERCIAL ITEMS,
and Licensed Data delivered or other-
wise furnished with “Limited Rights”
shall be marked with the following
“Limited Rights Notice” set forth at
DFARS 252.227 −7013(f)(3), and shall
be treated in accordance with such No-
tice:LIMITED RIGHTS
CONTRACTOR (MANUFACTUR- ER/ SUPPLIER) NAME:
NAVTEQ North America, LLC
CONTRACTOR (MANUFACTUR- ER/SUPPLIER) ADDRESS:
222 Merchandise Mart Plaza,
Suite 900, Chicago, Illinois 60654
The Government’s rights to use,
modify, reproduce, release, perform,
display, or disclose these technical
data are restricted by paragraph
(b)(3) of the Rights in Technical
Data−Noncommercial Items clause
contained in the above identified
contract. Any reproduction of techni-
cal data or portions thereof marked
with this legend must also reproduce
the markings. Any person, other
than the Government, who has been
provided access to such data must
promptly notify the above named
Contractor.

11 7
and; (ii) for civilian agency acquisi-
tions, the Licensed Data is licensed in
accordance with the rights set forth at
FAR 52.227−14(g)(1), RIGHTS IN
DATA−GENERAL (Protection of limit-
ed rights data and computer software ).
In the event that the Contracting Offi-
cer requires the delivery of limited
rights Licensed Data that has been
withheld or would otherwise be with-
holdable in accordance with FAR
52.227 −14(g)(1), the Licensed Data is
licensed with “Limited Rights” as set
forth in the following “Limited Rights
Notice” at FAR 52.227− 14(g)(2) (Alter-
nate II), which shall be affixed to the Li-
censed Data and the Licensed Data
shall be treated in accordance with
such Notice (which shall be marked on
any reproduction of these data, in
whole or in part):LIMITED RIGHTS NOTICE
(JUN 1987)
These data may be reproduced and
used by the Government with the ex-
press limitation that they will not,
without written permission of the
Contractor, be used for purposes of
manufacture nor disclosed outside
the Government; except that the
Government may disclose these
data outside the Government for the
following purposes, if any, provided
that the Government makes such
disclosure subject to prohibition
against further use and disclosure:
There are no additional purposes
permitting disclosure of such Data.
The manufacturer/supplier of the
Data is NAVTEQ North America,
LLC, 222 Merchandise Mart Plaza,
Suite 900, Chicago, Illinois 60654.
If the Contracting Officer refuses to use
either of the licenses provided in (i) or
(ii), herein, the Contracting Officer
must notify NAVTEQ North America,
LLC prior to seeking additional or alter-
native rights in the Licensed Data. There are two types of areas available for
route guidance. In one type of area, pri-
marily around metropolitan centers, de-
tailed route guidance is available for the
entire area. In the other type of area, all
roads are displayed on the map but route
guidance is
limited. The navigation route
might lack precision because the data (no
right turns, oneway traffic, etc.) is not
complete. It is still possible to reach the
destination by following the arrow direc-
tion and distance as shown on the bottom
left of the screen. The arrow points in the
direction of the destination. The distance
shown is as measured in a straight line
from the current vehicle position to the
destination area.
In order to provide you with as accurate map
information as possible, we are always gath-
ering information such as on road repairs and
carrying out on−site investigations. However,
the names of roads, streets, facilities, and
their locations frequently change. In some
places, construction on roads may be in pro-
gress. For that reason, information on some
areas in this system might be different from
the actual location.
The map database is normally updated once
a year. Contact your dealer for information
about the availability and pricing of an update.

11 8
1U020
The map database is normally updated once
a year. Contact your dealer for updating a
map database.
To confirm the database version and
disc coverage area
1. Push the “MENU” button.
2. Touch “Map DVD”.
Make sure the version of the database on this
screen. (The database version on the screen
above may be different from the actual
screen.) To display the disc coverage area, touch
“Covered Area”
. Confirm the covered area
on the screen.
Contact your dealer to find out if there is a
more recent update available.