2006 TOYOTA HIGHLANDER warning light

[x] Cancel search: warning light

Page 150 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
140
If the light stays on, it indicates that the
SRS driver and front passenger airbag
system and/or front passenger occupant
classification system and “AIRBAG ON”
an

Page 151 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
141
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road conditions. If the light comes on,
re

Page 165 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
155
TRACTION CONTROL OFF MODE
If your wheels get stuck in an ditch
when you are driving on a severe off
road and sand, turn off the traction
control system. This system t

Page 166 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
156
In the following cases, contact your Toyota
dealer:
The warning light does not  come on
after the ignition key is turned to “ON”.
The warning light remains on a

Page 167 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
157
When the traction control system is oper-
ating, the following conditions occur:
The system controls the spinning of the
4 wheels. At this time, the slip indica-
tor

Page 169 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
159
“VSC” warning light
This light warns that there is a problem
somewhere in the vehicle stability control
system or the traction control system.
The light will come

Page 170 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
160
LOW TIRE PRESSURE WARNING LIGHT
This light comes on when the ignition key
is turned to the “ON” position. It goes off
after a few seconds. This indicates that
the

Page 171 of 428

TOYOTA HIGHLANDER 2006 XU20 / 1.G Owners Manual ’06 HIGHLANDER_U (L/O 0508)
161

The loading is over  the limit or imbal-
anced.
Initialization was not performed correct-
ly after replacing or rotating tires or
wheels.
The outside temperature