AVALON_Navi_U (L/O 0508)
11 6
2006 AVALON Navigation from Aug. ’05 Prod. (OM41416U)
When the headlight switch is at “ON”
position, the screen changes to the day
mode or night mode.
To display the screen in the day mode
even with the head light switch on, select
“DAY MODE” switch on the adjust-
ment screen for brightness and contrast
control.
If the screen is set in the day mode with
the headlight switch turned to on, this
condition is memorized in the system even
with the engine turned off. The speech command system allows
you to operate the navigation system
with your voice.
1. Push the speech command switch.
A beep sounds and an indicator is shown
on the screen.
2. Give a command while an indicator is shown on the screen.
If the navigation system does not respond
or the confirmation screen does not disap-
pear, please push the speech command
switch and try again.
If no command is given, a beep sounds
and the indicator disappears 6 seconds
later.
If the system does not recognize your
speech, the system will respond with this
message (“System does not recognize this
command, please rephrase your com-
mand.”). Start the operation from the be-
ginning.
See page xii for the command list.
Speech command system
AVALON_Navi_U (L/O 0508)
11 7
2006 AVALON Navigation from Aug. ’05 Prod. (OM41416U)
Microphone
It is unnecessary to speak directly into
the microphone when giving a com-
mand.
Speech command example: Searching
for a route to your home.1. Push the speech command switch.
2. Say “Go home”.
If your home is not registered, you will
hear “Home is not registered”.
3. If you hear “Are you sure that you want a route to home?” (also shown
on the screen), push the speech
command switch and say “Yes”.
If you say “No”, the search will be can-
celed. 4. You will hear “Calculating route to home” and then the system starts
searching for a route.
INFORMATION
In the following conditions, the sys-
tem may not recognize the command
properly.
The command is not correct or
clear.
There are some noises such as wind
noise, etc.
