2006 Seat Ibiza 5D oil filter

SEAT maintenance program
8SEAT maintenance programUsing these instructionsThis programme will indicate the work that should be pe riodically carried out
on your vehicle in order to maintain the safety, reliability and lifetime condi-
tions required.
Using the “vehicle identification” data or the data in this document, the
correct spare parts for your vehicle will be specified in ca se of repairs; even
many years following the initial purchase.
We recommend that you keep this maintenance programme with the vehicle
documents. The Proof of service is one of the fundamental r equirements for
warranty rights.
The maintenance programme shows the date of delive ry and this indicates
the beginning of the vehicle guarantee.Maintenance ProgramThe SEAT maintenance programme is composed of di fferent inspection serv-
ices carried out according to the time since the vehi cle purchase or the
mileage.
Each Inspection Service as well as an y required additional operation already
has a pre-established work time. This will allow you to know the total cost of
the service beforehand.
. The SEAT Service Centre network is equipped with modern technology and
well-trained specialists. Many SEAT Service Centres offer different value
service packages
Adverse weather conditionsThe Service Centre “service consultant” will inform you of any necessary addi-
tional work within the intervals defined by the Inspection Ser vice depending
on the conditions and the environment in which the vehicle is used. For
example, for an oil change where the vehicle is use d only for frequent short
journeys or is subject to extreme temperatures. Likewis e, when the vehicle is
used in dusty conditions the air, dust and pollen filter cartridges must be
changed more often and the timing belt checked.Diesel fuelThe Service Centre “service consultant” can provide inf ormation about which
countries use fuel with a high sulphur content. In th ese cases, the oil must be
changed every 7,500 km / 4,650 miles.
Caution
•
Vehicles with the label “UNSUITABLE FOR BIODIESEL” on th e fuel cover
cannot be driven using biodiesel.
•
To be certain if your vehicle can be used with biodiesel according to the
DIN EN 14214 (FAME) standard consult your Serv ice Centre.
•
DIN is a German abbreviation for “Deutsches Institut für Normug e.V.”, the
German standards institute.
•
EN means European Norm.
•
FAME is the English abbreviation “F atty Acid Methyl Ester”
dsfsd Seite 8 Mittwoch, 3. Mai 2006 5:05 17

Inspection Service general programme11
•
Brake fluid change (every 2 years).
Inspection Service every 15,000 km or 1 yearOperations to be completed on your vehicle•
Label “Next Service”: Note the date, mileage and atta ch it to the door
frame.
•
Engine oil and oil filter: Replacement.
•
Front and rear brake pads: Inspection
•
Service interval indicator on the instrument panel: Re set.
•
Tyres, including the spare wheel: Check the profile, tread wear indicator
and pressure.
•
Interior and glove compartment lighti ng, lighter/socket, warning lights
and horn: Check operation.
•
Front/rear boot lights, indicators and hazard lights: Check operation.
•
Windscreen and headlights washer system: Check oper ation and for
possible damage, top up.
•
Exhaust gases installation: Verify attachments and ch eck for leaks and
damage.
Inspection Service every 30,000 km or each 2 yearsOperations to be completed on your vehicle:•
Exhaust gases installation: Verify attachments and ch eck for leaks and
damage.
•
Steering ball joints: Verify attachme nts and check for leaks and damage.
Check for play.
•
Label “Next Service”: Note the date, mileage and atta ch it to the door
frame.
•
Automatic gearbox (differe ntial): Check the oil level, top-up if necessary.
•
Battery: Inspection
•
Brake system: Check for leaks and damage.
•
Front and rear brake pads: Inspection.
•
Brake fluid level, according to brake pad wear: Inspecti on.
•
Self-diagnosis: Check fault memory in all systems.
•
Front/rear boot lights, indicators and hazard lights: Che ck operation.
•
Poly-V belt: Check condition.
•
Poly-V belt: Check tension (only engines without automatic tension
device).
•
Cooling system: Check the coolant level and the anti- freeze protection.
•
Engine and engine compartment components: Check f or leaks and
damage (from above).
•
Engine and engine compartment comp onents, gearbox and steering ball
joints: Check for leaks and damage (from bellow).
•
Engine oil and oil filter: Replacement.
dsfsd Seite 11 Mittwoch, 3. Mai 2006 5:05 17

Inspection Service general programme
12•
Test drive: Check brake operation, handbrake, gearbo x operation,
steering system operation, kick-down (for autom atic gearbox), air condi-
tioning and sliding roof.
•
Interior and glove compartment lighti ng, lighter/socket, warning lights
and horn: Check operation.
•
Tyres, including the spare wheel: Check the profile, tread wear indicator
and pressure.
•
Headlights: Check adjustment.
•
Windscreen and headlights washer system: Check operation and for
possible damage, top up.
•
Sun roof: Check operation, clean drains and grease guides.
•
Service interval indicator on the instrument panel: Re set.
•
Door and tailgate hinges: Lubricate.
•
Undercarriage protection: Visual damage inspection
•
Steering servo: Check oil level.
Additional workIn addition to the Inspection Service, additional maint enance jobs may have
to be carried out, depending on the conditions in which y our vehicle is used
and depending on the equipment level of your vehicle. Th is additional work
should be carried out in accordance with time/dista nce travelled to ensure
your vehicle remains reliable. Your Serv ice Centre will provide detailed infor-
mation about the additional work that may be neces sary. These can be done
independently of the obligatory services, taking int o account the notes in the
Maintenance Programme (or the label: Next service). Your SEAT Service
Centre will be happy to advise you and quote the p rices for this additional work. Additional jobs completed are marked on the w
orkshop sheet with the
receipt.
Every 7,500 km•
Engine oil and oil filter: Replacement (engines using high sulphur content
diesel).
Every 30,000 km•
Air filter: Clean the housing and replace the filter element (Ibiz a Cupra
only).
•
Fuel filter: Clean.
•
Fuel filter: Replacement (only diesel engines using biodi esel, or using fuel
that does not comply to the DIN EN 590 standard)
•
Dust and pollen filter for the passenger compartment : Replacement.
•
Manual gearbox: Check the oil level (for cases of perme ability).
Every 60,000 km•
Automatic gearbox (Gearbox): Check the ATF level.
•
Fuel filter: Replacement (only diesel engines using fuel conforming to the
DIN EN 590 standard)
•
Air filter: Clean the housing and replace the filter element.
dsfsd Seite 12 Mittwoch, 3. Mai 2006 5:05 17