Page 235 of 299

If and when233
Safety FirstOperating instructionsTips and MaintenanceTe c h n i c a l D a t a
WARNING
•If you are driving without the spare wheel, the cable should be rolled up
and the bracket fastened to the floor of the luggage compartment.
Fitting the defective wheel in the spare wheel casing
1. Place the wheel behind the vehicle.
2. Insert the support on the inside of the defective wheel, through
a central opening.
3. Insert the defective wheel below the vehicle, with the outer side
facing downwards.4. Remove the wheel spanner Ÿpage 232, fig. 153 and turn
the bolt on the floor of the luggage compartment several times to
the right, until the defective wheel is firmly secured against the
inside of the luggage compartment floor Ÿ in “Taking out
the spare wheel” on page 232.
5. Close the opening with the rubber seal Ÿpage 232, fig. 153
and lower the cover .
WARNING
Tighten the bolt of the luggage compartment to a maximum torque of 25
Nm.
Fig. 154 Resting point for
the spare wheel on the
bumper
AC
AB
AA
Page 239 of 299
If and when237
Safety FirstOperating instructionsTips and MaintenanceTe c h n i c a l D a t a
Removing the hubcaps
The hubcaps must be removed to gain access to the wheel
bolts.
– Take the wire hook from the vehicle tool kit.
– Insert the hook into a hole in the cover Ÿfig. 157.
– Pull off the cover.
Removing the caps from the wheel bolts
The caps must be removed from the wheel bolts before the
wheel bolts are unscrewed.
– Take the wire hook from the vehicle tool kit.
– Insert the hook through the opening in the middle of the cap
Ÿfig. 158.
– Use the wire hook to remove the caps.
The caps protect the wheel bolts and should be replaced after changing the
tyre.
When fitting, make sure that the caps click securely into place. They could
otherwise fall off.
Fig. 157 Removing the
hubcapsFig. 158 Use the hook to
pull off the cap
Page 248 of 299
If and when 246
– Remove the failed glass bulb and replace with a new bulb.
– Insert the lamp holder in the turn signal guide rail.
– First fit the turn signal in the opening of the chassis, securing the
tabs Ÿpage 245, fig. 165 and then, fit the lamp as shown by
the arrow .
Rear lights
Before changing a bulb, the tailgate should always be opened.
The lights have the following layout:
On the body
Turn signals, pilot light and brake/rear light
On the tailgate / rear door
Reversing light and rear antifog light.
Lights on vehicle body
– Open the cover in the luggage compartment trim.
– Press the side tabs in the direction of arrow Ÿfig. 166.
– Press the defective bulb into the bulb carrier, then turn it to the
left and remove it.
– Fit the new bulb and turn to the right as far as possible.
– Fit the lamp holder, press in until the tabs “click” into place.
A1
A2
Fig. 166 Lights on
vehicle body
Page 254 of 299