POWER ASSISTED STEERING
Fault finding - Customer complaints
36B
36B - 45V6 MR-366-X84-36B000$858_eng.mif
PAS
Vdiag No.: 04, 06, 08, 0C
and 12POWER ASSISTED STEERING
Fault finding - Customer complaints
NO DIALOGUE WITH THE COMPUTER ALP1
LOSS OF VEHICLE ASSISTANCE WITHOUT WARNING ALP2
POOR VEHICLE HANDLINGALP3
THE STEERING WHEEL DOES NOT RETURN BY ITSELF TO THE
CENTRE AT LOW VEHICLE SPEED: STEERING WHEEL SELF-
CENTRING INACTIVEALP4
UNDER-ASSISTANCE AT LOW SPEED AND OVER-ASSISTANCE AT
HIGH SPEEDALP5
TOO LITTLE ASSISTANCEALP6
ASSISTANCE AVAILABLE FOR 5 MIN. AFTER SWITCHING OFF THE
IGNITIONALP7
ASSISTANCE AVAILABLE BUT CHECK STEERING WARNING
MESSAGE DISPLAYED AND SERVICE WARNING LIGHT LIT
CONSTANTLY OR FLASHING AT 8 HzALP8
Vdiag 06 and 12 only
SERVICE INDICATOR LIGHT AND CHECK STEERING MESSAGE
COME ON STRAIGHT AWAYALP9
THE VEHICLE PULLS TO THE RIGHT OR TO THE LEFT ALP10
THE ENGINE DOES NOT START AND THE "STEERING NOT
UNLOCKED" IS DISPLAYED
OR
"STEERING NOT LOCKED" AFTER THE IGNITION IS SWITCHED
OFFALP11
MR-366-X84-36B000$858_eng.mif
POWER ASSISTED STEERING
Fault finding - Fault Finding Chart
36B
36B - 54V6 MR-366-X84-36B000$924_eng.mif
PAS
Vdiag No.: 04, 06, 08, 0C
and 12
ALP9The Service indicator light and the Check Steering message
come on straight away
NOTESApply the fault finding procedure only on Vdiag 06 and 12.
Check the conformity of the battery voltage and carry out fault finding on the charge circuit if necessary.
Check the condition and conformity of the ABS computer connector and its clips.
Check that the ABS computer has an electrical feed (see wiring diagram for the ABS fitted on the vehicle).
Disconnect the 8-track electric power assisted steering computer connector.
Check the condition and conformity of the connector and its clips.
If there is a repair procedure (see Technical Note 6015A, Electrical wiring repair, Wiring: Precautions for
repair), repair the connector, otherwise replace the wiring.
Carry out fault finding on the multiplex network (see 88B, Multiplexing).
Check the insulation, continuity and the absence of interference resistance on the following connections:
Electric power-
assisted steering
computer (8-track
connector)UCH
(PE2 40-track
connector)Protection and
Switching Unit (CT1
12-track connector)
track 7 track 8
track 5 track 18
track 6 track 8
track 16 track 1
track 3 ABS computer
track 2 ABS computer
(see wiring
diagram of the ABS
system installed in
the vehicle)
If there is a repair procedure (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair), repair the wiring, otherwise replace it.
If the connections previously checked are correct, contact the Techline.
AFTER REPAIRCarry out a check using the diagnostic tool.
DAETRW_V04_ALP09/DAETRW_V06_ALP09/DAETRW_V08_ALP09/DAETRW_V0C_ALP09/
DAETRW_V12_ALP09
