POWER ASSISTED STEERING
Fault finding - Fault Finding Chart
36B
36B - 47V6 MR-366-X84-36B000$924_eng.mif
PAS
Vdiag No.: 04, 06, 08, 0C
and 12
ALP2 Loss of vehicle assistance without warning
NOTES–apply the ALP after a complete check with the diagnostic tool,
–check the conformity of ET026 Computer calibration.
The vehicle loses the assistance function if the electric power assisted steering fuse is broken or the power supply
is lost.
The driver will feel the loss of the assistance on the steering wheel. Steering will then be the same as for unassisted
steering, manoeuvrable when driving even at low speed, but very difficult to manoeuvre when stationary.
Without its power supply, the power-assisted steering computer can no longer illuminate the warning light, and so
the driver is not made aware of the fault.
Check the electric power-assisted steering and engine compartment fuses (70A) and the passenger compartment
fuse (5A).
Change the fuses if necessary.
Check the computer supply voltage:
Black 2-track connector track 1 Vehicle earth
Black 8-track connector track 8 Vehicle earth
If there is a repair procedure (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair), repair the wiring, otherwise change the wiring.
Run a multiplex network test, and interpret any faults.
Check that the steering column and steering rack are in sound mechanical condition.
Repair if necessary.
Check that the front axle components, such as the track rod ends and shock absorber base plates, are in sound
mechanical condition.
Repair if necessary.
If the fault is still present, contact the Techline.
AFTER REPAIRCarry out a road test followed by a check with the diagnostic tool.
DAETRW_V04_ALP02/DAETRW_V08_ALP02/DAETRW_V06_ALP02/DAETRW_V0C_ALP02/
DAETRW_V12_ALP02
POWER ASSISTED STEERING
Fault finding - Fault Finding Chart
36B
36B - 53V6 MR-366-X84-36B000$924_eng.mif
PAS
Vdiag No.: 04, 06, 08, 0C
and 12
ALP8Assistance available but Check steering warning message
displayed and Service warning light lit continuously or flashing
at 8 Hz
NOTESNone
Check the vehicle battery voltage and the condition of the system's connections.
Repair if necessary.
Check the steering wheel angle sensor programming (ET020 = STATUS 4)
If the sensor is not calibrated, program the steering wheel angle sensor (procedure VP004 Steering wheel angle
sensor programming).
If the fault is still present, contact the Techline.
AFTER REPAIRCarry out a road test followed by a check with the diagnostic tool.
DAETRW_V04_ALP08/DAETRW_V08_ALP08/DAETRW_V08_ALP08/DAETRW_V0C_ALP08/
DAETRW_V12_ALP08
