MULTIPLEXING
Diagnostics - Dealing with faults
88B
88B-8
FAULTY COMPUTER
NOTES–Make sure the computers installed in the vehicle are the correct type and are
compatible with Mégane II.
–Check the power supply to the computers (earth, + battery, + accessories or + after
ignition).
Make sure that the computer wake-up mode is in full working order on the vehicle and properly assimilated
by the computers.
The wake-up mode is:
–timed power supply: UCH, instrument panel.
–+ accessories: Protection and Switching Unit, air conditioning control panel, radio, Control and
Communications Unit.
–+ After ignition: Injection, ABS, airbag, Electric Power Assisted Steering, Automatic transmission, LPG,
Steering lock, Roof control unit, Driving school unit, Automatic parking brake, Parking assistance.
–+ After ignition + dipped headlights: Xenon bulbs.
WARNING
Dialogue with the Xenon bulbs is only possible with + after ignition and the dipped headlights on.
–Switch to computer diagnostics mode.
Test of communication with computers.
⇒No communication from computers to diagnostic tool: see Fault Finding Chart 1
No communication with the computer or computers not communicating with the
diagnostic tool.
Check the connections to the computers and for no open circuit. Repair if necessary.
⇒Computers that only produce partial information when identified:
Check in the Workshop Repair Manual or Global Vehicle Base to see that the computer
really is compatible with Scénic II.
Make sure the CLIP diagnostic tool update is recent enough to handle Scénic II faults.
If after these tests no irregularity or open or short circuit has been detected, contact your Techline.
AFTER REPAIRCarry out a new multiplex network test with the diagnostic tool.
Clear the stored faults on all the computers connected to the network.
Deal with any other possible faults.
