2006 PORSCHE CAYENNE S light

Controls, Safety, Instruments
21
Locking vehicle doorsfBriefly press button 2 on the remote control.
The emergency flasher flashes twice and an
acoustic signal will sound twice.
The indication by the emergency flasher and by
the acoustic signal will be provided after all
doors and lids are closed.
All vehicle doors, the rear lid and the rear win-
dow cannot be opened from the outside.
The alarm system, passenger compartment
monitoring system and inclination sensor are
switched on.
Temporarily switching off passenger
compartment monitoring system and
inclination sensor
If people or animals are remaining in the locked ve-
hicle or the vehicle is being transported on a pas-
senger train or ship, for example, the passenger
compartment monitoring system and inclination
sensor must be deactivated.
To switch off passenger compartment monitoring
system and inclination sensor:
fPlease observe the chapter “TEMPORARILY
DEACTIVATING PASSENGER COMPARTMENT
MONITORING SYSTEM AND INCLINATION SEN-
SOR” on Page 29.
If the passenger compartment monitoring system
and inclination sensor are temporarily switched off
the emergency flasher flashes twice and an
acoustic signal will sound twice when the vehicle
is locked. All vehicle doors, the rear lid and the rear window
cannot be opened from the outside.
Malfunction of the remote control
The remote control may not function correctly due
to local radio waves. The vehicle will then not lock
properly.
This can be identified by the missing locking
sound and the missing check-back signal of the
hazard warning lights.
If this should occur:
fLock the vehicle with the key in the door lock.
Switching off the alarm system if it is
triggeredfUnlock vehicle doors or
fSwitch ignition on.ImmobilizerThere is a transponder (an electronic component),
containing a stored code, in each key.
Before the ignition is switched on, the ignition lock
checks the code.
The immobilizer can be deactivated and the en-
gine started only using an authorized ignition key.
Switching off the immobilizer
fInsert the ignition key into the ignition lock.
Switching on the immobilizer
fWithdraw the ignition key.

Controls, Safety, Instruments
23
Locking vehicle doorsfBriefly press button A in the door handle.
Emergency flasher flashes twice and an
acoustic signal will sound twice.
The indication by the emergency flasher and by
the acoustic signal will be provided after all
doors and lids are closed.
If the car key with remote control is out of ran-
ge, all vehicle doors, the rear lid and the rear
window cannot be opened from the outside.
The alarm system, passenger compartment
monitoring system and inclination sensor are
switched on.
Note on operation
– The key must be outside of the vehicle when
locking the vehicle doors, otherwise the vehi-
cle doors cannot be locked.Temporarily switching off passenger
compartment monitoring system and
inclination sensor
If people or animals are remaining in the locked ve-
hicle or the vehicle is being transported on a pas-
senger train or ship, for example, the passenger
compartment monitoring system and inclination
sensor must be deactivated.
To switch off passenger compartment monitoring
system and inclination sensor:
fPlease observe the chapter “TEMPORARILY
DEACTIVATING PASSENGER COMPARTMENT
MONITORING SYSTEM AND INCLINATION SEN-
SOR” on Page 29.
If the passenger compartment monitoring system
and inclination sensor are temporarily switched off
the emergency flasher flashes twice and an
acoustic signal will sound twice when the vehicle
is locked.
If the car key with remote control is out of range,
all vehicle doors, the rear lid and the rear window
cannot be opened from the outside.
Porsche Entry & Drive malfunction
Porsche Entry & Drive may not function correctly
due to local radio waves. The vehicle will then not
lock properly.
This can be identified by the missing locking
sound and the missing check-back signal of the
hazard warning lights. If this should occur:
fLock the vehicle with the key in the door lock.
Switching off the alarm system if it is
triggeredfUnlock vehicle doors with the remote control
or
fSwitch ignition on.ImmobilizerSwitching off the immobilizer
fSwitch ignition on.
Switching on the immobilizer
fSwitch ignition off and move control unit to the
left for 2 seconds.
fPlease observe the chapter “LOCKING THE
STEERING COLUMN” on Page 71.Switching off readiness for operationIf the vehicle is not unlocked within 3days the
Porsche Entry & Drive readiness for operation is
switched off.
fPull the door handle once, to reactivate the
system.
fPull the door handle again, to open the door.

Controls, Safety, Instruments
25
Indication by the emergency flashers and
acoustic soundIf the vehicle doors are unlocked or locked, a re-
sponse is provided by the emergency flashers and
acoustic sound (only when locking):
Unlocking with the remote control
– The hazard warning lights flash once.
Unlocking by pressing the button in the door
handle on vehicles with Porsche Entry &
Drive
– The hazard warning lights do not flash.
Locking
– The hazard warning lights flash twice.
– An acoustic signal will sound twice.
In the multi-purpose display of the instrument pan-
el, you can set the check-back signal when locking
and unlocking the vehicle and save it on the re-
spective remote control.
fPlease observe the chapter “SIGNAL” on
Page 121.
Central locking buttonCentral locking buttons A in the armrests let you
lock and unlock the vehicle electrically.
fPress the button A symbol.
All vehicle doors will be locked.
Each door can be opened by pulling the inner
door handle twice.
fPress the button A symbol.
If activated on the rear doors, only the relevant
door will be unlocked.
Note on operation
If the vehicle was locked with the key or by remote
control, it cannot be unlocked with the central
locking button.
Each door can be opened by pulling the inner door
handle twice.The power windows, the central locking buttons
on the rear doors and the rear control panel for
the air conditioning can be disabled using the safe-
ty button B in the armrest of the driver’s door.
Switching off
fPress safety button B.
The symbol in the safety button lights up.
Switching on
fPress safety button B again.
The symbol in the safety button goes out. Locking
Unlocking
Safety button

30
Controls, Safety, Instruments
A, D - Switch for reading lights
B- Button for dimming the comfort lighting
C- Switch for interior light1. Apply the parking brake.
2. Switch on interior lighting by moving switch C
to the left.
3. Remove ignition key.
On vehicles with Porsche Entry & Drive:
Switch off the ignition.
4. Open the driver‘s door.
The symbol on the top half of the rocker switch
flashes.5. Press the flashing top half of rocker switch un-
til the upper symbol lights permanently.
6. Lock the vehicle.
Emergency flasher flashes twice and an acous-
tic signal will sound twice.
The vehicle doors, the rear lid and the rear window
are locked but the doors can be opened from the
inside by pulling the inner door handle twice.
fInform any persons remaining in the vehicle
that the alarm system will be triggered if the
door is opened.
Note on operation
If the ignition is switched on after pressing the
rocker switch, the passenger compartment moni-
toring system is activated again. The symbols on
the rocker switch will flash.1. Apply the parking brake.
2. Switch on interior lighting by moving switch C
to the left.
3. Remove ignition key.
On vehicles with Porsche Entry & Drive:
Switch off the ignition.
4. Open the driver‘s door.
The symbol on the top half of the rocker switch
flashes.
5. Press the bottom half of rocker switch until the
lower symbol lights permanently.
6. Lock the vehicle.
Emergency flasher flashes twice and an acous-
tic signal will sound twice.
The vehicle doors, the rear lid and the rear window
are locked but the doors can be opened from the
inside by pulling the inner door handle twice.
fInform any persons remaining in the vehicle
that the alarm system will be triggered if the
door is opened.
Note on operation
If the ignition is switched on after pressing the
rocker switch, the inclination sensor is activated
again. The symbols on the rocker switch will flash. Deactivating passenger compart-
ment monitoring
Deactivating inclination sensor

Controls, Safety, Instruments
31
Deactivating passenger compartment
monitoring system and inclination sensor
1. Apply the parking brake.
2. Switch on interior lighting by moving switch C
to the left.
3. Remove ignition key.
On vehicles with Porsche Entry & Drive:
Switch off the ignition.
4. Open the driver‘s door.
The symbol on the top half of the rocker switch
flashes.
5. Press the bottom half of rocker switch until the
bottom symbol lights permanently.
6. Press the flashing top half of rocker switch un-
til the upper symbol lights permanently.
7. Lock the vehicle.
Emergency flasher flashes twice and an acous-
tic signal will sound twice.
The vehicle doors, the rear lid and the rear window
are locked but the doors can be opened from the
inside by pulling the inner door handle twice.
fInform any persons remaining in the vehicle
that the alarm system will be triggered if the
door is opened.Note on operation
If the ignition is switched on after pressing the
rocker switch, the passenger compartment moni-
toring system and the inclination sensor are acti-
vadet again. The symbols on the rocker switch will
flash.Activating the alarm system, the passenger
compartment monitoring system and
inclination sensor
fUnlock the vehicle and lock it again.
Fault indication
If the monitoring system and the inclination sensor
could not be deactivated the symbols on the rock-
er switch will flash (e.g. the rocker switch is
pressed with the ignition on).
For deactivating the passenger compartment
monitoring and inclination sensor:
fSwitch on interior lighting.
fSwitch off ignition.
fPress the rocker switch.
fLock the vehicle.

32
Controls, Safety, Instruments
A- Light-emitting diode for alarm systemFunction indicationThe locking condition of the vehicle is indicated by
a rapid flashing of the light-emitting diodes A in the
front doors.
The light-emitting diodes go out when the vehicle
is unlocked.The passenger compartment monitoring and
inclination sensor are switched on
– The light-emitting diodes flash for 2 seconds,
rapidly, then slowly.
The passenger compartment monitoring and
inclination sensor are switched off
– The light-emitting diodes flash for 2 seconds,
rapidly, then slowly.
The passenger compartment monitoring and
inclination sensor are switched off in the
multi-purpose display in the instrument panel
– The light-emitting diodes flash rapidly for
2 seconds, go out for 28 seconds and then
flash slowly.
Faults of the central locking system and the
alarm system
– The light-emitting diodes flash rapidly for
2 seconds, shine for 28 seconds and then
flash slowly.

Controls, Safety, Instruments
35
Comfort function for vehicles with
Porsche Entry & Drive
Warning!
Danger of injury. The window will close with
its full closing force.
fTake care to ensure that nobody can be injured when the windows close.
Opening and closing windows
fHold the car key in the door lock in the unlock-
ing or locking position until the windows have
reached the desired position.
If you unlock the vehicle with the key at the door
lock, only the driver’s door is unlocked. In order to
prevent the alarm system from being triggered,
you must switch the ignition on within 15 seconds
of opening the door.
Closing windows
fHold the button in the door handle when lock-
ing the vehicle until the windows and the Pano-
rama roof system have reached the desired
position.
Note on operation
The comfort function remains available for approx.
30 seconds after the vehicle has been locked.
Storing final position of the door windowsThe end positions of the door windows are lost
when the battery is disconnected and reconnect-
ed. The one-touch operation of the windows is dis-
abled.
Perform these procedures for all windows:
1. Close window completely once by pulling rock-
er switch.
2. Open window completely again by pressing
rocker switch.The power windows, the central locking buttons
on the rear doors and the rear control panel for
the air conditioning can be disabled using the safe-
ty button C in the armrest of the driver’s door.
Switching off
fPress safety button C.
The symbol in the safety button lights up.
Switching on
fPress safety button C again.
The symbol in the safety button goes out.
Safety button

Controls, Safety, Instruments
41
Rear SeatsThe rear seats are divided and can be folded
forward individually to make the loadspace bigger.
Caution!
Risk of damage to seat cushions, backrest,
and seat belt if only the backrest is folded
forward.
fAlways fold seat cushions and backrest forward.
Folding rear seats forwardIf the luggage safety net is installed, first set up
the left seat cushion in a vertical position and fold
the left rear seat backrest forward.On vehicles with automatically controlled
four-zone air conditioning:
fPress the safety button in the driver's door
armrest before folding the rear seats forward.
The rear control panel for the air conditioning
ceases to function.
This prevents unintentional adjustment of the
air conditioning.
The symbol in the switch lights up.
1. Remove the headrests of the backrest to be
folded forward.
Therefore:
Please observe the chapter “EXAMPLE: DRI-
VER’S SEAT” on Page 40.
2. Move front seats forward.
3. Pull seat cushion up at loop A.
4. Pull seat cushion forward (arrow B).
f f f
Safety button