Page 69 of 296
Controls, Instruments
69
Manual controlWhen the ignition is on, the spoiler can be 
extended and retracted manually using the button. 
Extending 
fPress button briefly. 
The spoiler extends to its final position. 
The light-emitting diode in the button lights up.
Running in
fPress and hold button until the spoiler has rea-
ched its final position. 
The light-emitting diode in the button goes out.
Fixed rear spoiler 
 Caution!
Risk of damage to rear spoiler. 
fPlease consult the operator before using auto-
matic car washes. 
fDo not push the vehicle by the spoiler.  
     
        
        Page 71 of 296

Controls, Instruments
71
Limits of ultrasonic measurement 
The parking assistant system cannot detect: 
– sound-absorbing obstacles (e.g. powder 
snow), 
– sound-reflecting obstacles (e.g. glass sur-
faces, flat painted surfaces) 
– and very thin obstacles. 
Other ultrasound sources (e.g. pneumatic brakes 
of other vehicles, jackhammers) can interfere with 
detection of obstacles. 
Fault indication 
The parking assistant system indicates a fault in 
two ways: 
– After reverse gear has been selected, the 
short signal tone is followed by a continuous 
tone of the same pitch:
This indicates that sensors are soiled or cove-
red with ice. 
– After reverse gear has been selected, the 
short signal tone is followed by a continuous 
tone with a much lower pitch:
This indicates a general system fault. Please 
have the fault remedied at an authorized 
Porsche dealer. 
A - Control switch for door mirror adjustment Swivelling down mirror glass on the 
passenger’s side On vehicles with seat memory you can activate an 
additional parking aid.
fPlease observe the chapter “SEAT MEMORY” 
on Page 36.
– When reverse gear is engaged, the mirror 
glass on the passenger’s side swivels down 
slightly to show the curb area. Preconditions
– Vehicle must be equipped with seat memory.
– Set the control switch A to “passenger’s side”.
– Reverse gear must be engaged.
Returning mirror glass to its original position
fDrive forwards with a speed of over 4 mph 
(6 km/h) or
– Set the control switch A to “driver’s side”. 
     
        
        Page 72 of 296
72
Controls, Instruments
Operation, Instruments 1 Light switch
2 Turn signals/
headlight dimmer/flasher lever
3 Ignition Lock/locking the steering column
4 Hands-free microphone for telephone
5Horn
6 Windshield wiper/washer lever
7 Porsche Communication Management/Radio
8 Interior temperature sensor, GPS antenna
9 Emergency flasher switch10 Central locking button, 
Readiness display for alarm system
11 Cupholder
12 Operating lever for on-board computer
13 Locking lever for steering-wheel adjustment
14 Operating lever for cruise control
15 Control panel for heating, ventilation and air 
conditioning system
16 Buttons for rear spoiler, 
Porsche Active Suspension Management 
(PASM),
Sport Mode,
Porsche Stability Management (PSM)
17 Seat heating, left/right 
     
        
        Page 111 of 296

Controls, Instruments
111
OIL
Display and measurement of the engine 
oil level
 Caution!
Risk of engine damage.
fRegularly check the oil level after refuelling.
fDo not allow the oil level to fall below the mini-mum mark.
Conditions for measuring the oil level
1. It is important to ensure that the vehicle is 
horizontal for correct oil level measurement 
to occur.
2. Engine is off.
3. Ignition on.Oil return time
Before the oil level is measured, the engine oil has 
to have flowed back into the oil pan.
The time taken for the engine oil to flow back de-
pends on the engine temperature and how long 
the engine has been stopped.
This waiting time is counted down in the on-board 
computer display when the ignition is switched on. 
The oil level display segments start to “cycle”.
fIt is best to measure the engine oil level before 
embarking on a journey (if the vehicle has not 
been driven for an extended period) or with the 
engine at operating temperature. Shorter wait-
ing times are achieved in this way.Initiating oil level measurement
fSwitch ignition on (do not start the engine).
The engine-oil level measurement display ap-
pears in the on-board computer.
fAllow waiting time to elapse.
fOnce the measurement has been completed, 
you can read off the engine oil level on the seg-
ment display.
– If the segments are filled in up to the top line, 
the oil level has reached the maximum mark. 
fUnder no circumstances add engine oil. 
     
        
        Page 112 of 296

112
Controls, Instruments – If the bottom segment is filled in, the oil level 
has reached the minimum mark.
fAdd engine oil immediately.
– If the segment flashes, the oil level has 
dropped to below the minimum mark.
fAdd engine oil immediately.
The difference between the minimum and maxi-
mum marks on the segment display is approx. 
1.2 liters.
Each segment of the display corresponds to ap-
prox. 0.4 liter.
fAdd engine oil if necessary.
Please observe the chapter “ENGINE OIL LE-
VEL” on Page 189.
Before adding oil, switch ignition off.
fNever add more engine oil than required 
to reach the maximum mark.Oil level measurement during refuelling
The oil level is automatically measured during re-
fuelling. 
Preconditions
1. Ignition is switched off.
2. If the engine is at operating temperature, at 
least 5 minutes must elapse between parking 
the vehicle and starting the engine.
3. Refuelling completed within 15 minutes.
When the ignition is switched on, the engine oil lev-
el is shown on the segment display.
Measurement will be stopped if the above require-
ments are not met.
fStart oil level measurement in the “OIL“ menu 
or
fStart oil level measurement by switching on 
the ignition.
Failure
A failure of the oil level display is indicated by a 
warning message in the on-board computer.The oil level measurement can also be 
initiated in the “OIL” menu:
Switching on selection field “D”
fPush operating lever forward.
Initiating measurement
fSelect “OIL” with the operating lever.
fPush operating lever forward.
Measurement is started. 
     
        
        Page 116 of 296

116
Controls, Instruments
Warnings on the instrument panel and the on-board computerIf a warning message appears, always refer to the corresponding chapters in the Owner’s Manual.
Warning messages are issued only if all measurement preconditions are met. Therefore, check all fluid levels regularly – 
in particular, always check the engine oil level after refuelling.
Instrument 
panelOn-board 
computerText display on on-board 
computerMeaning/measure
Seat belt Driver and passengers must fasten their seat 
belts.
Handbrake Handbrake is still on.
Ignition key 
not removed
Replace battery 
in ignition keyReplace the remote-control battery.
Ignition lock faulty, 
please go to workshopHave the fault remedied at an authorized 
Porsche dealer.
Ignition lock faulty, 
visit workshop nowHave the fault remedied at an authorized 
Porsche dealer.
Relieve  steering Relieve the steering  l o c k  b y  m o v i n g  t h e  s t e e r i n g  
wheel to the left or right.
Steering locked The steering wheel lock remains engaged. 
Have the fault remedied at an authorized 
Porsche dealer.
Lights on Dipped beam/side light on.
Parking light on Left/right parking light on. 
     
        
        Page 118 of 296

118
Controls, Instruments
Check engine oil level Start engine oil level measurement in the 
on-board computer.
The vehicle must be horizontal and the ignition 
must be switched on.
Engine oil pressure too low Stop immediately at a suitable place, measure 
oil level with the on-board computer and, if ne-
cessary, add engine oil.
Warning light
Temperature gau-
geEngine temperature too high Switch engine off and let it cool.
Check coolant level and, if necessary,
add coolant.
Temperature gau-
ge warning light 
flashesCheck coolant level Switch engine off and let it cool.
Check coolant level and, if necessary, add 
coolant.
Engine diagnostics – workshop Consult your authorized Porsche dealer.
Reduced engine power Consult your authorized Porsche dealer.
Temperature gau-
ge warning light 
flashesFailure of 
engine compartment blowerConsult your authorized Porsche dealer.
Warning Battery/generator Stop at a safe place and switch the engine off. 
Do not continue driving.
Have the fault remedied at an authorized 
Porsche dealer.
Oil pressure gauge faulty Have the fault remedied at an authorized 
Porsche dealer.
Oil level display faulty Have the fault remedied at an authorized 
Porsche dealer.
Oil temperature gauge faulty Have the fault remedied at an authorized 
Porsche dealer.
Instrument 
panelOn-board 
computerText display on on-board 
computerMeaning/measure 
     
        
        Page 120 of 296

120
Controls, Instruments
Airbag system fault Airbag is faulty.
Have the fault remedied at an authorized 
Porsche dealer.
Check passenger’s seat setting Weight sensing is impaired on the passenger's 
seat (Advanced Airbag).
When the backrest is in contact with the engine 
compartment wall, the backrest can warp.
Correct the seating position, set the backrest 
upright, do not support weight on the armrests, 
or lift on the handles.
Failure spoiler control Driving stability is impaired.
Adjust your driving style. Reduce speed.
Have the fault remedied at an authorized 
Porsche dealer.
Display of 
selector lever posi-
tion flashesSelector lever is not engaged Tiptronic S:
Selector lever can be between two positions.
Engage the selector lever correctly.
Move selector lever to P Tiptronic S: 
Move selector lever to position P before with-
drawing key from ignition lock.
Apply brake Tiptronic S:
Apply the brake when starting.
Depress clutch pedal Manual transmission:
Depress clutch pedal when starting.
Move selector lever 
to position P or NTiptronic S:
The vehicle can be started only in the selector 
lever position P or N.
Display of 
selector lever posi-
tion flashesTiptronic emergency run Have the fault remedied at an authorized 
Porsche dealer.
Instrument 
panelOn-board 
computerText display on on-board 
computerMeaning/measure