2006 NISSAN ALTIMA fuel

[x] Cancel search: fuel

Page 222 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual Windshield wiper and washer*Check that
the wipers and washer operate properly and that
the wipers do not streak.
Windshield defrosterCheck that the air
comes out of the defroster outlets properly and

Page 223 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual When performing any inspection or maintenance
work on your vehicle, always take care to prevent
serious accidental injury to yourself or damage to
the vehicle. The following are general precau-
tions

Page 229 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual 5. Remove the drain plugsBwith a wrench by
turning it counterclockwise and completely
drain the oil.
If the oil filter is to be changed, remove and
replace it at this time. See “Changing engine
oil

Page 233 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual When checking or replacement is required, we
recommend your NISSAN dealer for servicing.
WARNING
cUse only Genuine NISSAN Matic K ATF.
Do not mix with other fluids.
cUsing automatic transmission fluid

Page 234 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual BRAKE FLUID
Check the brake fluid level in the reservoir. If the
fluid level is below the MIN line or the brake
warning light comes on, add Genuine NISSAN
Super Heavy Duty Brake Fluid or equivalentDOT

Page 239 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Mainte-
nance Guide.” When replacing the filter, wipe the
insi

Page 269 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual 9 Technical and consumer information
Capacities and recommended fuel/lubricants.........9-2
Fuel recommendation...........................9-3
Engine oil and oil filter recommendation...........9-5
Rec

Page 270 of 304

NISSAN ALTIMA 2006 L31 / 3.G Owners Manual The following are approximate capacities. The actual refill capacities may be a little different. When refilling, follow the procedure
described in the “Maintenance and do-it-yourself” section to