2006 Mercury Mountaineer climate settings

Location of Spare Tire and Tools
The spare tire is located under the vehicle,
just forward of the rear bumper. The spare
tire winch drive nut is located at the rear
center of the cargo area, under a lid. The
jack, jack handle and lug nut wrench are
located behind the rear seat under the
carpeted lid in the cargo floor. The tools are
contained in a bag attached to the jack.
Fuses
If the vehicle’s electrical components are not
operating, a fuse may have blown. The fuse
panel is located below the instrument panel
on the driver’s side; remove the cover to
view the fuses. For more information
regarding changing fuses, refer to the
Roadside Emergencies chapter of your
Owner’s Guide.
Fuel Information
Use regular unleaded gasoline with an
(R+M)/2 octane rating of 87. Ford Motor
Company does not recommend using regular
unleaded gasoline with an octane rating
of 86 or lower in high altitude areas.
The advertised fuel capacity of the fuel tank
is equal to the rated refill capacity of the fuel
tank as listed in the Refill capacities section
of the Owner’s Guide.
Tire Pressure
Your vehicle’s tire pressure is properly set by
your authorized dealer according to the
recommended specifications found on the
vehicle’s tire label, located on the driver’s
door jamb. Check your tire pressure during
routine maintenance and seasonal changes.
If the Tire Pressure Monitoring System light
stays illuminated after starting, immediately
check the vehicle’s tire pressures. Note:
Improperlyinflated tires can affect vehicle
handling and can fail suddenly, resulting in a
possible loss of vehicle control.Rear Window Buffeting
When one or both of the rear windows are
open, the vehicle may demonstrate a wind
throb or buffeting noise; this noise is commonamong a wide range of vehicles and can be
eliminated by simply lowering a front
window approximately two to three inches.
Fuel Pump Shut-Off Switch
The fuel pump shut-off switch is a device
intended to stop the electric fuel pump
when your vehicle has been involved in a
substantial jolt. The switch is located in the
passenger’s footwell, by the kick panel.
After a collision, if the engine cranks but
does not start, the fuel pump shut-off
switch may have been activated. For more
information regarding the fuel pump
shut-
off switch, refer to the Roadside
Emergencieschapter of your Owner’s Guide.
Changing the Tires
The spare tire is not equipped with a Tire
Pressure Monitoring System (TPMS) sensor.
The TPMS warning light will illuminate when
the spare tire is in use. Replace the spare tire
with a road tire as soon as possible. If you
get a flat tire while driving, do not apply the
brake heavily; instead, gradually decrease
your speed, hold the steering wheel firmly
and slowly move to a safe place on the side
of the road.
Roadside Assistance
During your Mountaineer’s 3-year/36,000
mile limited warranty period, the assurance
and support of a 24-hour emergency
roadside assistance program is included.
Roadside assistance includes such services as
fuel delivery, tire changes, jump starts and
help when you are locked out of your
vehicle. Complete your roadside assistance
identification card and keep it handy (such
as in your wallet) for quick reference. This
identification card is located in your Mercury
Owner’s Information portfolio. To receive
roadside assistance in the United States, call
(800) 241-3673.
MERCURY MOUNTAINEERQUICK REFERENCE GUIDE 20
06
Ford Motor Company
Customer Relationship Center
P.O. Box 6248
Dearborn, MI 48121
1-800-392-3673 (FORD)
(TDD for the hearing impaired: 1-800-232-5952)
This Quick Reference Guide is not intended to
replace your Owner’s Guide which contains
more detailed information concerning the
features of your vehicle, as well as important
safety warnings designed to help reduce the risk
of injury to you and your occupants. Please read
your entire Owner’s Guide carefully as you begin
learning about your new vehicle and refer to
the appropriate sections when questions arise.
All information contained in this Quick ReferenceGuide was accurate at the time of duplication.
We reserve the right to change features,
operation and/or functionality of any vehicle
specification at any time. Your Mercury
dealer is the best source for the most
current information.
For detailed operating and safety information,
please consult your Owner’s Guide.
May 2005
First Printing
Quick Reference Guide Mercury Mountaineer
Litho in U.S.A.
*F6E6J19G217AA*
F6E6-J19G217-AA
CENTERCONSOLE
Dual Automatic Temperature Control (DATC) System(if equipped)
If your Mountaineer came equipped with another climate system, refer to your Owner’s Guide
for detailed information.
01 Temperature controls
To control the temperature on the driver’s side in single zone mode, select any temperature
between 60º F and 90º F by pressing the driver temperature control; the climate system’s
display indicates the selected temperature. The passenger can also select any temperature
between 60º F and 90º F by pressing the passenger temperature control.
02 Fan Speed
Press to manually increase and decrease fan speed.
03 DUAL(Single / dual electric temperature control)
Allows the driver to have full control of the cabin temperature settings (single zone) or allows
the passenger to have control of their individual temperature settings (dual zone control).
Press to turn on dual zone mode; press again to return to single zone.
04 AUTO
Press to select the desired temperature shown in the display window. The system will
automaticallydetermine the fan speed, the direction of the airflow, and outside or recirculated
air to heat or cool the vehicle to the selected temperature.
05 OFF
Outside air is shut out and the fan will not operate. Note:If your vehicle is equipped with the
auxiliary climate control system, the auxiliary fan can still operate with the front system off.
06 Manual Override Controls
Allows you to manually determine where airflow is directed. To return to fully automatic
control, press AUTO.
07 Windshield Defroster
Distributes outside air through the windshield defroster vents.
08 Rear Window Defroster
The rear defroster control is located on the instrument panel. Press the rear defroster control
to clear the rear window of thin ice and fog. The ignition must be in the 3 (ON) position to
operate the rear window defroster. The defroster turns off automatically after 10 minutes or
when the ignition is turned to the 1 (OFF/LOCK) or 2 (ACC) position. To manually turn off the
defroster before 10 minutes have passed, push the control again.AM / FM / CD / MP3 Sound System
(if equipped) If your Mountaineer came
equipped with another audio system,
refer to your Owner’s Guide for
detailed information.
ACD Eject:Press to eject a CD. Press and
hold to auto eject all CDs present in the sys-
tem. If there is no CD present, the display
will read NO CD.
BLOAD:Press to load a CD. Press load and
a memory preset to load to a specific slot.
Press and hold to autoload up to six CDs.
CTune / Disc selector:Press to manually
go up or down the radio frequency or to
select a desired disc. Also use in menu
mode to select various settings.
D ON / OFF / Volume:Press to turn
ON/OFF. Turn to increase/decrease volume.
If the volume is set above a certain level and
the ignition is turned off, the volume will
come back on at a “nominal” listening level
when the ignition switch is turned back on.
ECD:Press to enter CD mode. If a CD is
already loaded into the system, CD play will
begin where it ended last. If no CD is
loaded, NO DISC will be displayed.
F AM / FM:Press to select AM/FM
frequency band.
GMUTE / Phone:Press to mute the
playing media. Press again to return to
the playing media.
HAUX:Press to toggle between FES/DVD,
AUX and Satellite Radio modes (if equipped).If no auxiliary sources are available, NO AUX
AUDIO will be displayed.I MENU: Press to toggle through the
following modes: Autoset, Bass, Treble,
Balance, Fade, Occupancy mode, Speed
sensitive volume, Setting the clock, RBDS,
Track/Folder Mode & Compression. For more
information on these menu items, refer to
your Owner’s Guide.
JSEEK:Press to access the previous strong
station or track.
K TEXT/SCAN:Press and hold for a brief
sampling of radio stations or CD tracks.
Press again to stop. In CD/MP3 mode, press
TEXT to display track title, artist name, disc
title and file name (if available).
LSEEK:Press to access the next strong
station or track.
M REW (Rewind):Press to manually
reverse in a CD track.
N FF (Fast forward):Press to manually
advance in a CD track.
O FOLDER:In folder mode, press to access
the next folder on MP3 discs, if available.
PSHUFFLE:Press to play the tracks on the
current disc in random order.
QPLAY / PAUSE:This control is operational
in CD and DVD mode (if equipped). When a
CD or DVD is playing in the FES system,
press this control to play or pause the
current CD/DVD. The CD/DVD status will
display in the radio display.
RMemory Presets:To set a station, select
frequency band AM/FM, tune to a station
and press and hold a preset button until
sound returns.
Essential InformationClimate Co n t r o lAudio System
0405060708
0102
A
B
FI
L
MNO
R
PQ
G
J
C
D
E
H
K
01
03