2006 Mercury Milan turn signal

3. Turn the ignition to the 1 (LOCK) position and remove the firstcoded
keyfrom the ignition.
4. Within ten seconds of turning the ignition to the 1 (LOCK) position,
insert the second previouslycoded keyinto the ignition.
5. Turn the ignition from the 1 (LOCK) position to the 3 (RUN) position.
Keep the ignition in the 3 (RUN) position for at least three seconds, but
no more than 10 seconds.
6. Turn the ignition to the 1 (LOCK) position and remove the second
previously programmedcoded keyfrom the ignition.
7. Within twenty seconds of turning the ignition to the 1 (LOCK)
position and removing the previously programmedcoded key,insert the
new unprogrammed key (new key/valet key) into the ignition.
8. Turn the ignition from the 1 (LOCK) position to the 3 (RUN) position.
Keep the ignition in the 3 (RUN) position for at least six seconds.
9. Remove the newly programmedcoded keyfrom the ignition.
If the key has been successfully programmed it will start the vehicle’s
engine and will operate the remote entry system (if the new key is an
Integrated Keyhead Transmitter). The theft indicator light will illuminate
for three seconds and then go out to indicate successful programming.
If the key was not successfully programmed, it will not start your
vehicle’s engine and/or will not operate the remote entry features. The
theft indicator light may flash on and off. Wait 20 seconds and you may
repeat Steps 1 through 8. If failure repeats, bring your vehicle to your
authorized dealer to have the new key(s) programmed.
To program additional new unprogrammed key(s), wait twenty seconds
and then repeat this procedure from Step 1.
PERIMETER ALARM SYSTEM (IF EQUIPPED)
The perimeter anti-theft system will help prevent your vehicle from
unauthorized entry.
If there is any potential perimeter anti-theft problem with your vehicle,
ensureALL Integrated Keyhead Transmittersare brought to the
authorized dealer to aid in troubleshooting.
Arming the system
When armed, this system will respond if unauthorized entry is
attempted. When unauthorized entry occurs, the system will flash the
turn signal lamps and will sound the horn.
2006 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Locks and Security
86

The system is ready to arm whenever the key is in the 1(LOCK)
position, or is removed from the ignition. Either of the following actions
will prearm the alarm system:
•Press the
control on the remote entry transmitter portion of your
Integrated Keyhead Transmitter.
When you press the lock control twice within three seconds on the
remote entry transmitter portion of your IKT, the horn will chirp once to
let you know that all doors, the hood and the trunk are closed. If any of
these are not closed, the horn will chirp twice to warn you that a door,
the hood or the trunk is still open.
•Press the driver or passenger
interior door lock control while
the door is open, then close the
door.
There is a 20 second countdown when any of the above actions occur
before the vehicle becomes armed.
Each door, the hood or the trunk is armed individually, and if any are
open, they must be closed for the system to enter the 20 second
countdown.
The turn signal lamps will flash once when all doors, the hood and the
trunk are closed indicating the vehicle is locked and entering the 20
second countdown.
Disarming the system
You can disarm the system by any of the following actions:
•Unlock the doors by using the remote entry transmitter portion of
your Integrated Keyhead Transmitter.
•Unlock the driver’s door with a key. Turn the key full rearward
(toward the rear of the vehicle) to ensure the alarm disarms.
•Turn ignition to the 3 (ON) position with a valid SecuriLockkey.
•Press the panic control on the remote entry transmitter portion of
your IKT. This will only shut off the horn and turn lamps when the
alarm is sounding. The alarm system will still be armed.
Pressing the power door UNLOCK control within the 20 second
prearmed mode will return the vehicle to a disarmed state.
2006 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Locks and Security
87

HAZARD FLASHER CONTROL
The hazard flasher is located on the
instrument panel by the radio. The
hazard flashers will operate when
the ignition is in any position or if
the key is not in the ignition.
Push in the flasher control and all
front and rear direction signals will flash. Press the flasher control again
to turn them off. Use it when your vehicle is disabled and is creating a
safety hazard for other motorists.
Note:With extended use, the flasher may run down your battery.
FUEL PUMP SHUT-OFF SWITCH
This device stops the electric fuel pump from sending fuel to the engine
when your vehicle has had a substantial jolt.
After an accident, if the engine cranks but does not start, this switch
may have been activated.
The fuel pump shut-off switch is
located in the front passenger
footwell area in the right upper
corner.
To reset the switch:
1. Turn the ignition to 1 (LOCK).
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.
4. Turn the ignition to 3 (RUN).
5. Wait a few seconds and return
the key to 1 (LOCK).
6. Make another check for leaks.
2006 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Roadside Emergencies
172

L
Lamps
autolamp system .......................34
bulb replacement
specifications chart ..................39
daytime running light ...............35
fog lamps ...................................35
headlamps .................................34
headlamps, flash to pass ..........36
instrument panel, dimming .....36
interior lamps ...........................38
replacing bulbs .........................39
Lane change indicator
(see Turn signal) ........................38
Lights, warning and indicator ....10
anti-lock brakes (ABS) ..........160
Load limits .................................149
Locks
autolock .....................................81
childproof ..................................73
doors ..........................................71
Lubricant specifications ...243–244
Lug nuts ....................................184
Lumbar support, seats ...............90
M
Manual transaxle
fluid capacities ........................241
fluid, checking and adding ....238
lubricant specifications ..........244
Manual transmission .................168
reverse .....................................168
Message center ...........................61
english/metric button ...............66
system check button ................65
warning messages .....................66
Mirrors .........................................54automatic dimming rearview
mirror ........................................54
heated ........................................55
programmable memory ............77
side view mirrors (power) .......54
Moon roof ....................................59
Motorcraft parts ........203, 223, 240
O
Octane rating ............................226
Oil (see Engine oil) ..................210
P
Parking brake ............................161
Parts (see Motorcraft parts) ....240
Passenger Occupant
Classification Sensor ...................96
Power distribution box
(see Fuses) ...............................176
Power door locks ........................71
Power mirrors .............................54
Power point .................................52
Power steering ..................162–163
fluid, checking and adding ....233
fluid, refill capacity ................241
fluid, specifications .........243–244
Power Windows ...........................53
R
Radio ......................................16, 20
Relays ........................................173
Remote entry system ...........74, 76
illuminated entry ................79–80
locking/unlocking doors ...........76
opening the trunk .....................77
2006 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Index
254

Transaxle
fluid, checking and adding
(automatic) .............................234
fluid, checking and adding
(manual) .................................238
Transmission .............................163
brake-shift interlock (BSI) ....163
fluid, refill capacities ..............241
lubricant specifications ..243–244
manual operation ....................168
Trunk ...........................................73
remote release ....................68, 77
Turn signal ..................................38
V
Vehicle dimensions ...................245Vehicle Identification Number
(VIN) ..........................................247
Vehicle loading ..........................149
Ventilating your vehicle ...........159
W
Warning lights (see Lights) .......10
Washer fluid ..............................209
Water, Driving through .............169
Windows
power .........................................53
Windshield washer fluid and
wipers ..........................................49
checking and adding fluid .....209
replacing wiper blades ...........209
Wrecker towing .........................190
2006 Milan(mln)
Owners Guide (post-2002-fmt)
USA(fus)
Index
256