Page 275 of 561

274 Controls in detailDriving systemsParktronic* (Parking assist)
The Parktronic system is an electronic aid
designed to assist the driver during
parking maneuvers. It visually and audibly
indicates the relative distance between the
vehicle and an obstacle.
The Parktronic system is automatically
activated when you switch on the ignition,
release the parking brake, and set the
automatic transmission to positionD,R,
orN.
The Parktronic system deactivates at
vehicle speeds exceeding approximately
11 mph (18 km/h). At lower vehicle
speeds, the Parktronic system turns on
again.The Parktronic system also deactivates
when you set the automatic transmission
to positionP or depress the parking brake
pedal.
The Parktronic system monitors the sur-
roundings of your vehicle with six sensors
in the front bumper and four sensors in the
rear bumper.
1Sensors in the front bumperWarning!
G
Parktronic is a supplemental system. It is
not intended to, nor does it replace, the
need for extreme care. The responsibility
during parking and other critical maneuvers
always rests with the driver.
Special attention must be paid to objects
with smooth surfaces or low silhouettes
(e.g. trailer couplings, painted posts, or road
curbs). Such objects may not be detected by
the system and can damage the vehicle.
The operational function of the Parktronic
system can be affected by dirty sensors,
especially at times of snow and ice. See
“Cleaning the Parktronic system sensors”
(page 399).
Interference caused by other ultrasonic
signals (e.g. working jackhammers, car
wash, or the air brakes of trucks) can cause
the system to send erratic indications, and
should be taken into consideration.
Warning!
G
Make sure no persons or animals are in the
area in which you are maneuvering. Other-
wise you run the risk of causing injury.
Page 276 of 561
275 Controls in detail
Driving systems
Range of the sensors
To function properly, the sensors must be
free of dirt, ice, snow and slush. Clean the
sensors regularly, being careful not to
scratch or damaging the sensors, see
“Cleaning the Parktronic* system sensors”
(page 399).
Front sensors
Rear sensors
Center
approx. 40 in (100 cm)
Corners
approx. 24 in (60 cm)
Center
approx. 48 in (120 cm)
Corners
approx. 32 in (80 cm)
!During parking maneuvers, pay special
attention to objects located above or
below the height of the sensors
(e.g. planters or trailer hitches).
The Parktronic system will not detect
such objects at close range and dam-
age to your vehicle or the object may
result.
Ultrasonic signals from outside
sources (e.g. working jackhammers,
car wash or the air brakes of trucks)
may impair the operation of the
Parktronic system.
Page 549 of 561

548 Index
Panorama sliding/pop-up roof 260
Power tilt/sliding sunroof* 462
Tailgate 122
Tilt/sliding sunroof* 255
Tilt/Sliding sunroof* in an
emergency 462
Windows 248
Opening the tailgate from the inside 122,
123, 124
Opening the tailgate from the inside
electrically* 123
Opening the tailgate from the
outside 122
Operating
CD player 171
Radio 170
Radio transmitters 339
Telephone* 194
Vehicle outside the USA or
Canada 13
Operating safety 17
Operator’s Manual 10
Ornamental moldings 399
Outside temperature indicator 159
Overhead control panel 31
Overspeed range 532P
Paintwork 397
Panic alarm 95
Panic button on remote control 95
Panorama roof with power tilt/sliding
panel* 259
Panorama roof with tilt/sliding panel
Cleaning 401
Parcel nets 298
Parking 334
Parking and locking 64
Parking brake 56, 65
Engaging 65
Message in display 431
Releasing 56
Parking lamps
Replacing bulbs 466
Parking position
Exterior rear view mirrors 146
Parktronic* 274, 532
Cleaning system sensor 399
Range of the sensors 275
Sensor cover 399
Warning indicators 276Partition net* 290
Engaging 291
Removing 292, 293
Tightening 291
Parts service 508
Passenger compartment 338
Fuse box 505
Interior lighting 154
Passenger safety see Occupant safety
Pedals 331
Phone book*
Loading 195
Quick search 195
Phone number*
Dialing 195
Redialing 196
Plastic and rubber parts
Cleaning 402
Plastic parts, cleaning 401
Poly-V-belt drive 532
Layout 512
Positions (Memory function*)
Recalling from memory 145
Storing in memory 145