2006 MERCEDES-BENZ ML350 door mirror

136 Controls in detailMemory function*The memory button and stored position
buttons are located on the entry side of
each front seat base.
MMemory button
1, 2, 3Stored positions
Switch on the ignition (
page 34).
or

Open the respective door.
Storing positions in memory
Adjust the seats, steering wheel and
exterior rear view mirrors to the de-
sired position (
page 38).

Press memory buttonM.

Release memory buttonM and press
stored position1,2 or3 within
three seconds.
All the settings are stored at the select-
ed position.
Recalling positions from memory
Press and hold memory position
button1,2 or3 until the seat, steering
wheel and exterior rear view mirrors
have fully moved to the stored posi-
tions.!Do not operate the power seats using
the memory button if the seat backrest
is in an excessively reclined position.
Doing so could cause damage to front
or rear seats.
First move seat backrest to an upright
position.iReleasing the button immediately
stops movement to the stored posi-
tions.

173 Controls in detail
Control system
Limiting opening height of tailgate*
Use this function to activate or deactivate
the limiting opening height of tailgate.
Move the selection marker to the Vehicle
submenu using theæ
orç button.

Press buttonj ork repeatedly
until you see this message in the dis-
play:
Opening limiter Tailgate
.
The selection marker is on the current
setting.

Press buttonæ orç to switch Opening limiter Tailgate On
or
Off
.Convenience submenu
Access the
Convenience
submenu via the
Settings...
menu. Use the
Convenience

submenu to change the settings for a num-
ber of convenience features. The following
functions are available:
Activating easy-entry/exit feature*
Use this function to activate and deacti-
vate the easy-entry/exit feature
(
page 128).Function
Page
Activating easy-entry/exit
feature*
173
Set parking position* for exteri-
or rear view mirror
174
Setting fold-in function* for
exterior rear view mirrors
175
Warning!
G
You must make sure no one can become
trapped or injured by the moving steering
wheel and driver’s seat when the
easy-entry/exit feature is activated.
To stop seat/steering wheel movement, do
one of the following:

Press seat adjustment switch
(page 39).


Move steering column stalk*
(page 42).


Press one of the memory position but-
tons or the memory button
M*
(
page 136).
Do not leave children unattended in the
vehicle, or with access to an unlocked
vehicle. Children could open the driver’s
door and unintentionally activate the
easy-entry/exit feature, which could re-
sult in an accident and/or serious per-
sonal injury.

196 Controls in detailGood visibilityActivating exterior rear view mirror
parking position*
Follow these steps to activate the mirror
parking position so that the
passenger-side exterior rear view mirror
will be turned downward to the stored
position.
The buttons are located on the door
control panel.
1Driver’s side exterior rear view mirror
button
2Adjustment button
3Passenger-side exterior rear view mir-
ror button

Make sure you have stored a parking
position for the passenger-side exterior
rear view mirror (
page 137).

Make sure the
Mirror adjustment
parking assist function in the
Conve-
nience
submenu of the control system
is switched to
On (page 174).

Switch on the ignition (
page 34).

Place the gear selector lever in reverse
gearR.
The indicator lamp on the driver’s side
or passenger-side exterior rear view
mirror button comes on, dependent
from the last setting.When the driver’s side exterior rear view
mirror button comes on:

Press button3 for the passenger-side
exterior rear view mirror.
The passenger-side exterior rear view mir-
ror will be turned downward to the stored
position.
When the passenger-side exterior rear
view mirror button comes on:
The passenger-side exterior rear view mir-
ror will be turned downward to the stored
position.iThe exterior rear view mirror parking
position is key-dependent. For more in-
formation on storing exterior rear view
mirror parking position, see “Storing
exterior rear view mirror parking posi-
tion” (
page 137).

197 Controls in detail
Good visibility
The exterior rear view mirror returns to its
previously stored driving position:

when you switch off the ignition


ten seconds after you put the gear
selector lever out of positionR
Approximately 15 seconds later the in-
dicator lamp on the exterior rear view
mirror button goes out.


immediately once your vehicle exceeds
a speed of approx. 6 mph (10 km / h)


immediately when you press button1
for driver’s side mirror (
page 196)Power folding exterior rear view
mirrors*
Folding the exterior mirrors in and out
automatically
When the corresponding function in the
control system is activated (
page 175):


The exterior rear view mirrors automat-
ically fold in as soon as the vehicle is
locked from the outside.


The exterior rear view mirrors automat-
ically fold out as soon as the vehicle is
unlocked and the driver’s or front pas-
senger door are subsequently opened.Folding the exterior mirrors in and out
manually
The button is located on the door control
panel.
1Button for folding exterior mirrors in
and out

Switch on the ignition (
page 34).
iWith gear selector lever in reverse
gearR you can deactivate the exterior
rear view mirror parking position by
pressing button1, or activate by
pressing button3. The indicator lamp
of the selected button is on.
!Before you drive the vehicle through an
automatic car wash, fold the exterior
mirrors in, otherwise they may get
damaged.

292 Controls in detailUseful featuresStep 3:
Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the left side of the interior
rear view mirror, keeping the indicator
lamp4 in view.
Step 4:

Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (1, 2
or3). Do not release the buttons until
completing step 5.
The indicator lamp4 on the
integrated remote control will flash,
first slowly and then rapidly.Step 5:

When the indicator lamp4 flashes
rapidly, release both buttons.
Step 6:

Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp4.
If the indicator lamp4 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.Step 7:

To program the remaining two buttons,
repeat the steps above starting with
step 3.
iThe indicator lamp4 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.
iIf the indicator lamp4 flashes rapidly
for about two seconds and then turns
to a constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.


376 OperationVehicle careEngine cleaning
Prior to cleaning the engine compartment
make sure to protect electrical compo-
nents and connectors from the intrusion of
water and cleaning agents.
Corrosion protection, such as
MB Anticorrosion Wax, should be applied
to the engine compartment after every en-
gine cleaning. Before applying, all control
linkage bushings and joints should be lu-
bricated. The poly-V-belt and all pulleys
should be protected from any wax.
Vehicle washing
Do not use hot water or wash your vehicle
in direct sunlight. Only use a mild car wash
detergent, such as Mercedes-Benz
approved Car Shampoo.
Thoroughly spray the vehicle with a dif-
fused jet of water. Direct only a very weak
spray towards the ventilation intake. Use
plenty of water and rinse the sponge and
chamois frequently.Rinse with clear water and thoroughly dry
with a chamois. Do not allow cleaning
agents to dry on the finish.In the winter, thoroughly remove all traces
of road salt as soon as possible.
When washing the underbody, do not for-
get to clean the inner sides of the wheels.
!Due to the width of the vehicle, fold in
exterior rear view mirrors prior to run-
ning the vehicle through an automatic
car wash to prevent damage to the mir-
rors.iAfter running the vehicle through an au-
tomatic car wash, wipe any wax off of
the windshield (
page 378) and the
wiper blade inserts (page 378). This
will prevent smears and reduce wiping
noise which can be caused by residual
wax on the windshield.
iVehicles with KEYLESS-GO*:
If a door handle is hit by a strong jet of
water, and a SmartKey with
KEYLESS-GO* is in close proximity, i.e.
within approximately 3 ft (approxi-
mately 1 m), the vehicle could be inad-
vertently locked or unlocked.

515 Index
Emergency operations
Closing tilt/sliding sunroof* 439
Locking the vehicle 436
Opening tilt/sliding sunroof* 439
Remote door unlock 288
Unlocking the vehicle 435
Emergency tensioning device see ETD
Emission control 321
Ending
A call (telephone*) 180
Engine
Message in the display 410
Starting 49
Starting with KEYLESS-GO* 50
Technical data 486
Turning off 62
Engine cleaning 376
Engine compartment
Hood 326
Main fuse box 478
Engine malfunction
indicator lamp 385, 410
Engine malfunction indicator
lamp (Canada only) 25
Engine malfunction indicator
lamp (USA only) 25Engine number 502
Engine oil 327, 495
Adding 331
Additives 495
Checking level 327
Checking with the
control system (ML 500 only) 328
Checking with the
oil dipstick (ML 350 only) 330
Consumption 327
Display messages 414–415
Messages in display 329, 414–415
Viscosity 502
ESP
®
25, 95, 502
Off-road-ESP
®
98
Switching off 97
Switching on 98
Warning lamp 387
ETD 502
Safety guidelines 70
ETD (Emergency tensioning device) 76
Exterior mirrors
Folding 197
Exterior rear view mirrors
Adjusting 44
Parking position* for 174F
Fastening the seat belts 46
First aid kit 430
Flat tire 456
Lowering the vehicle 460
Preparing the vehicle 457
Spare wheel 433
Flexible Service System PLUS
(FSS PLUS) 502
Floormats* 279
Fluid level
Automatic transmission 332
Fog lamp, rear
Switching on 142
Fog lamps
Replacing bulbs 443
Fog lamps, front
Messages in display 418
Replacing bulbs 445
Switching on 142
Folding
Exterior mirrors 197
Folding the backrest forward 261
4-ETS 98
Off-road - 4-ETS 99

521 Index
MAXCOOL maximum cooling 223
Maximum inflation pressure 366
Maximum load rating 366
Maximum loaded vehicle weight 366
Maximum tire inflation pressure 504
MB Tex upholstery
Cleaning 380
Mechanical key 435
Memory function* 135, 504
Recalling positions from
memory 136
Menus 153
AUDIO 157
In control system 153, 154
Message memory 159
Settings menu 161
Standard display 156
Submenus 152
TEL* 178
Trip computer 177
Message
Displaying 160
Message memory 159
Calling up 159Miles/kilometers in speedometer
Setting 164
Minispare wheel
Spare wheel 433
Mirrors
Activating exterior mirror
parking position* 196
Adjusting 43
Auto-dimming rear view mirror* 195
Exterior rear view mirror 44
Exterior rear view mirror
parking positions* 174
Modular COMAND System 504
Modular COMAND System see
separate operating instructions
MON 324
MON (Motor Octane Number) 504
Mounting
New wheel 459
Mph or km/h in speedometer 164
Multicontour seat* 132
Multifunction display 504
Selecting language 164
Standard display 154Multifunction display messages
ABS 397
Batteries 398, 407
Brake fluid 409
Brake pads 408
Coolant 412
Coolant level 410
Cruise control 398
Doors 413
EBP (Electronic Brake
Proportioning) 408
Engine oil 414–415
Fuel cap 416
Fuel reserve tank 416
Hood 416
Lamps 420
Lamps, exterior 418
Oil 414–415
Parking brake 409
SmartKey 417
SmartKey with KEYLESS-GO* 417
Tailgate 427
Tele Aid* 425, 426
Washer fluid 427
Multifunction steering wheel 26, 504