2006 MERCEDES-BENZ G55AMG spare tire

279 Operation
Winter driving
Block heater (Canada only)
The engine is equipped with a block
heater.
The electrical cable may be installed at an
authorized Mercedes-Benz Light Truck
Center.
Snow chains
Snow chains should only be driven on
snow-covered roads at speeds not to
exceed 30 mph (50 km/h). Remove chains
as soon as possible when driving on roads
without snow.Please observe the following guidelines
when using snow chains:

Use of snow chains is not permissible
with all wheel/tire combinations.

Snow chains should only be used on
the rear wheels. Follow the manufac-
turer’s mounting instructions.

Only use snow chains that are
approved by Mercedes-Benz. Your
authorized Mercedes-Benz Light Truck
Center will be glad to advise you on this
subject.

Use of snow chains may be prohibited
depending on location. Always check
local and state laws before installing
snow chains.
Warning!G
If you use your spare tire when winter tires
are fitted on the other wheels, be aware that
the difference in tire characteristics may
very well impair turning stability and that
overall driving stability may be reduced.
Adapt your driving style accordingly.
Have the spare tire replaced with a winter
tire at the nearest authorized
Mercedes-Benz Light Truck Center.
i
When driving with snow chains, you
may wish to deactivate the ESP
(
page 84) before setting the vehicle
in motion. This will improve the
vehicle’s traction.

325 Practical hints
Where will I find...?
Spare wheel
The spare wheel is located under a cover
on the outside of the vehicle’s tailgate.
For information on rim and tire specifica-
tions, see (
page 371) and (page 373).
Removing cover
1Cover ring
2Key
3Tab
Open lock for cover ring1 with
key2 for the spare wheel cover.
Fold tab3 downwards.
4Cover plate
Pull cover ring1 slightly outwards in
direction of arrows and remove.
Pull cover plate4 upward towards
you.5Catch
6Recess
i
When replacing cover plate4, make
sure catch5 engages in recess6.
Make sure the lock faces downwards
when mounting cover ring1.
For safety reasons, check regularly that
the spare wheel is securely fastened.

326 Practical hints
Where will I find...?
Removing the spare wheel
1Mounting screws
Unscrew mounting screws1.
Remove the spare wheel.For more information on changing the
wheel, see “Flat tire” (
page 348).
Warning!G
Make sure no one is injured when removing
the spare wheel.
Grip wheel from the sides.
Keep hands from beneath the wheel.
i
After changing the wheel, secure the
replaced wheel on the spare wheel car-
rier. Make sure the wheel cannot come
loose.
Cover the wheel with the cover plate.
Repair or replace damaged tire as soon
as possible and return spare tire as
original spare.

348 Practical hints
Flat tire
Preparing the vehicle
Park the vehicle as far as possible from
moving traffic on a hard surface.
Turn on the hazard warning flashers.
Turn the steering wheel so that the
front wheels are in a straight ahead
position.
Set the parking brake (page 57).
Move the gear selector lever toP.
Turn off the engine (page 58).
Have any passenger exit the vehicle at
a safe distance from the roadway.
Remove the vehicle tool kit
(
page 323) and the jack
(
page 324).
Remove the spare wheel from the
spare wheel mounting bracket
(
page 325).Information on spare wheel
When you replace the vehicle’s tires, you
can use the spare wheel as a regular wheel
if:

it is not more than six years old

rim and tire are the same model as the
regular wheels
Warning!G
For your safety, remove spare wheel from
the spare wheel mounting bracket before
undertaking any further steps.
Warning!G
If the spare tire is more than six years old or
is not the same model as the regular tires,
have the spare tire replaced with a new tire
at the nearest Mercedes-Benz Light Truck
Center.
Never operate the vehicle with more than
one spare tire.
Warning!G
G55AMG:
Vehicles with different tire dimensions on
the front and rear axle: rim and tire size of
spare wheel and normal wheel differ.
Handling will be adversely affected when the
spare wheel is used.
Do not exceed the maximum speed of
50 mph (80 km/h).

349 Practical hints
Flat tire
Mounting the spare wheel
Prepare the vehicle (page 348).
Lifting the vehicle
Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
(not included) or other sizable objects.
When changing wheel on a level surface:
Place one chock in front of and one be-
hind the wheel that is diagonally oppo-
site to the wheel being changed.
Always try lifting the vehicle using the jack
on a level surface. However, should cir-
cumstances require you to do so on a hill,
place the wheel chocks as follows:
Place chocks on the downhill side
blocking both wheels of the axle not
being worked on.
Wheel wrench
On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
Warning!G
The jack is designed exclusively for jacking
up the vehicle under the axle housing. To
help avoid personal injury, use the jack only
to lift the vehicle during a wheel change.
Never get beneath the vehicle while it is sup-
ported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always firmly set parking brake and block
wheels before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Make sure the jack is posi-
tioned correctly under the axle housing. Al-
ways lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.
If the vehicle is not raised as described, it
could slip off the jack as a result of vibra-
tions (e.g. opening or closing a door or the
tailgate).

352 Practical hints
Flat tire
Lowering the vehicle
Using the pump handle, open the low-
ering screw on the jack approximately
one turn (
page 350).
The vehicle is resting fully on its own
weight.
Remove the jack.
After use, disassemble pump handle
(
page 350) and store jack in the des-
ignated storage compartment
(
page 324).
1-5 Wheel bolts
Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to 5), until all bolts are tight.
Observe a tightening torque of 97 lb-ft
(130 Nm).Press the jack piston in again and close
the lowering screw. Store the jack
(
page 324) and the other vehicle
tools (
page 323).
After changing the wheel, secure the
damaged wheel on the spare wheel
mounting bracket (
page 326). Make
sure the wheel cannot come loose.
Check the tire inflation pressure and
correct it if necessary.
A table with the tire pressure values for
your vehicle is located on the fuel filler
flap.
Warning!G
Have the tightening torque checked after
changing a wheel as soon as possible. The
wheels could come loose if they are not
tightened to a torque of 97 lb-ft (130 Nm).

373 Technical data
Rims and tires
Spare wheels
G500G55AMG
Rims (light alloy)71/2 J x18 H271/2 J x18 H2
Wheel offset1.69 in (43 mm)1.69 in (43 mm)
All season tires (radial-ply tires)265/60 R18 110V M+S265/60 R18 110V M+S

396 Index
Engine oil level see Oil level
Enlarged cargo compartment 188
ESP 25, 80, 84, 384
Messages in display 302
Switching off 86
Switching on 87
Synchronizing 302
Warning lamp 295
ETD 62, 71, 384
Safety guidelines 66
Exterior lamp switch 110
Exterior lamps
Delayed shut-off 140
Exterior rear view mirrors
Adjusting 41
Parking position for 144
F
Fahrenheit
Setting temperature units 136
Fastening the seat belts 43
Fine adjustment
Cruise control 183
First aid kit 323Flat tire 348
Lowering the vehicle 352
Mounting the spare wheel 349
Spare wheel 325
Flexible Service System (FSS, Canada
vehicles) 384
Fog lamp, rear 114, 336
Fog lamps, front 113
Messages in display 315
4-ETS 80, 83
Front airbags 67
Front axle differential lock
Switching on 162
Front fog lamps
Replacing bulbs 336, 340
Front lamps
Messages in display 314, 316
Replacing bulbs 336, 338
Switching on 110
Front seat head restraints
Installing 102
Removing 101
Front towing eye 361
Front turn signal lamp
Replacing bulbs 342FSS (Flexible Service System, Canada
vehicles) 384
Fuel 240
Additives 379
Fuel reserve warning lamp 296
Gasoline additives 379
Premium unleaded gasoline 240,
376, 378
Refueling 239
Requirements 379
Reserve warning 25
Technical data 376
Fuel additives 379
Fuel consumption statistics
After start 145
Since last reset 145
Fuel filler flap 239
Locking 239
Opening 328
Unlocking 239
Fuel requirements 379
Fuel reserve tank
Message in display 313
Fuel tank
Capacity 376
Filler flap 239