2006 MERCEDES-BENZ G55AMG hood open

243 Operation
Engine compartment
Closing
Lower hood and let it drop into lock
from a height of approximately 0.7 ft
(20 cm).
The hood will lock audibly.
Check to make sure the hood is fully
closed.
If you can raise the hood at a point
above the turn signals to the left and
right of the hood, then it is not properly
closed. Open it again and let it drop
with somewhat greater force.
Engine oil
The amount of oil your engine needs will
depend on a number of factors, including
driving style. Higher oil consumption can
occur when

the vehicle is new

the vehicle is driven frequently at
higher engine speeds
Engine oil consumption checks should only
be made after the vehicle break-in period.
Warning!G
The engine is equipped with a transistorized
ignition system. Because of the high voltage,
it is dangerous to touch any components (ig-
nition coils, spark plug sockets, diagnostic
socket) of the ignition system

with the engine running

while starting the engine

if ignition is “on” and the engine is
turned manually
Warning!G
Be careful that you do not close the hood on
anyone.
!
Do not push the hood closed manually,
as this could damage it.
i
Do not use any special lubricant addi-
tives, as these may damage the drive
assemblies. Using special additives not
approved by Mercedes-Benz may
cause damage not covered by the
Mercedes-Benz Limited Warranty.
More information on this subject is
available at any Mercedes-Benz Light
Truck Center.

246 Operation
Engine compartment
Checking engine oil level with the oil
dipstick
When checking the oil level the vehicle
must

be parked on level ground

be at normal operating temperature

have been stationary for at least
5 minutes with the engine turned offTo check the engine oil level with the oil
dipstick, do the following:
Open the hood (page 242).
Pull out oil dipstick1 (page 247).
Wipe oil dipstick1 clean.
Fully insert oil dipstick1 into the
dipstick guide tube.
Pull out oil dipstick1 again after
approximately three seconds to obtain
accurate reading.
Oil dipstick
The oil level is correct when it is between
the lower (min) and upper (max) mark of
the oil dipstick.
If necessary, add engine oil.
For adding engine oil, see (
page 247).
For more information on engine oil, see the
“Technical data” section (
page 376) and
(
page 377).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 311).
i
The engine oil level can be checked by
either the oil dipstick or via the multi-
function display in the instrument
cluster (
page 244). The amount of
engine oil needed is shown more
precisely in the multifunction display.
i
The filling quantity between the upper
and lower marks on the oil dipstick is
approximately 2.1 US qt. (2.0 l).

248 Operation
Engine compartment
Screw oil filler cap2 back on filler
neck.
For more information on engine oil, see the
“Technical data” section (
page 376) and
(
page 377).
Transmission fluid level
The transmission fluid level does not need
to be checked. The transmission has a per-
manent supply of automatic transmission
fluid.
If you notice transmission fluid loss or gear
shifting malfunctions, have an authorized
Mercedes-Benz Light Truck Center check
the automatic transmission.
Coolant level
The engine coolant is a mixture of water
and anticorrosion/antifreeze.
When checking the coolant level,

the vehicle must be parked on level
ground.

the engine must be cool. The coolant
level should reach the Cold Level mark
(plastic bridge) in the reservoir.
!
Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter not
covered by the Mercedes-Benz Limited
Warranty.Warning!G
In order to avoid any possibly serious burns:

Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature display in-
dicates that the coolant is overheated.

Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid and
is under pressure.

Using a rag, slowly open the cap approx-
imately 1/2turn to relieve excess pres-
sure. If opened immediately, scalding
hot fluid and steam will be blown out un-
der pressure.

Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.


308 Practical hints
What to do if …
During severe operating conditions and
stop-and-go city traffic, the coolant tem-
perature may rise close to 248°F (120°C).
Display symbolDisplay messagePossible causePossible solution
ÏCOOLANT
STOP, ENGINE OFF!The coolant is too hot. Stop the vehicle and turn off the en-
gine.
Only start the engine again after the
message disappears. You could other-
wise damage the engine.
Warning!G
Driving when your engine is badly overheat-
ed can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously burned.
Steam from an overheated engine can cause
serious burns and can occur just by opening
the hood. Stay away from the engine if you
see or hear steam coming from it.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until the
engine has cooled down.
!
The engine should not be operated with
the coolant temperature above 248°F
(120°C). Doing so may cause serious
engine damage which is not covered by
the Mercedes-Benz Limited Warranty.

313 Practical hints
What to do if …
Display symbolDisplay message Possible causePossible solution
A RESERVE FUEL
GO TO GAS STATIONThe fuel level has dropped below the re-
serve mark.Refuel at the next gas station
(
page 239).
CHECK GAS CAP
SEE OPERATOR’S MANUALA loss of pressure has been detected in
the fuel system. The fuel cap may not be
closed properly or the fuel system may be
leaky.Check the fuel cap (page 239).
If it is not closed properly:
Close the fuel cap.
If it is closed properly:
Have the fuel system checked by an
authorized Mercedes-Benz Light Truck
Center.
YHOOD OPEN!You are driving with the hood open.Close the hood (page 243).
I REMOVE KEY!You have forgotten to remove the
SmartKey.Remove the SmartKey from the starter
switch.
REPLACE KEY
DRIVE TO WORKSHOP!No additional code available for
SmartKey.Visit an authorized Mercedes-Benz
Light Truck Center.

346 Practical hints
Replacing wiper blades
Removing wiper blades
Fold the wiper arm forward.
1Safety tab
2Wiper blade
3Wiper arm
4Attachment link
Warning!G
For safety reasons, switch off wipers and re-
move SmartKey from starter switch before
replacing a wiper blade. Otherwise, the mo-
tor could suddenly turn on and cause injury.
!
Never open the hood when the wiper
arm is folded forward.
Hold on to the wiper when folding the
wiper arm back. If released, the force
of the impact from the tensioning
spring could crack the windshield.
Do not allow the wiper arms to contact
the windshield glass without a wiper
blade inserted.
Make certain that the wiper blades are
properly installed. Improperly installed
wiper blades may cause windshield
damage.
The wiper with air spoiler should be
mounted on the driver’s side.
For your convenience, you should have
this work carried out by an authorized
Mercedes-Benz Light Truck Center.

395 Index
Driving
General instructions 43, 220
In winter 225
Problems 55
Safety systems 80
Through standing water 226
Driving abroad 236
Driving and safety systems
4-ETS 83
ABS 80
BAS 82
EBB 84
ESP 84
Driving instructions 220
Passenger compartment 227
Driving off 222
Driving systems 181
Cruise control 181
Driving safety systems 80
Driving through water 231
E
Easy-entry/exit feature 100
Activating 143
EBB 80, 84
Electrical fuses 362
Electrical outlet 200Electrical system
Technical data 374
Electronic Brake Booster (EBB) 84
Electronic Stability Program see ESP
Electronic Traction System (ETS) 83
Emergency call system 202
Emergency calls
Initiating an emergency call 205
With Tele Aid 204
Emergency operation (Limp Home
Mode) 156
Emergency operations
Closing tilt/sliding sunroof 330
Locking the vehicle 328
Opening tilt/sliding sunroof 330
Remote door unlock 209
Unlocking the tailgate 327
Unlocking the vehicle 327
Emergency tensioning device see ETD
Emission control 237
Emission control information label 368
Ending
A call (telephone) 147Engine
Compartment 242
Message in display 294
Starting with SmartKey 49
Technical data 370
Turning off with SmartKey 58
Engine air filter
Messages in display 310
Engine cleaning 285
Engine compartment 242
Hood 242
Engine malfunction indicator lamp 25,
294
Engine number 384
Engine oil 243, 377
Adding 247
Additives 378
Checking level 243
Consumption 243
Display messages 312
Messages in display 245, 311
Oil dipstick 247
Viscosity 384

398 Index
High beam flasher 52, 114
High beam headlamps
Messages in display 315
Replacing bulbs 336, 338
Switching on 114
High mounted brake lamp 336
Hood 242
Closing 243
Messages in display 313
Opening 242
Hydroplaning 224
I
Identification labels 368
Certification label 368
Vehicle identification number
(VIN) 368
Ignition
Switching on 49
Ignition (Position in starter switch) 35
Immobilizer 88
Activating 88
Deactivating 88
Infant and child restraint systems 72
Installing 76
LATCH child seat anchors 77Information
Button for Tele Aid 207
Inside rear view mirror
Auto-dimming 163
Installing
Cargo compartment cover 187
Infant and child restraint systems 76
Wiper blades 347
Instructions
Loading 192
Instrument cluster 24, 120, 385
Cleaning 287
Coolant temperature display 120
Illumination 120
Lamps in 296
Multifunction display 123
Outside temperature indicator 122
Selecting language 137
Instrument lighting 120
Instruments and controls see Cockpit
Interior lighting 116
Delayed shut-off 141
Manual operation 117
Interior rear view mirror
Adjusting 41
Intermittent wiping 54Interval wiping 55
Switching off 55
Switching on 55
J
Jack 324
Jump starting 356
K
Key, mechanical 327
Key, SmartKey
Battery check lamp 94
Checking the batteries 95
Factory setting 94
Global locking 94
Global unlocking 94
Loss of 96
Positions in starter switch 35
Remote controls 92
Restoring to factory setting 95
Selective setting 94
Starting the engine 49
Unlocking with 34
Key-dependency memory
Settings 144
Keys 92
Kickdown 385