245 Operation
Engine compartment
Other display messages
If the SmartKey is not turned to position2
in the starter switch, the following
message will appear:
FOR ENGINE OIL LEVEL
SWITCH ON IGNITION!
Switch on the ignition (page 35).
If you see the message:
OBSERVE WAITING PERIOD
If engine is at operating temperature,
wait five minutes before repeating
check procedure.
If engine is not at operating tempera-
ture yet, wait 30 minutes before re-
peating check procedure.If you see the message:
ENGINE OIL LEVEL
NOT WHEN ENGINE ON!
Turn off the engine.
If the engine is at operating tempera-
ture, wait five minutes before checking
oil.
If the engine is not at operating temper-
ature yet, you must wait 30 minutes
before checking oil.
If there is excess engine oil with the engine
at normal operating temperature, the
following message will appear:
ENGINE OIL LEVEL
REDUCE OIL LEVEL
Have excess oil siphoned or drained
off. Contact an authorized
Mercedes-Benz Light Truck Center.For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 311).
!
Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter not
covered by the Mercedes-Benz Limited
Warranty.
i
Perform the engine oil level check with
the dipstick if it cannot be completed
with the control system (
page 246).
In this case we recommend that you
have the system checked at a
Mercedes-Benz Light Truck Center.
246 Operation
Engine compartment
Checking engine oil level with the oil
dipstick
When checking the oil level the vehicle
must
be parked on level ground
be at normal operating temperature
have been stationary for at least
5 minutes with the engine turned offTo check the engine oil level with the oil
dipstick, do the following:
Open the hood (page 242).
Pull out oil dipstick1 (page 247).
Wipe oil dipstick1 clean.
Fully insert oil dipstick1 into the
dipstick guide tube.
Pull out oil dipstick1 again after
approximately three seconds to obtain
accurate reading.
Oil dipstick
The oil level is correct when it is between
the lower (min) and upper (max) mark of
the oil dipstick.
If necessary, add engine oil.
For adding engine oil, see (
page 247).
For more information on engine oil, see the
“Technical data” section (
page 376) and
(
page 377).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
page 311).
i
The engine oil level can be checked by
either the oil dipstick or via the multi-
function display in the instrument
cluster (
page 244). The amount of
engine oil needed is shown more
precisely in the multifunction display.
i
The filling quantity between the upper
and lower marks on the oil dipstick is
approximately 2.1 US qt. (2.0 l).
248 Operation
Engine compartment
Screw oil filler cap2 back on filler
neck.
For more information on engine oil, see the
“Technical data” section (
page 376) and
(
page 377).
Transmission fluid level
The transmission fluid level does not need
to be checked. The transmission has a per-
manent supply of automatic transmission
fluid.
If you notice transmission fluid loss or gear
shifting malfunctions, have an authorized
Mercedes-Benz Light Truck Center check
the automatic transmission.
Coolant level
The engine coolant is a mixture of water
and anticorrosion/antifreeze.
When checking the coolant level,
the vehicle must be parked on level
ground.
the engine must be cool. The coolant
level should reach the Cold Level mark
(plastic bridge) in the reservoir.
!
Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter not
covered by the Mercedes-Benz Limited
Warranty.Warning!G
In order to avoid any possibly serious burns:
Use extreme caution when opening the
hood if there are any signs of steam or
coolant leaking from the cooling system,
or if the coolant temperature display in-
dicates that the coolant is overheated.
Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158°F (70°C). Allow engine to
cool down before removing cap. The
coolant reservoir contains hot fluid and
is under pressure.
Using a rag, slowly open the cap approx-
imately 1/2turn to relieve excess pres-
sure. If opened immediately, scalding
hot fluid and steam will be blown out un-
der pressure.
Do not spill antifreeze on hot engine
parts. Antifreeze contains ethylene gly-
col which may burn if it comes into con-
tact with hot engine parts.
283 Operation
Vehicle care
Vehicle care
Cleaning and care of the vehicle
While in operation, even while parked, your
vehicle is subjected to varying external in-
fluences which, if gone unchecked, can at-
tack the paintwork as well as the
underbody and cause lasting damage.Such damage is caused not only by ex-
treme and varying climatic conditions, but
also by:
Air pollution
Road salt
Tar
Gravel and stone chipping
To avoid paint damage, you should imme-
diately remove:
Grease and oil
Fuel
Coolant
Brake fluid
Bird droppings
Insects
Tree resins, etc.
Frequent washing reduces and/or elimi-
nates the aggressiveness and potency of
the above adverse influences.More frequent washings are necessary to
deal with unfavorable conditions:
Near the ocean
In industrial areas (smoke, exhaust
emissions)
During winter operation
You should check your vehicle from time to
time for stone chipping or other damage.
Any damage should be repaired as soon as
possible to prevent corrosion.
In doing so, do not neglect the underbody
of the vehicle. A prerequisite for a thor-
ough check is a washing of the underbody
followed by a thorough inspection. Dam-
aged areas need to be re-undercoated.
Your vehicle has been treated at the facto-
ry with a wax-base rustproofing in the body
cavities which will last for the lifetime of
the vehicle. Post-production treatment is
neither necessary nor recommended by
Mercedes-Benz because of the possibility
of incompatibility between materials used
in the production process and others ap-
plied later.
Warning!G
Many cleaning products can be hazardous.
Some are poisonous, others are flammable.
Always follow the instructions on the partic-
ular container. Always open your vehicle’s
doors or windows when cleaning the inside.
Never use fluids or solvents that are not de-
signed for cleaning your vehicle.
311 Practical hints
What to do if …
When the ADD 1.0 QT. ENG. OIL - WHEN
NEXT REFUELLING!
(Canada: 1.0 LITER)
message appears while the engine is run-
ning and at operating temperature, the en-
gine oil level has dropped to approximately
the minimum level.When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.
Visually check for oil leaks. If no obvious oil
leaks are noted, drive to the nearest ser-
vice station where the engine oil should be
topped to the required level with an ap-
proved oil specified in the Factory
Approved Service Products pamphlet.
Display symbolDisplay messagePossible causePossible solution
: USA only:
ADD 1.0 Qt. ENGINE OIL
WHEN NEXT REFUELING!
Canada only:
ADD 1.0 LITER ENG. OIL
WHEN NEXT REFUELING!
The engine oil level is too low.Add engine oil (page 247) and check
the engine oil level (
page 244).
!
The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in
serious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.
312 Practical hints
What to do if …
Display symbolDisplay messagePossible causePossible solution
: ENGINE OIL LEVEL
REDUCE OIL LEVEL!You have added too much engine oil.
There is a risk of damaging the engine or
the catalytic converter.Have oil siphoned or drained off. Ob-
serve all legal requirements with re-
spect to its disposal.
ENGINE OIL LEVEL
STOP, ENGINE OFF!There is no oil in the engine. There is a
danger of engine damage.Carefully bring the vehicle to a halt as
soon as possible.
Turn off the engine.
Add engine oil (page 247) and check
the engine oil level (
page 244).
ENGINE OIL
VISIT WORKSHOP!It may be that there is water in the engine
oil.Have the oil checked.
ENGINE OIL LEVEL
VISIT WORKSHOP!The engine oil has dropped to a critical
level.Check the engine oil level
(
page 244) and add oil as required
(
page 247).
If you must add engine oil frequently,
have the engine checked for possible
leaks.
The measuring system is malfunctioning.Have the measuring system checked
by an authorized Mercedes-Benz Light
Truck Center.
337 Practical hints
Replacing bulbs
Notes on bulb replacement
Use only 12 volt bulbs of the same type
and with the specified watt rating.
Switch lights off before changing a bulb
to prevent short circuits.
Always use a clean lint-free cloth when
handling bulbs.
Your hands should be dry and free of oil
and grease.
If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Light Truck Center.
Have the LEDs for the following lamps re-
placed by an authorized Mercedes-Benz
Light Truck Center.
Additional turn signals in the exterior
rear view mirrors
High mounted brake lamp
Lamps in the exterior rear view mirrors
Warning!G
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas.
A bulb can explode if you:
touch or move it when hot
drop the bulb
scratch the bulb
Wear eye and hand protection.
i
Have the headlamp adjustment
checked regularly by a Mercedes-Benz
Light Truck Center.
Do not turn the headlamp adjusting
screws. If the adjusting screws are
turned, the headlamp adjustment must
be checked by a Mercedes-Benz Light
Truck Center.
392 Index
Center console 28
AIRBAG OFF indicator lamp 297
Lower part 29
Upper part 28
Centigrade
Setting temperature units 136
Central locking
From inside 99
Switch 99
Switching on/off (control
system) 142
Unlocking from inside 99
Certification label 368
Changing
Key setting 143
Charging
Vehicle battery 353
Checking
Coolant level 241, 248
Oil level 241, 243
Checklist
Off-road driving 229Child safety 72
Infant and child restraint systems 62,
72
LATCH child seat anchors 77
Child safety switch see Blocking of rear
door window operation
Cigarette lighter 199
Cleaning
Cup holders 287
Gear selector lever 287
Hard plastic trim items 287
Headlamps 165
Headliner 287
Illuminated door sill panels 288
Instrument cluster 287
Leather upholstery 288
Light alloy wheels 287
MB Tex upholstery 288
Plastic and rubber parts 288
Rear Parking Assist sensors* 286
Seat belts 287
Steering wheel 287
Windows 286
Windshield 54
Wiper blades 286
Wood trims 288Cleaning tires 254
Climate control 168
Adjusting 171
Defogging windshield 171
Defrosting 172
Rear window defroster 166
Setting the temperature 170
Clock 25
Closing
Glove box 194
Hood 243
Side windows 175
Tailgate 98
Tilt/sliding sunroof 178, 330
Tilt/sliding sunroof with
SmartKey 179
Windows 175
Windows with SmartKey 176
Closing tilt/sliding sunroof
In an emergency 330
Cockpit 22, 383
Cockpit management and data system
(COMAND) 384
Cold tire inflation pressure 273
COMAND 384