2006 MERCEDES-BENZ G500 instrument panel

Contents
Introduction.......................................... 9
Product information ................................ 9
Operator’s Manual ............................... 10
Service and warranty information .. 10
Important notice for California
retail buyers and lessees of
Mercedes-Benz automobiles .......... 11
Maintenance .................................. 12
Roadside Assistance ...................... 12
Change of address or ownership.... 13
Operating your vehicle outside the
USA or Canada............................... 13
Where to find it .................................... 15
Symbols ............................................... 16
Operating safety .................................. 17
Proper use of the vehicle ............... 17
Problems with your vehicle .................. 18
Reporting safety defects...................... 19
Reporting safety defects ................ 19
Vehicle data recording......................... 20
Information regarding electronic
recording devices........................... 20At a glance.......................................... 21
Cockpit ................................................. 22
Instrument cluster ................................ 24
Multifunction steering wheel ................ 26
Center console ..................................... 28
Upper part ...................................... 28
Lower part ...................................... 29
Overhead control panel ........................ 30
Door control panel................................ 31Getting started................................... 33
Unlocking ............................................. 34
Unlocking with the SmartKey ......... 34
Adjusting .............................................. 37
Seats .............................................. 37
Steering wheel ................................ 40
Mirrors ............................................ 41
Driving .................................................. 43
Fastening the seat belt ................... 43
Starting the engine ......................... 48
Switching on headlamps ................. 51
Turn signals .................................... 52
Windshield wipers ........................... 53
Rear window wiper/washer ............ 54
Problems while driving.................... 55
Parking and locking .............................. 57
Parking brake ................................. 57
Switching off headlamps................. 58
Turning off engine ........................... 58

21 At a glance
Cockpit
Instrument cluster
Multifunction steering wheel
Center console
Overhead control panel
Door control panel

66 Safety and Security
Occupant safety
Safety guidelines for the seat belt,
emergency tensioning device and
airbag Your vehicle was originally equipped
with airbags that are designed to acti-
vate in certain impacts exceeding a
preset threshold to reduce the poten-
tial and severity of injury. It is important
to your safety and that of your passen-
ger that you replace deployed airbags
and repair any malfunctioning airbags
to make sure the vehicle will continue
to provide supplemental crash protec-
tion for occupants.
Warning!G

Damaged seat belts or belts that were
highly stressed in an accident must be
replaced and their anchoring points
must also be checked. Use only belts in-
stalled or supplied by an authorized
Mercedes-Benz Light Truck Center.

No modifications of any kind may be
made to any components or wiring of
the SRS. This includes changing or re-
moving any component or part of the
SRS, the installation of additional trim
material, badges, etc. over the steering
wheel hub, passenger front airbag cov-
er, outboard sides of the front seat
backrests, door trim panels, or door
frame trims, and installation of addition-
al electrical /electronic equipment on or
near SRS components and wiring. Keep
area between airbags and occupants
free from objects (e.g. packages, purs-
es, umbrellas, etc.).

Airbags and emergency tensioning de-
vices (ETDs) are designed to function on
a one-time-only basis. An airbag or ETD
that was activated must be replaced.

Do not pass belts over sharp edges.
They could tear.

Do not make any modification that could
change the effectiveness of the belts.

Do not bleach or dye seat belts as this
may severely weaken them. In a crash
they may not be able to provide ade-
quate protection.

Never place your feet on the instrument
panel, dashboard, or on the seat. Always
keep both feet on the floor in front of the
seat.

Airbag system components will be hot
after an airbag has inflated. Do not
touch.

71 Safety and Security
Occupant safety
Emergency tensioning device (ETD),
seat belt force limiter
The seat belts for the front and rear outer
seats are equipped with emergency ten-
sioning devices and belt force limiters.
The ETD is designed to activate in the
following cases:

in frontal or rear-end impacts exceed-
ing a preset severity level

if the restraint systems are operational
and functioning correctly, see
1indicator lamp (
page 62)In an impact, emergency tensioning
devices remove slack from the belts in
such a way that the seat belts fit more
snugly against the body.

Belts should not be worn twisted. In a
crash, you wouldn’t have the full width
of the belt to manage impact forces. The
twisted belt against your body could
cause injuries.

Pregnant women should also use a
lap-shoulder belt. The lap belt portion
should be positioned as low as possible
on the hips to avoid any possible pres-
sure on the abdomen.

Never place your feet on the instrument
panel, dashboard or on the seat. Always
keep both feet on the floor in front of the
seat.
i
The ETDs for the front seats will only
activate if the respective front seat belt
is fastened (latch plate properly
inserted into buckle).
The ETDs for the rear outer seats will
activate with or without the respective
seat belt fastened.
Warning!G
An emergency tensioning device (ETD) that
was activated must be replaced.
When disposing of the emergency tension-
ing device, our safety instructions must be
followed. These are available at your autho-
rized Mercedes-Benz Light Truck Center.
!
Do not place objects heavier than
20 lbs (9 kg) on the front passenger
seat. This could cause the passenger
front airbag and, with the seat belt
fastened to secure the object, the ETD
on the front passenger side to deploy in
a crash which exceeds the system’s
deployment threshold.

110 Controls in detail
Lighting
For information on how to switch on the
headlamps and use the turn signals, see
“Switching on headlamps” (
page 51)
and “Turn signals” (
page 52).
Exterior lamp switch
The exterior lamp switch is located on the
dashboard to the left of the steering wheel.MOff
Daytime running lamp mode
(
page 112)
UAutomatic headlamp mode
Daytime running lamp mode
(
page 112)
CParking lamps (also tail lamps,
license plate lamps, side marker
lamps, instrument panel lamps)
BLow beam headlamps (or high
beam headlamps when the combi-
nation switch is pushed forward)
and parking lamps
ˆStanding lamps, right (turn left one
stop)
‚Standing lamps, left (turn left two
stops)
‡Indicator lamp for front fog lamps
†Indicator lamp for rear fog lampi
If you drive in countries where vehicles
drive on the other side of the road than
the country in which the vehicle is reg-
istered, you must have the headlamps
modified for symmetrical low beams.
Relevant information can be obtained
at your authorized Mercedes-Benz
Light Truck Center.

242 Operation
Engine compartment
Hood
Opening
The pull release lever is under the driver’s
side of the instrument panel.
1Release leverPull release lever1 upward.
The hood is unlocked.
2Safety hook
Lift hood up slightly.
Pull safety hook2 in direction of ar-
row and open hood.
Warning!G
Do not pull the release lever while the vehi-
cle is in motion. Otherwise the hood could
be forced open by passing air flow.
!
To avoid damage to the windshield wip-
ers or hood, open the hood only with
wipers in parked position.
Warning!G
To help prevent personal injury, stay clear of
moving parts when the hood is open and the
engine is running. Make sure the hood is
properly closed before driving. When closing
the hood, use extreme caution not to catch
hands or fingers.
The radiator fan may continue to run for ap-
proximately 30 seconds or even restart af-
ter the engine has been turned off. Stay
clear of fan blades.
Warning!G
If you see flames or smoke coming from the
engine compartment, or if the coolant tem-
perature display indicates that the engine is
overheated, do not open the hood. Move
away from vehicle and do not open the hood
until the engine has cooled down. If neces-
sary, call the fire department.

392 Index
Center console 28
AIRBAG OFF indicator lamp 297
Lower part 29
Upper part 28
Centigrade
Setting temperature units 136
Central locking
From inside 99
Switch 99
Switching on/off (control
system) 142
Unlocking from inside 99
Certification label 368
Changing
Key setting 143
Charging
Vehicle battery 353
Checking
Coolant level 241, 248
Oil level 241, 243
Checklist
Off-road driving 229Child safety 72
Infant and child restraint systems 62,
72
LATCH child seat anchors 77
Child safety switch see Blocking of rear
door window operation
Cigarette lighter 199
Cleaning
Cup holders 287
Gear selector lever 287
Hard plastic trim items 287
Headlamps 165
Headliner 287
Illuminated door sill panels 288
Instrument cluster 287
Leather upholstery 288
Light alloy wheels 287
MB Tex upholstery 288
Plastic and rubber parts 288
Rear Parking Assist sensors* 286
Seat belts 287
Steering wheel 287
Windows 286
Windshield 54
Wiper blades 286
Wood trims 288Cleaning tires 254
Climate control 168
Adjusting 171
Defogging windshield 171
Defrosting 172
Rear window defroster 166
Setting the temperature 170
Clock 25
Closing
Glove box 194
Hood 243
Side windows 175
Tailgate 98
Tilt/sliding sunroof 178, 330
Tilt/sliding sunroof with
SmartKey 179
Windows 175
Windows with SmartKey 176
Closing tilt/sliding sunroof
In an emergency 330
Cockpit 22, 383
Cockpit management and data system
(COMAND) 384
Cold tire inflation pressure 273
COMAND 384