Page 348 of 498
347 Operation
Vehicle care
Cleaning the Parktronic system*
sensors
1Parktronic system* sensors in the front
bumper
Use a mild car wash detergent, such as
Mercedes-Benz approved Car Sham-
poo, with plenty of water and a soft,
non-scratching cloth to clean
sensors1 on the bumpers.Cleaning the windows and the wiper
blades
Switch on the ignition (
page 36).
Turn combination switch to wiper
settingII (
page 54).
With wiper arms in vertical position,
switch off the ignition (
page 60).
!Do not apply strong pressure to the
sensor covers. Applying strong pres-
sure may damage the sensor covers.
Follow the instructions provided by the
power washer manufacturer on main-
taining a distance between the vehicle
and the nozzle of the power washer.!To prevent scratches, never apply
strong force and only use a soft,
non-scratching cloth when cleaning the
sensors. Do not attempt to wipe dirty
sensors with a dry cloth or sponge.
!The windshield wipers must be in a ver-
tical position before folding them away
from the windshield. They could other-
wise damage the hood.Warning!
G
For safety reasons, switch off wipers and re-
move SmartKey from starter switch (vehi-
cles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status0) before cleaning the windshield the
windshield and/or the wiper blades. Other-
wise, the wiper motor could suddenly turn
on and cause injury.
Page 356 of 498
355 Practical hints
What to do if …
Problem
Possible cause/consequence
Suggested solution
ú
(USA only)
±
(Canada only)
The yellow engine malfunction
indicator lamp comes on while
driving.
There is a malfunction in:
The fuel management system
The ignition system
The emission control system
Systems which affect emissions
Such malfunctions may result in excessive
emissions values and may switch the engine
to its limp-home (emergency operation)
mode.
Have the vehicle checked as soon as
possible by an authorized
Mercedes-Benz Center.
An on-board diagnostic connector is
used by the service station to link the
vehicle to the shop diagnostics system.
It allows the accurate identification of
system malfunctions through the read-
out of diagnostic trouble codes. It is
located in the front left area of the foot-
well next to the parking brake.
iSome states may by law require you to
visit a workshop immediately as soon
as the engine malfunction indicator
lamp comes on. Check local require-
ments.
Page 365 of 498
364 Practical hintsWhat to do if …
On the pages that follow, you will find a
compilation of the most important warning
and malfunction messages that may ap-
pear in the multifunction display.
For your convenience the messages are
divided into two sections:
Text messages (
page 365)
Symbol messages (
page 373)
Warning!
G
No messages will be displayed if either the
instrument cluster or the multifunction dis-
play is inoperative.
As a result, you will not be able to see infor-
mation about your driving conditions, such
as speed or outside temperature, warn-
ing/indicator lamps, malfunction/warning
messages or the failure of any systems.
Driving characteristics may be impaired.
If you must continue to drive, please do so
with added caution. Visit an authorized
Mercedes-Benz Center as soon as possible.
iSwitching on the ignition causes all
instrument cluster lamps (except high
beam headlamp indicator lamp and
turn signal indicator lamps unless acti-
vated) as well as the multifunction dis-
play to come on. Make sure the lamps
and multifunction display are in work-
ing order before starting your journey.
Page 379 of 498
378 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause/consequence
Possible solution
(USA only)ú(Canada only)±
Visit workshop
There may be a malfunction in the:
fuel injection system
ignition system
exhaust system
fuel system
Have the measuring system checked
by an authorized Mercedes-Benz
Center.
B
Coolant
Check level
The coolant level is too low.
Add coolant (
page 297).
If you have to add coolant frequently,
have the cooling system checked by
an authorized Mercedes-Benz Center.
Warning!
G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You can be seriously burned.
!Do not ignore the low engine coolant
level warning. Extended driving with
the message and symbol displayed
may cause serious engine damage not
covered by the Mercedes-Benz Limited
Warranty.
Do not drive without sufficient amount
of coolant in the cooling system. The
engine will overheat causing major
engine damage.
Page 382 of 498
381 Practical hints
What to do if …
Display symbol
Display messages
Possible cause/consequence
Possible solution
G
Display malfunction
Visit workshop
The displays for several systems have
malfunctioned. Some systems them-
selves may also have malfunctioned.
Continue driving with added caution.
When the multifunction display is mal-
functioning, warnings and malfunc-
tion messages might not be
displayed.
Have the electronic systems checked
by an authorized Mercedes-Benz
Center.
±
Display malfunction
Visit workshop
Certain electronic systems are unable to
relay information to the control system.
The following systems may have failed:
Coolant temperature display
Tachometer
Cruise control display
Have the electronic systems checked
by an authorized Mercedes-Benz
Center.
Engine
Service
There may be a malfunction in:
the fuel injection system
the ignition system
the exhaust system
Have the engine checked as soon as
possible by an authorized
Mercedes-Benz Center.
Page 478 of 498
477 Technical terms
Shift lock
When the vehicle is parked, this lock
prevents the transmission selector le-
ver from being moved out of positionP
without the ignition or engine on and
brake pedal depressed.
SRS
(S
upplemental R
estraint S
ystem)
Seat belts, emergency tensioning de-
vice and air bags. Though independent
systems, they are closely interfaced to
provide effective occupant protection.Tele Aid System
(T
elematic A
larm I
dentification on D
e-
mand)
The Tele Aid system consists of three
types of response: automatic and man-
ual emergency, roadside assistance
and information. Tele Aid is initially
activated by completing a subscriber
agreement and placing an acquain-
tance call.
The Tele Aid system is operational
provided that the vehicle’s battery is
charged, properly connected, not dam-
aged and cellular and GPS coverage is
available.
Telematics*
A combination of the terms “telecom-
munications” and “informatics”.Tightening torque
Force times lever arm (e.g. a lug
wrench) with which threaded fasteners
such as wheel bolts are tightened.
TIN
(T
ire I
dentification N
umber)
(
page 334)
Tire load rating
(page 334)
Tire ply composition and material used
(page 334)
Tire speed rating
(page 334)
Traction
(page 334)
Tread
(page 334)
Page 487 of 498
486 IndexHood 293
Message in display 384
HVAC see 4-zone automatic climate
control
Hydroplaning 283
I
Identification labels 446
Identification Number, Vehicle (VIN) 446
Ignition 36, 38, 50
Immobilizer 93
Indicator lamps see Lamps, indicator and
warning
Infant and child restraint systems see
Children in the vehicle
Information
About service and warranty 10
Button for Tele Aid 267
Inside door handle 111
Inside rear view mirror
Antiglare 191Installing
Infant and child restraint systems 80
Towing eye bolt 439
Wiper blades 418
Instrument cluster 24, 144, 474
Cleaning 349
Coolant temperature gauge 145
Illumination 144
Multifunction display 147
Outside temperature indicator 146
Interior lighting 141
Delayed switch-off 167
Interior rear view mirror 44
J
Jack 398, 399
Jacking up the vehicle 425
Jump starting 435K
Key, Mechanical 402
Key, SmartKey
Changing batteries 408
Key, SmartKey with KEYLESS-GO*
Changing batteries 409
KEYLESS-GO* 110, 474
Activating ignition with 38
Closing
Trunk 117
Factory setting 107
Global locking 107
Global unlocking 107
Important notes 105
Remote controls 103
Starting the engine 50
Turning off engine 60
Unlocking and opening, trunk 110
Unlocking with 35
Kickdown 180, 474
Kilopascal 333
