2006 MERCEDES-BENZ CL600 check engine

352 Practical hintsWhat to do if …?When the message:ADD 1.0 QT. OIL
AT FILLING STATION(Canada:
1.0 LITER
)
appears while the engine is running and at
operating temperature, the engine oil level
has dropped to approximately the mini-
mum level.When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.
Visually check for oil leaks. If no obvious oil
leaks are noted, drive to the nearest ser-
vice station where the engine oil should be
topped to the required level with an ap-
proved oil specified in the Factory
Approved Service Products pamphlet.
Display
Possible cause/consequence
Possible solution
:
ENGINE OIL LEVEL
VISIT WORKSHOP
The engine oil has dropped to a critical
level.

Check the engine oil level (
page 275)
and add engine oil as required
(
page 278).

If you must add engine oil frequently,
have the engine checked for possible
leaks.
There is water in the engine oil.

Have the engine oil checked.
OIL SENSOR MALFUNCT.
VISIT WORKSHOP
The measuring system is malfunctioning.

Have the measuring system checked by
an authorized Mercedes-Benz Center.
!The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in
serious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.

353 Practical hints
What to do if …?
Display
Possible cause/consequence
Possible solution
_
ENTRY POSITION
DO NOT DRIVE
Seat, exterior mirrors and steering wheel
have not yet moved to their preset driving
positions.

Wait until the seat, exterior mirrors and
steering wheel have moved to their driv-
ing positions.
The message will disappear.
Y

HOOD OPEN
You are driving with the hood open.

Close the hood (
page 274).
I
REMOVE KEY
You have forgotten to remove the
SmartKey.

Remove the SmartKey from the starter
switch.
REPLACE KEY
DRIVE TO WORKSHOP
The SmartKey is malfunctioning.

Visit an authorized Mercedes-Benz
Center as soon as possible.
AUTOMATIC LIGHT ON
REMOVE KEY
SmartKey in starter switch position
1or2.

Remove the SmartKey from the starter
switch.
KEY
CHECK BATTERY
The battery in the SmartKey with
KEYLESS-GO* is discharged.

Replace the battery (
page 377).
KEY
NOT RECOGNIZED
SmartKey with KEYLESS-GO* is not rec-
ognized while the engine is running be-
cause

the SmartKey is not in the vehicle


there is strong radio-frequency inter-
ference

Stop the vehicle in a safe location as soon
as it is safe to do so.

Search for the SmartKey.
Otherwise the vehicle cannot be centrally
locked nor can the engine be started again
after it has been stopped.

391 Practical hints
Battery
Battery
The battery is located in the trunk under
the right hand wheel well cover panel.
1Battery cover
2Locking knob
Rotate and loosen locking knob2 ap-
prox. one-half turn.

Remove battery cover1.
Warning!
G
Failure to follow these instructions can re-
sult in severe injury or death.
Never lean over batteries while connecting,
you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.Warning!
G
Do not place metal objects on the battery as
this could result in a short circuit.
Use leak-proof battery only to avoid the risk
of acid burns in the event of an accident.
!Never loosen or detach battery termi-
nal clamps while the engine is running
or the SmartKey is in the starter switch.
Otherwise the alternator and other
electronic components could be se-
verely damaged.
Have the battery checked regularly by
an authorized Mercedes-Benz Center.
Refer to Maintenance Booklet for main-
tenance intervals or contact your au-
thorized Mercedes-Benz Center for
further information.Warning!
G
With a disconnected battery

you will no longer be able to turn the
SmartKey in the starter switch and
pressing the KEYLESS-GO* start/stop
button (
page 35) on the gear selector
lever will have no effect


the gear selector lever will remain
locked in positionP

394 Practical hintsJump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:

Jump starting should only be performed
when the engine and catalytic convert-
er are cold.


Do not start the engine if the battery is
frozen. Let the battery thaw out first.


Only use 12-volt battery to jump start
your vehicle. Jump starting with a more
powerful battery could damage the ve-
hicle’s electrical system, which will not
be covered by the Mercedes-Benz
Limited Warranty.


Only use jumper cables with sufficient
cross-section and insulated terminal
clamps.


Always make sure that the jumper ca-
bles are not on or near pulleys, fans or
other parts that move when an engine
is started or running.
Warning!
G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
!Avoid repeated and lengthy starting at-
tempts.
Do not attempt to start the engine us-
ing a battery quick charge unit.
If engine does not run after several un-
successful starting attempts, have it
checked at the nearest authorized
Mercedes-Benz Center.
Excessive unburned fuel generated by
repeated failed starting attempts may
damage the catalytic converter and
may present a fire risk.
Make sure the jumper cables do not
have loose or missing insulation.
Make sure the cable clamps do not
touch any other metal part while the
other end is still attached to a battery.!Do not tow-start the vehicle.

395 Practical hints
Jump starting
The battery is located on the right side of
the trunk under the battery cover
(page 391).

Make sure the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Shift gear selector lever to positionP.

Open the trunk.

Remove battery cover.

Remove red cover from positive
terminal 1. 1Positive terminal of discharged battery
2Negative terminal of discharged bat-
tery
3Positive terminal of charged battery
4Negative terminal of charged battery

Connect positive terminals 1 and3
of the batteries with the jumper cable.
Clamp cable to charged battery3
first.

Start engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminals2 and4
of the batteries with the jumper cable.
Clamp cable to charged battery4
first.

Start the engine of the disabled vehi-
cle.
Now you can again turn on the electrical
consumers. Do not turn on the lights under
any circumstances.

Remove the jumper cables first from
negative terminals2 and4 and then
from positive terminals1 and3.
You can now turn on the lights.

Have the battery checked at the near-
est authorized Mercedes-Benz Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 281).
!Never invert the terminal connections.

423 Technical data
Fuels, coolants, lubricants, etc.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable if
MB 325.0 anticorrosion/antifreeze solu-
tion or other Mercedes-Benz approved
products of equal specification (see
Factory Approved Service Products
Pamphlet) are used to renew the coolant
concentration or bring it back up to the
proper level.
To provide important corrosion protection,
the solution must be at least 45% anticor-
rosion/antifreeze [equivalent to freeze
protection to approx. –22°F (–30°C)]. If
you use a solution that is more than 55%
anticorrosion/antifreeze [freeze protec-
tion to approx. –49°F (–45°C)], the engine
temperature will increase due to the lower
heat transfer capability of the solution.
Therefore, do not use more than this
amount of anticorrosion/antifreeze.If the coolant level is low, water and
MB 325.0 anticorrosion/antifreeze should
be used to bring it up to the proper level
(have cooling system checked for signs of
leakage). Please make sure the mixture is
in accordance with label instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality, con-
sult an authorized Mercedes-Benz Center.Anticorrosion/antifreeze
Your vehicle contains a number of alumi-
num parts. The use of aluminum compo-
nents in motor vehicle engines
necessitates that anticorrosion/antifreeze
coolant used in such engines be specifical-
ly formulated to protect the aluminum
parts. (Failure to use such anticorrosion/
antifreeze coolant will result in a signifi-
cantly shortened service life.)
Therefore, the following product is strongly
recommended for use in your vehicle:
Mercedes-Benz 325.0 anticorrosion/
antifreeze agent.
Before the start of the winter season (or
once a year in hot southern regions), you
should have the anticorrosion/antifreeze
concentration checked. The coolant is also
regularly checked each time you bring your
vehicle to an authorized Mercedes-Benz
Center for service.

434 IndexAutomatic locking when driving 110
Automatic transmission 48, 165
Accelerator position 169
Driving tips 169
Emergency operation (Limp Home
Mode) 177
Gear ranges 170
Gear selector lever position 48, 165,
167
Gear shifting malfunctions 177
Kickdown 169
Kickdown, manual shift program
CL 55 AMG and CL 65 AMG 177
Manual (One-touch) gearshifting 172
Manual shift program CL 55 AMG and
CL 65 AMG 175
Shift program mode selector
switch 171
Starting the engine 48
Steering wheel gearshift control
CL 55 AMG and CL 65 AMG 173
Transmission fluid level 279
Warning sounds (vehicles with
KEYLESS-GO*) 59B
BabySmart
TM
Air bag deactivation system 74
Compatible child seats 427
Self-test 74
Backrest
Power seats 37
Power seats, Multicontour* 117
Backrest supports
Shoulder region (Multicontour
seats*) 117
Backup lamps
Replacing bulbs 379, 383
Bar 309
BAS 81, 427
Batteries, SmartKey
Checking battery condition 93
Replacing 376
Battery, SmartKey with KEYLESS-GO*
Checking battery condition 99
Replacing 377
Battery, Vehicle 281, 391
Charging 392
Disconnecting 392
Jump starting 394
Message in display 345Reconnecting 393
Reinstalling 392
Removing 392
Bead 309
Beverage holder see Cup holder
Bi-Xenon headlamps see Headlamps
Block heater (Canada only) 314
Brake Assist System see BAS
Brake fluid 420
Brake warning lamp 329
Checking 271
Message in display 346
Brake lamp
High mounted 379
Messages in display 354
Replacing bulbs 379
Brake pads
Message in display 346
Brakes 260
High-performance brake system
(CL 65 AMG only) 261
Warning lamp 329
Break-in the vehicle 258
Bulbs, replacing
Side marker lamps, front 382
Bulbs, replacing see Replacing bulbs

438 IndexEngine oil 274, 420
Adding 278
Additives 420
Changing 278, 420
Checking level 274
Consumption 274
Filler neck 278, 279
Messages in display 275, 276, 351
Recommended engine oils and oil
filter 420
Viscosity 428
ESP
®
82, 429
Messages in display 342
Warning lamp 332, 333
ETD 71, 429
Safety guidelines 66
Exterior rear view mirrors 43
Auto-dimming on the driver’s
side 178
Parking position 124, 180
Parking position for 164
Power folding 180
Storing parking position 124F
Filler neck, Engine oil 278, 279
First aid kit 369
Flat tire 386
Jacking up the vehicle 387
Lowering the vehicle 390
Mounting the spare wheel 386
Preparing the vehicle 386
Flexible Service System see FSS
Fluids
ABC fluid 279
Automatic transmission 279, 418
Brake fluid 272, 418, 420
Capacities 418
Engine coolant 280, 419, 422
Engine oil 418, 420
Hydraulic system for ABC 418
Power steering fluid 418
Windshield washer system and head-
lamp cleaning system 282, 419,
425
Fog lamps 128, 379
Messages in display 355, 357
Replacing bulbs 379, 383Front air bags 67
Front lamps see Headlamps
Front passenger front air bag 63, 67
Front passenger front air bag off indicator
lamp 74, 336
Front seat head restraints see Head re-
straints
FSS (Canada vehicles) 315, 429
Fuel 271, 419, 421
Additives 422
Capacities, Fuel tank 419
Consumption statistics after
start 151
Consumption statistics since last
reset 152
Filling the tank 270
Fuel filler flap and cap 270, 374
Fuel gauge 25, 331
Fuel reserve warning lamp 25, 331
Requirements, Octane rating 271,
419, 421
Technical data 419, 421
Fuel cap
Engine malfunction indicator
lamp 331
Message in display 360