2006 MERCEDES-BENZ C55AMG remote start

23 At a glance
Cockpit
ItemPage
1Steering wheel gearshift
control163
2Cruise control lever245
3Multifunction steering
wheel26,
126
4Horn
5Instrument cluster24,
122
6Overhead control panel29
ItemPage
7Glove box lid release256
8Glove box lock256
9Center console27
aStarter switch33
bHood lock release297
cSteering wheel adjustment
lever38
dRemote trunk opening
switch100
eParking brake pedal46, 54
fDoor control panel30
ItemPage
gParking brake release46
hCombination switch

Turn signals49

Windshield wipers50

High beam49
jExterior lamp switch48,
114
kExterior rear view mirror
adjustment40,
113
lHeadlamp washer button*169

32 Getting started
The “Getting started” section provides an
overview of the vehicle’s most basic func-
tions. First-time Mercedes-Benz owners
should pay special attention to the infor-
mation given here.
If you are already familiar with the basic
functions described here, the “Controls in
detail” section (
page 94) will provide you
with further information. The correspond-
ing page references are located at the end
of each segment.
Unlocking
Unlocking with the SmartKey
SmartKey with remote control
1‹Lock button
2ŠOpening button for trunk
3ŒUnlock button
4ÂPanic button* (
page 81)
Press unlock buttonΠon the
SmartKey.
All turn signal lamps flash once. The
locking knobs in the doors move up.
The anti-theft alarm system* is dis-
armed.
Get in the vehicle and insert the
SmartKey in the starter switch.
For more information, see “Locking and
unlocking” (
page 94).
i
Canada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button4.

94 Controls in detail
In the “Controls in detail” section you will
find detailed information on how to oper-
ate the equipment installed on your vehi-
cle. If you are already familiar with the
basic functions of your vehicle, this section
will be of particular interest to you.
To quickly familiarize yourself with the ba-
sic functions of the vehicle, refer to the
“Getting started” section of this manual.
The corresponding page numbers are giv-
en at the beginning of each segment.
For more information on locking and
unlocking, see “Getting started”
(
page 32) and (page 54).
Locking and unlocking
SmartKey
Your vehicle comes supplied with two
SmartKeys, each with remote control and
a removable mechanical key.
The locking tabs for the mechanical key
portion of the two SmartKeys are a
different color to help distinguish each
SmartKey unit.
The SmartKey provides an extended oper-
ating range. To prevent theft, however, it is
advisable to only unlock the vehicle when
you are in close proximity to it.
The SmartKey centrally locks and unlocks:

the doors

the trunk

the fuel filler flap
SmartKey with remote control
1‹ Lock button
2Š Opening button for trunk
3Mechanical key locking tab
4ΠUnlock button
5Battery check lamp
6Â Panic button* (
page 81).
i
Canada only:
Only vehicles equipped with an
anti-theft alarm system* have
SmartKeys with integrated panic
button6.

104 Controls in detail
Locking and unlocking
Locking and unlocking from the inside
You can lock or unlock the doors and the
trunk from inside using the central locking
or unlocking switch. This can be useful, for
example, if you want to lock the vehicle
before starting to drive.
You cannot lock or unlock the fuel filler flap
with the central locking or unlocking
switch.The switches are located in the center
console.
1Central locking switch
2Central unlocking switch
Warning!G
When leaving the vehicle, always remove the
SmartKey from the starter switch, take it
with you, and lock the vehicle. Do not leave
children unattended in the vehicle, or with
access to an unlocked vehicle. Unsuper-
vised use of vehicle equipment may cause
an accident and/or serious personal injury.
i
You can open a locked door from the
inside. Open door only when conditions
are safe to do so.
If the vehicle was previously centrally
locked using the SmartKey, it will not
unlock using the central unlocking
switch2.
If the vehicle was previously locked
with the central locking switch1

while in the selective remote con-
trol mode, only the door opened
from the inside is unlocked.

while in the global remote control
mode, the complete vehicle is
unlocked when a door is opened
from the inside.

275 Controls in detail
Useful features
Step 5:
After the indicator lamp1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.Step 6:
Press and hold the just-trained signal
transmitter button (2, 3 or4) and
observe the indicator lamp1.
If the indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3 or4) is pressed and re-
leased.Step 7:To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling code
feature, follow these instructions after
completing the “Programming” portion
(steps 1 through 6) of this text. (A second
person may make the following training
procedures quicker and easier.)
i
The indicator lamp1 flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
i
If the indicator lamp1 flashes rapidly
for about 2 seconds and then turns to a
constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.

277 Controls in detail
Useful features
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
Press and hold the signal transmitter
button (2, 3 or4). Do not release
this button until it has been successful-
ly trained.
While still holding down the signal
transmitter button (2, 3 or4),
“cycle” your hand-held remote control
button6 as follows: Press and hold
button6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.
Proceed with programming step 5 and
step 6 to complete.
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Switch on the ignition (page 33).
Press and hold the desired signal
transmitter button (2, 3 or4).
Do not release the button.
The indicator lamp1 will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.
Operation of integrated remote control
Switch on the ignition (page 33).
Select and press the appropriate inte-
grated signal transmitter button (2,
3 or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
i
Upon completion of programming the
integrated remote control, make sure
you retain the hand-held remote con-
trol that came with the garage door
opener, gate operator or other device.
You may need it for use in other vehi-
cles, for future programming of an
integrated remote control, or simply for
continued use as a hand-held remote
control to operate the respective
device in other situations.

452 Index
Control system submenus 127, 129
Convenience 148
Instrument cluster 138
Lighting 144
Time/Date 140
Vehicle 147
Controller Area Network see CAN system
Coolant 301, 439
Anticorrosion/antifreeze
quantity 440
Capacities 436
Checking coolant level 295, 301
Messages in display 367–369
Temperature 292
Temperature gauge 25, 123
Cruise control 245, 444
Message in display 370
Cup holder 258, 260
Cleaning 346
Curb weight 332
Customer Assistance Center see CACD
Date display, setting 142, 143
Daytime running lamp mode 116
Setting 144
Deep water see Standing water
Defogging windshield
Automatic climate control*
(Canada only) 191
Climate control 180
Defrosting, Front
Automatic climate control*
(Canada only) 190
Climate control 179
Defrosting, Rear 173
Delayed shut-off
Exterior lamps 146
Interior lighting 147
Department of Transportation see DOT
Difficulties
While driving 52
With starting 46
Digital clock see clock
Digital speedometer 130
Dimensions, vehicle 435
Direction of rotation (tires) 308Displays
Digital speedometer 130
Maintenance service indicator 338
Messages in display 370
Multifunction display 125
Outside temperature 130
Symbol messages 365
Text messages 360
Vehicle status messages
memory 135, 358
Distance to empty (range),
Trip computer 151
Door control panel 30
Doors
Entry lamps 121
Locking/unlocking, SmartKey 94
Message in display 370
Opening from inside/outside 96, 99
Remote door unlock (Tele Aid*) 272
Unlocking, Mechanical key 386
DOT 332
Downhill driving
Cruise control 246
Drinking and driving 283

453 Index
Driving
Abroad 290
Hydroplaning 287
In winter 288
Instructions 42, 283
Problems 52
Safety systems 82
Systems 245
Through standing water 289
Driving safety systems
ABS 82
BAS 84
ESP
®84
E
Easy-entry/exit feature 39, 148
Electrical fuses see Fuses
Electrical outlet 263
Electrical system, Technical data 434
Electronic Stability Program see ESP
®
Emergency calls
911 calls 235
Tele Aid* calls 266, 267, 271
Emergency operation
(Limp-Home Mode) 168Emergency operations
Gear selector lever, Unlocking 388
Locking/unlocking the vehicle 386
Power tilt/sliding sunroof*,
Manual operation 389
Remote door unlock 272
Trunk lid, Releasing from inside 102
Trunk lid, Unlocking 387
Emergency Tensioning Device see ETD
Emergency, in case of
Battery, Jump starting 415
First aid kit 350, 380
Flat tire, Changing 404
Fuses 420
Hazard warning flasher 119
Instrument cluster,
Indicator lamps 350–356
Roadside Assistance 12, 268
Towing the vehicle 417
Emission control 291
Information label 426
System warranties 10Engine
Belt layout 427
Block heater (Canada only) 337
Brake-in recommendations 282
Cleaning 343
Compartment 297
Malfunction indicator lamp 25, 352
Maximum engine speed 428
Number 426
Starting 46
Technical data 428
Turning 56
Engine coolant see coolant
Engine number 444
Engine oil 298, 437
Adding 300
Additives 437
Changing 436
Checking level 299
Consumption 298
Display messages 299
Filler neck 301
Messages in display 299, 371, 372
Recommended engine and
oil filter 371
Viscosity 444