2006 MAZDA MODEL TRIBUTE belt

INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
WARNING LIGHTS
8. Anti-lock Brake
System (ABS)
ABS malfunction,
normal brakes only, dealer
inspection required
9. Always fasten
safety belts
10. Air bag readiness
Front or side air bag malfunction,
dealer inspection required
11. Four wheel drive
indicator*
Light blinking continuously
indicates 4WD in heat
protection mode
Light blinking intermittently
indicates 4WD system disabled,
dealer inspection required
See Transaxle12. Turn signals/hazard
warning on
13. High beams on
14. Cruise control on*,see Getting Started
15. Brake system
Parking brake on/low brake fluid
16. Overdrive off
indicator*, see Transaxle
17. Service engine soon
Dealer inspection required if
light remains on, see Owner’s
Manual
18. Engine oil pressure
warning light
19. Charging system
warning light
Dealer inspection required
20. Low fuel
Refuel as soon as possible
21. Check fuel cap
Fuel filler cap not properly
installed
22. Door ajar
23. Anti-theft on
24. Tire Pressure Monitoring
System (TPMS)*
Warning light illuminates for a
few seconds after ignition is on
If tire pressure is too high or
too low, or tire temperature is
too high, warning light will
illuminate and beeper will sound
Flashing warning light indicates
possible malfunction; dealer
inspection required
Instrument
Cluster
Instrument
Cluster
*Denotes optional equipment
GAUGES
1. Tachometer
2. Speedometer
3. Fuel gauge
16.5-gallon/62-liter tank
(2.3L and 3.0L)4. Odometer/trip odometer
selector
Press to toggle between
odometer and trip odometer
Tip: Press and hold for more
than 1 second to reset trip
odometer
5. Odometer
6. Gearshift indicator (A/T)*
7. Coolant temperature gauge
If above normal range, stop
vehicle and turn off engine, check
coolant level when safe
1312
0 20406080100
120
140
160
180
x1000r/min8
0 204060
80
100
120
7 6 5
4
3
2
1
0
F
E CH
7233620225
8
9
10
19
18
171615
4
ODO
4WD
1224111214
21
4WD

MIRRORS/WINDOWS
Always check the Owner’s Manual for more operating information and safety features
Mirrors/
Windows
Child-Safety
Seats
*Denotes optional equipment
Child-safety seat*
Install in rear outboard
passenger seat positions using
dual-locking mode retractorsafety
belts; see Owner’s Manual for
proper installation and seat tether
and LATCH system instructions
Passenger air bag sensing
system,see Getting Started
WARNINGS: Use age
appropriate child restraints,
see Owner’s Manual and
state or province laws
Never place rear-facing
infant-safety seat in front
passenger seat in front
of any air bag, an infant
is in serious danger of
being injured or killed
If you must install a
forward-facing child-safety
seat in the front seating
position, move vehicle seat
as far back as possible
It is strongly recommended
that you install front facing
child-safety seats in rear
seating areaRear child-safety seat
anchors
Anchors located on rear seat
cushion for securing child-safety
seat (see Owner’s Manual)
Dual locking mode lap/
shoulder belt retractor
(front passenger and all
rear belts only)
Vehicle sensitive mode:
Belt locks only on hard braking/
cornering or impacts of about
5 mph or higher
Automatic locking mode must
be used when installing child-
safety seat
To activate: Pull webbing fully out of
retractor, allow belt to retract until
click is heard; belt will only tighten
To disengage: Unbuckle belt
and allow webbing to retract
fully; for complete details
see Owner’s Manual Dual power
mirrors
To adjust left/right
mirror: Rotate control
switch (1) left/right,
tilt in direction
of desired mirror
movement
Tip: To lock mirrors in
place, move control switch
to center position
Power windows
Operate with ignition in
ON position
All windows may be controlled
from driver’s door; each passenger
door has a separate switch
2. Driver’s window
One-touch-down: Press rear
of switch firmly and release,
window goes down all
the way; tap switch again
to stop; press and hold for normal operation; press and
hold front of switch to close
3. Passenger window
switches
Press rear/front of switch
to open/close
4. Power window lockout
switch
Press right side of switch:
only driver’s window operates;
press left side of switch and all
windows function again
Tip: Power windows and
moon roof can be operated
for up to 10 minutes after
ignition key is turned off
and with doors closed,
opening door will completely
cancel this function
1
AUTO
3 2
4

SEATS
Always check the Owner’s Manual for more operating information and safety features
Beltminder
Intermittently
sounds chime
and illuminates
safety belt
warning lamp
when driver’s safety
belt is unbuckled
and occupied
Front seat shoulder
belt height adjustment
To raise/lower belt: Squeeze
and hold release buttons (1)
and slide up/down
WARNING: Make sure
adjuster locks in one
of its positions
Manual controls
1. Fore/aft adjustment
Raise lever and hold, slide
seat, release lever
2. Seatback angle/tilt
slide seats
To adjust seatback: Lift and hold
lever, lean forward or back-
ward to tilt seat, release lever
To slide unoccupied seat: Lift
lever to unlock, fold seatback
down and slide seat forward
To lock seat: Move to desired
position and raise seatback
to upright position
3 . Manual lumbar adjustment*
Rotate clockwise/counterclock-
wise to increase/decrease
firmness4. Head restraint
To raise/lower: Pull up/
hold release button (9)
and push down
Tip: Rear seat head
restraints* can be removed
to provide better visibility,
rear head restraints* must
be replaced if seats are
occupied
Power driver’s seat*
5. Raise/lower front of seat
Pull/push front of switch
up/down
6. Fore/aft adjustment
Slide entire switch horizontally
Raise/lower seat cushion
Pull/push entire switch
vertically
Seats
Seats
*Denotes optional equipment
7. Raise/lower rear
of seat
Pull/push back of switch
up/down
8. Heated seats*
Press to activate/
deactivate
Folding rear seat,
see Owner’s Manual
WARNING: Never drive
with any seat in a reclined
position because you will
not get the full protection
from safety belts
9
765
3
12
4
8
WARNINGS: Do not adjust
seats while driving
Safety belts must always
be worn when vehicle is
in motion
All air bags are supplemental
and do not replace safety
belt usage
Always wear your safety
belt and properly secure
children 12 and under
in the rear seat, and in
appropriate child
safety seats
11

UNDER HOOD
Always check the Owner’s Manual for more operating information and safety features
Under Hood
1 . Windshield washer reservoir
Fill with windshield washer
fluid, not water
2. Power steering fluid
reservoir
Check with engine off and at
normal temperature; fluid level
should be within MIN and
MAX lines
3. Engine coolant reservoir
Level should be at cold fill level
or within the cold fill range
when cold
WARNING: Never remove
coolant reserve tank cap
while engine is running or
hot; you could get burned
4. Brake/clutch fluid reservoir
Fill to MAX mark with DOT 3
fluid, check with cap on
5. Air filter
6. Power distribution box 7. Battery
8. Engine oil filler cap
9. Hood latch
10. Engine oil dipstick
Check with engine off and
at normal temperature; oil
level should be within
crosshatched area of dipstick
11. Automatic transaxle
fluid dipstick**
Check with engine on at
operating temperature; fluid
level should be within
crosshatched area
2.3L Engine
3.0L Engine
Tip: For additional service
details, see Owner’s Manual
Normal maintenance notes
Change engine oil/replace filter
every 5,000*/7,500 miles; rotate
tires every 7,500 miles or sooner
if needed; replace cabin air filter
every 25,000 miles or 24 months
A.Change: Engine oil/replace filter
Inspect: Engine coolant level, brake
fluid level, tire inflation pressure
and tire wear, power steering
fluid level, washer fluid level
Lube: Locks and hinges
B.Inspect: Disc brakes
C.Inspect: Drive belts (3.0 liter),
fuel lines and hoses, brake lines,
hoses and connections, drum
brakes, steering operation and
linkages, front and rear suspension
ball joints, driveshaft dust
boots, exhaust system heat
shields, chassis/bodybolts and
nuts, cooling system and hoses
Replace: Fuel filterD.Inspect: Drive belts (2.3 liter)
Replace: Air filter
E.Inspect: Hoses and tubes
for emission system
F. Replace: Spark plugs
Inspect: Engine valve clearance
(2.3 liter), adjust if noisy
G.Replace: PCV valve (3.0 liter),
engine coolant (yellow)
H.Replace: Manual transaxle fluid
Fuel pump
shutoff
Disables fuel
pump after
a substantial
jolt; located in front passenger’s
footwell, by kick panel access cover
To reset: Press down top of
exposed red reset button (1)
WARNING: Do not reset
shutoff switch if you see
or smell fuel
7,500 miles
15,000 miles
22,500 miles
30,000 miles
37,500 miles
45,000 miles
52,500 miles
60,000 miles
67,500 miles
75,000 miles
82,500 miles
90,000 miles
A A C
H A A D F A
A B C E A A
A D
A B C
A A
A B
5,000 miles*A
97,500 miles
G 100,000 miles
* Special operating conditions
** Denotes optional equipment
91107
38245611
918107
3241156
1