2006 MAZDA MODEL MX-5 MIATA train

Black plate (29,1)
WARNING
Proper Size of Child-Restraint System:
For effective protection in vehicle accidents and sudden stops, a child must be
properly restrained using a seat belt or child-restraint system depending on age and
size. If not, the child could be seriously injured or even killed in an accident.
Follow the Manufacturer's Instructions and Always Keep the Child-Restraint System
Buckled Down:
An unsecured child-restraint system is dangerous. In a sudden stop or a collision it
could move causing serious injury or death to the child or other occupants. Make sure
any child-restraint system is properly secured in place according to the child-restraint
system manufacturer's instructions. When not in use, remove it from the vehicle or
fasten it with a seat belt, or latch it down to BOTH LATCH lower anchors for LATCH
child-restraint systems.
Holding a Child While the Vehicle is Moving:
Holding a child in your arms while the vehicle is moving is extremely dangerous. No
matter how strong the person may be, he or she cannot hold onto a child in a sudden
stop or collision and it could result in serious injury or death to the child or other
occupants. Even in a moderate accident, the child may be exposed to air bag forces
that could result in serious injury or death to the child, or the child may be slammed
into the adult, injuring the adult. Always secure a child in a proper child-restraint
system.
Rear-Facing Child-Restraint System:
Seating a child in a rear-facing child-restraint system that is installed on the
passenger seat with the passenger air bag deactivation indicator light not illuminated
is extremely dangerous. In an accident, a air bag could inflate and cause serious
injuries or even death to the child seated in the rear-facing child-restraint system.
When using a rear-facing child-restraint system, always make sure the passenger air
bag deactivation indicator light is illuminated by using the key to turn the passenger
air bag off.
Refer to Passenger Air Bag Deactivation Switch on page 2-30.
Refer to Passenger seat weight sensors on page 2-37.
Essential Safety Equipment
Child Restraint
2-17
MX-5_8U35-EA-05F_Edition4 Page29
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (30,1)
WARNING
Seating Children in a Child-Restraint System on the Passenger Seat:
This vehicle is equipped with both a passenger seat weight sensor and a passenger an
air bag deactivation indicator light (page 2-37). Even with the passenger seat weight
sensors, seating a child in a child-restraint system on the passenger seat under the
following conditions increases the danger of the passenger air bag deploying and
could result in serious injury or death to the child. These are among the reasons why
the passenger air bag should be turned off by using the key.
lThe total seated weight of the child with the child-restraint system on the passenger
seat is approximately 30 kg (66 lb) or more with a child in the child-restraint
system.
lLuggage or other items are placed on the seat with the child in the child-restraint
system.
lThe seat is washed.lLiquids are spilled on the seat.lThe passenger seat is moved backward, and it is pushed into luggage or other items
placed behind it.
lLuggage or other items are placed between the passenger seat and center console.lAny accessories which might increase the total seated weight on the passenger seat
are attached to the passenger seat.
Children and Seating Position with Side Air Bag:
Allowing anyone to lean over or against the door is dangerous. If the vehicle is
equipped with side air bags, the impact of an inflating side air bag could cause serious
injury or death to the person. Children are more likely to sleep in the vehicle; when
they do, they are more at risk in the passenger's seat that has a side air bag because
they may slump over into the path of the seatback-mounted air bag. Furthermore,
leaning over or against the doors could block the side air bag and eliminate the
advantages of supplemental protection. Because the side air bag deploys from the
outboard shoulder of the seat, do not allow the child to lean over or against the side
window, even if the child is seated in a child-restraint system.
One Belt, One Passenger:
Using one seat belt for more than one person at a time is dangerous. A seat belt used
in this way can't spread the impact forces properly and the two passengers could be
crushed together and seriously injured or even killed. Never use one belt for more
than one person at a time and always operate the vehicle with each occupant properly
restrained.
2-18
Essential Safety Equipment
Child Restraint
MX-5_8U35-EA-05F_Edition4 Page30
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (31,1)
WARNING
Child-Restraint Tether:
Using a child-restraint system that requires a tether is dangerous. Your Mazda doesn't
have a child-restraint tether. The child-restraint system cannot be properly secured. In
a collision, it could move and cause serious injury or even death to the child or
someone else. Always use a child-restraint system designed for use without a tether.
CAUTION
A seat belt or child-restraint system can become very hot when exposed to direct
sunlight during warm weather. To avoid burning yourself or a child, check them before
you or your child touches them.
NOTE
Your Mazda is equipped with LATCH lower anchors for attachment of specially
designed LATCH child-restraint systems behind the passenger seat that slide through the
passenger seat when it is in the fully rearward position. When using these anchors to
secure a child-restraint system, refer to“LATCH Child-Restraint Systems ”(page 2-23).
Essential Safety Equipment
Child Restraint
2-19
MX-5_8U35-EA-05F_Edition4 Page31
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (32,1)
Installing a Child-
Restraint System
The passenger lap/shoulder belt can easily
be converted into the automatic locking
mode, which must be done to hold the
child-restraint system.
Some child-restraint systems also employ
specially designed LATCH attachments;
refer to“LATCH Child-Restraint
Systems ”(page 2-23).
Follow these manufacturer's instructions
when installing a child-restraint system on
the passenger's seat, unless you are
attaching a LATCH-equipped child-
restraint system to the LATCH lower
anchors. Refer to “LATCH Child-
Restraint Systems ”(page 2-23).
NOTE
Follow the child-restraint system
manufacturer's instructions carefully. If
you are not sure whether you have a
LATCH system, check in the child-
restraint system manufacturer's
instructions and follow them
accordingly. Depending on the type of
child-restraint system, it may not
employ seat belts which are in
automatic locking mode, however if it
uses an upper tether, it may not be
mounted properly in this vehicle as
there is no safe way to anchor the tether.
Confirm whether the child-restraint
system can be used with seat belts by
reading the child-restraint system
manufacturer's instructions. Before installing a child-restraint system,
make sure the passenger air bag
deactivation indicator light illuminated by
using the key to turn the passenger air bag
off.
Refer to Passenger seat weight sensors on
page 2-37.
Refer to Passenger Air Bag Deactivation
Switch on page 2-30.
1. Make sure to remove articles from
behind the passenger seat that would
prevent the seat from sliding back fully,
and then slide the seat as far back as
possible.
2. Secure the child-restraint system with
the lap portion of the lap/shoulder belt.
See the instructions on the child-
restraint system for belt routing
instructions.
3. To get the retractor into the automatic locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.
2-20
Essential Safety Equipment
Child Restraint
MX-5_8U35-EA-05F_Edition4 Page32
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (33,1)
4. Push the child-restraint system firmlyinto the vehicle seat. Be sure the belt
retracts as snugly as possible. Clicking
from the retractor will be heard during
retraction if the system is in automatic
locking mode. If the belt does not lock
the seat down tight, repeat this step.
5. Make sure the passenger air bag deactivation indicator light illuminates
by using the key to turn the passenger
air bag off after installing a child-
restraint system on the passenger seat.
WARNING
Rear-Facing Child-Restraint System:
Seating a child in a rear-facing child-
restraint system that is installed on the
passenger seat with the passenger air
bag deactivation indicator light not
illuminated is extremely dangerous. In
an accident, a air bag could inflate
and cause serious injuries or even
death to the child seated in the rear-
facing child-restraint system. When
using a rear-facing child-restraint
system, always make sure the
passenger air bag deactivation
indicator light is illuminated by using
the key to turn the passenger air bag
off.
Refer to Passenger seat weight sensors
on page 2-37.
Refer to Passenger Air Bag
Deactivation Switch on page 2-30.
Essential Safety Equipment
Child Restraint
2-21
MX-5_8U35-EA-05F_Edition4 Page33
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (34,1)
NOTE
lInspect this function before each use
of the child-restraint system. You
should not be able to pull the
shoulder belt out of the retractor
while the system is in the automatic
locking mode. When you remove the
child-restraint system, be sure the
belt fully retracts to return the system
to emergency locking mode before
occupants use the seat belts.
lFollow the child-restraint system
manufacturer's instructions carefully.
Depending on the type of child-
restraint system, it may not employ
seat belts which are in automatic
locking mode, however if it uses an
upper tether, it may not be mounted
properly in this vehicle as there is no
safe way to anchor the tether.
Confirm whether the child-restraint
system can be used with seat belts by
reading the child-restraint system
manufacturer's instructions.
2-22
Essential Safety Equipment
Child Restraint
MX-5_8U35-EA-05F_Edition4 Page34
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (35,1)
LATCH Child-Restraint System
Your Mazda is equipped with LATCH lower anchors for attachment of specially designed
LATCH child-restraint systems behind the passenger seat that slide through the passenger
seat when it is in the fully rearward position. Only LATCH booster seats and infant carriers
without upper tethers can be used in this position, as there is no good place to anchor the
tether due to this vehicle's design. Both anchors must be used when installing these lower
anchor only child-restraint systems, otherwise the seat will bounce around and put the child
in danger.
WARNING
Manufacturer's Instructions for Child-Restraint System:
An unsecured child-restraint system is dangerous. In a sudden stop or a collision it
could move causing serious injury or death to the child or other occupants. Make sure
any child-restraint system does not rely on an upper tether and then properly secure
those non-tethered seats according to the child-restraint system manufacturer's
instructions.
Unsecured Child-Restraint System:
An unsecured child-restraint system is dangerous. In a sudden stop or a collision it
could move causing serious injury or death to the child or other occupants. Follow the
child-restraint system manufacturer's instructions on belt routing to secure the seat
just as you would with a child in it so that nobody is tempted to put a child in an
improperly secured seat later on. When not in use, remove it from the vehicle or fasten
it with a seat belt, or latch it down to BOTH LATCH lower anchors for LATCH child-
restraint systems.
LATCH Child-Restraint Systems:
Not following the child-restraint system manufacturer's instructions when installing
the child-restraint system is dangerous. If seat belts or a foreign object prevent the
child-restraint system from being securely attached to the LATCH lower anchors and
the child-restraint system is installed improperly, the child-restraint system could move
in a sudden stop or collision causing serious injury or death to the child or other
occupants. When installing the child-restraint system, make sure there are no seat
belts or foreign objects near or around the LATCH lower anchors. Always follow the
child-restraint system manufacturer's instructions.
Essential Safety Equipment
Child Restraint
2-23
MX-5_8U35-EA-05F_Edition4 Page35
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F

Black plate (36,1)
qLATCH Child-Restraint System
Installation Procedure
Before installing a child-restraint system,
make sure the passenger air bag
deactivation indicator light illuminated by
using the key to turn the passenger air bag
off.
Refer to Passenger seat weight sensors on
page 2-37.
Refer to Passenger Air Bag Deactivation
Switch on page 2-30.
1. Make sure to remove articles from
behind the passenger seat that would
prevent the seat from sliding back fully,
and then slide the seat as far back as
possible to insert the LATCH lower
anchors between the seat bottom and
the seatback.
2. Expand the area between the seat bottom and the seatback slightly to
verify the locations of the LATCH
lower anchors.
NOTE
The markings above the LATCH lower
anchors indicate the locations of the
LATCH lower anchors for the
attachment of a child-restraint system. 3. Secure the child-restraint system using
BOTH LATCH lower anchors,
following the child-restraint system
manufacturer's instruction, however if
it uses an upper tether, it may not be
mounted properly in this vehicle as
there is no safe way to anchor the
tether. Confirm whether the child-
restraint system can be used with seat
belts by reading the child-restraint
system manufacturer's instructions.
4. Make sure the passenger air bag deactivation indicator light illuminates
by using the key to turn the passenger
air bag off after installing a child-
restraint system on the passenger seat.
2-24
Essential Safety Equipment
Child Restraint
MX-5_8U35-EA-05F_Edition4 Page36
Thursday, October 6 2005 11:2 AM
Form No.8U35-EA-05F