GETTING STARTED
Always check the Owner’s Manual for more operating information and safety features
Getting
Started
Getting
Started
Tip: Each time switch is
pressed, a beeper will
sound, this is normal Power sliding doors*
The power sliding doors can be
opened/closed by using: Exterior/
interior door handles, keyless
remote, lower dashboard power
sliding door switches and one
switch on each sliding door post
WARNING: Read all information
and warnings related to power
sliding doors in Owner’s Manual
Opening/closing using door
handles
Power sliding doors automatically
open/close by sliding door
approximately 2” in desired direction
from fully opened/closed positions;
buzzer will sound before door operates
Tip: If the system is
completely inoperative,
both sliding doors can be
operated manually
Operation from rear seatsPress switch for 1 second, doors
automatically open or close after
buzzer sounds; press again to stop
Tip: Turn on MAIN SWITCH to
operate system, then return
switch to OFF POSITION to
keep children from electrically
operating sliding doors, also
activate both manual safety
locks to keep children from
manually operating
sliding doors Operation from driver’s seat
Power sliding doors main switch:
Press (2) to disable/enable system
Opening/closing using switches:
Stop vehicle, shift into park and
apply parking brake; unlock
sliding doors and press main
switch (2) to ON position; press
left/right switches (1) to open/close
Press switch for 1 second,
doors automatically open or
close after beep sounds; press
again to stop sliding doors while
they are opening/closing
If power sliding doors malfunction
and beep sounds continuously;
press main switch to OFF position
to disable, see your Mazda Dealer
2
1
Tips: The system operates
only in PARK position
The system may not operate
correctly if battery voltage
is low
Manual sliding door
Closing/opening sliding door from
the outside: Pull the door handle
outward to release the lock,
slide door front/rear
Closing/opening sliding door
from inside: Pull door handle
downward, open/close the door
by sliding toward the front/rear
Tip: Make sure fuel lid is closed
before opening left side sliding
door, fuel lid cannot be opened
with left siding door open
*Denotes optional equipment
SEATS
Always check the Owner’s Manual for more operating information and safety features
Seats
Child-safety
Seats
Child-safety seat
To install in 2nd row outboard
seats: Use dual locking mode
retractor seat belts; see Owner’s
Manual for proper installation
and child seat tether and LATCH
system instructionsWARNING: Read all
informationand warnings
in Owner’sManual and
attached to seat before
using child-safety seat
Safety belt emergency
locking mode
Belts lockonly on hard acceleration,
braking, cornering or impacts of
about 5 mph or moreAutomatic locking mode
(front passenger and all
rear safety belts only)
Must be used when installing
child-safety seat
To activate: Pull belt fully out of
retractor, allow belt to retract until
click is heard; belt will only tighten
To disengage: Unbuckle belt and
allow belt to retract fullyWARNING: Make sure all seats
are properly latched, because
during a sudden stop or
collision the seat or seatback
could move, causing injury
Third-row seatInsert seat belts in retainers;
remove head restraints; pull strap
(1), push seatback toward front of
vehicle until it locks with a click
Pull strap (2); release the lock of
front seat legs
Pull strap (3); lift seatback and
seat bottom up to vertical; gently
lower the seat into seat well123
