2006 MAZDA MODEL 6 SPORTS SEDAN check engine light

INSTRUMENT CLUSTER
Always check the Owner’s Manual for more operating information and safety features
Instrument
Cluster
Instrument
Cluster
HF
E C
P
R
N
D
M
2
1111113121410
0 123x1000r/min
4
5
6
7
8
19202221232518245
7
98
3
15
17
16
0 20mph
km/h4060
80
100
120
140
TRIPA8
O.O
20 406080100120
140
160
180
200
220
240
64
2
21. Engine oil pressure
warning light
22. Air bag readiness
Front, side and/or curtain air
bag malfunction; warning
light constantly flashes or
stays on or never comes on
with ignition on, dealer
inspection required
23. Door ajar
24. Immobilizer system on,
see Locks
25. Always fasten
safety belts
7. Engine coolant
temperature gauge
If above normal range, stop
vehicle and turn off engine,
check coolant level when safe
14. Traction Control
System,
Light flashes when in use;
dealer inspection required if
light remains on
15. Lights on**
16. Traction Control
System off,
System turned off manually
or malfunctioning; dealer
inspection required
17. Low fuel
18. Brake system
Parking brake on/low fluid level
19. Check engine
Dealer inspection required
20. Charging system
warning light
Dealer inspection required6. Odometer/tripmeter
selector
Press to select among trip A,
trip B, and odometer
Press and hold to reset selected
trip meter
WARNING LIGHTS
8. Cruise control,see Getting Started
9. Cruise Control
Main Power On,
see Getting Started
10. Anti-lock Brake
System (ABS)
ABS malfunction, normal brakes
only, dealer inspection required
11. Turn signals/hazard
warning on
12. Automatic transaxle
indicator
Dealer inspection required
if light remains on
13. High beams on
CRUISE
MAIN
CRUISE
GAUGES
1. Tachometer
2. Speedometer
3. Fuel gauge
4. Odometer/tripmeter
5. Gear indicator*
Displays current gear of
Sport AT
*Denotes optional equipment
**If equipped with black-out meter

HOMELINK®
Always check the Owner’s Manual for more operating information and safety features
HomeLink®
Driving
Tips
Auto-dimming rear
view mirror*
Auto-dimming function changes
are based on outside lighting
conditions and if bright headlights
are visible in rear view mirror
Press on (2), off (3)
ABS self test
A self-diagnostic test is performed
when starting; you may feel some
brake pedal pulsation and hear
some noise, this is normal
Traction Control System (TCS)
Enhances traction and safety by
regulating engine torque
When TCS detects drive wheel
slippage it lowers engine torque
to prevent loss of traction Rolling code synchronization
procedure
Refer to your garage door opener or
device instruction manual to confirm
your system is equipped with a
rolling code feature
Tip: This procedure is easier
to perform with the assistance
of another person
To synchronize: Press programming
button on garage door opener
motor; press/hold for 2 seconds
and release the programmed
HomeLink
®button 2 times
within 30 seconds of pressing
the garage door opening
motor programming button
Some devices may require you
to press/hold and release a
third time to complete
programming procedure
If indicator light stays on,
programming is complete
To erase all existing programming;
press and hold two outer
HomeLink
®buttons (1) on mirror,
continue to hold buttons until
indicator light flashes
Anti-lock Braking System (ABS)
ABS automatically reduces
hydraulic pressure to any wheel
on the verge of locking up
You may feel a slight pulsing of
the brake pedal and hear a
clicking noise; this tells you the
ABS is functioning properly;
increase pressure on pedal for
maximum braking
Tips: Maintain constant
pressure on the brake pedal
Do not pump the brakes
To program or reprogram:
Press and hold two outer
HomeLink
®buttons (1) for 20
seconds and no more than
30 seconds, release only after
indicator light (4) begins to
flash; hold transmitter for the
device to be programmed
between 1-3 inches to
HomeLink
®; press transmitter
button and desired HomeLink®
button (1) simultaneously until
HomeLink®indicator light (4)
goes from slow to rapid flashing
Verify device operation by
pressing HomeLink
®button (1)
that was just programmed
Tip: You do not need to repeat
the first step to program the
other two hand-held transmit-
ters for the remaining
HomeLink® buttons
For further information, contact
HomeLink
®at 1-800-355-3515,
www.homelink.comor your
authorized Mazda Dealer
Gas cap
After filling vehicle with gasoline,
fully reinstall gas cap by turning
clockwise until a clicking sound is
heard, if gas cap is not fully
installed, Check Engine light
may come on
For more information on Check
Engine light, see Owner’s Manual HomeLink
®Wireless
Control System*
Located on rear view mirror
HomeLink
®provides three
programmable buttons that
will replace three hand-held
device transmitters
Tip: It is recommended to
park outside of garage when
programming HomeLink
®
WARNING: When programming
a garage door or gate opener,
disconnect power to these
devices before programming,
continuous operation of these
devices could damage the motor
*Denotes optional equipment
11423

UNDER HOOD
Always check the Owner’s Manual for more operating information and safety features
Under Hood
1. Engine oil filler cap
SAE 5W-20
2. Automatic transmission
fluid (ATF) dipstick*
See Owner’s Manual
3 . Brake/Clutch* fluid reservoir
Fill to MAX mark with DOT 3
fluid; check with cap on
4. Battery
5. Fuse block
6. Air filter
7. Hood support rod
8. Hood latch
Push hood latch to the right,
open hood
9. Engine coolant reservoir
Level should be between FULL
and LOW markings when cold
WARNING: Never remove
coolant reserve tank cap
while engine is running or
hot; you could get burned
10. Engine oil dipstick
Check with engine off after
approximately 5 minutes and
at operating temperature; fluid
level should be between MAX
and MIN markings on dipstick
11. Power steering fluid
reservoir
Check with engine off and at
normal temperature; fill to
MAX mark
12. Windshield washer
reservoir
Fill with windshield washer fluid
Break-in period
First 600 miles: Drive at varying
road and engine speeds; avoid
full throttle, rapid acceleration
or kick-down of transmission
Unique driving conditions
†Every 5,000 miles change
oil/filter, inspect coolant level,
lights, brake/clutch fluid, tire
pressure/wear, power steering
fluid, locks/hinges and washer fluid
Normal maintenance notes
Rotate tires every 7,500 miles or
sooner if needed
Replace cabin air filter every
25,000 miles or 24 months
Inspect exhaust system and heat
shields every 45,000 miles
Replace (FL22)* engine coolant
every 120,000 miles or 10 years
A.Change: Engine oil/
replace filter
Lube: Locks and hinges
B.Inspect: Disc brakes
C.Inspect: Drive belts (3.0 liter),
fuel lines and hoses, brake
lines, hoses and connections,
steering operation and linkages,
front and rear suspension ball
joints, driveshaft dust boots,
cooling system
D.Inspect: Drive belts (2.3 liter)
Replace: Air filter
E.Inspect: Hoses and tubes for
emission system
F. Replace: Spark plugs
Inspect: Engine valve clearance
(2.3 liter), adjust if noisy
G. Replace: Engine coolant
(Other than FL22)
3.0-liter V62.3-liter I4
*Denotes optional equipment†See Owner’s Manual
1197126
5143
810
101179126
51243
8
7,500 miles
15,000 miles
22,500 miles
30,000 miles
37,500 miles
45,000 miles
52,500 miles
60,000 miles
67,500 miles
75,000 miles
82,500 miles
90,000 miles
A A A
F A A
B C E A A
A D
A
BC A
A B
A
105,000 miles G