2006 MAZDA MODEL 6 engine

[x] Cancel search: engine

Page 150 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (150,1)
NOTE
If the vehicle is driven at a low speed
from a standing start while in M2, the
gear will not shift down to M1
automatically until the shift lever is
tapped back (
) or forward

Page 151 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (151,1)
Recommendations for shifting
Upshifting
For normal acceleration and cruising, we recommend
these shift points.
(2.3-liter engine model)
Gear Vehicle speed
M1 to M2 24 km/h (15 mph)

Page 152 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (152,1)
Power Steering
Power steering is only operable when the
engine is running. If the engine is off or if
the power steering system is inoperable,
you can still steer, but it requires

Page 156 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (156,1)
lPress the CANCEL button.
The system is off when the ignition is off.
NOTE
Cruise control will cancel at about 15
km/h (9 mph) below the preset speed or
below 30 km/h (19 mph).
Tra

Page 157 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (157,1)
qTCS Indicator Light
This indicator light stays on for a few
seconds when the ignition switch is turned
to the ON position. If the TCS is
operating, the indicator light flashes.
If

Page 158 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (158,1)
NOTE
lWhen TCS is on and you attempt to
free the vehicle when it is stuck, or
drive it out of freshly fallen snow,
the TCS will activate. Depressing the
accelerator will not increa

Page 159 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (159,1)
Meters and Gauges
(Black-out meter)
When the ignition switch is in the ON position, the dashboard gauges illuminate.
Speedometer ...................................................

Page 161 of 390

MAZDA MODEL 6 2006  Owners Manual (in English) Black plate (161,1)
The trip meter records the total distance
the vehicle is driven until the meter is
again reset. Return it to“0.0”by holding
the selector depressed for more than 1
second. Use t