2006 Lexus GS430 engine

TOUCH SCREEN
221
Initial screen
G18001
When you select the engine switch in “ACC” or “IG −ON” mode,
the initial screen appears and the system begins operating.
After a few seconds, the initial screen disappears.
CAUTION
When the vehicle is stopped with the engine running,
always apply the parking brake for safety.
Touch switch operation
This system is operated mainly by the switches on the screen.
To prevent damage to the screen, lightly touch switches on the
screen with your finger. When you touch a switch on the
screen, a beep sounds.
Do not use objects other than your finger to touch the screen.
INFORMATION
 If the system does not respond to a touch of a switch,
move your finger away from the screen and then
touch it again.
 You cannot operate dimmed switches.
 Wipe off fingerprints on the surface of the display
using a glass cleaning cloth.
 The displayed image may become darker and moving
images may be slightly distorted when the display is
cold.
 When you look at the screen through polarized
material such as polarized sunglasses, the screen
may be dark and hard to see. If so, change the angle
of the screen or take off your sunglasses.

TOUCH SCREEN
223
G18003
Consumption
The consumption is calculated and displayed based on
the driving distance and the fuel consumption for 2
seconds with engine running.
The value is updated every 0.5 seconds.
If you are driving at low speeds just before stopping, the
accurate figure may not be shown.
After Refueling
The consumption after refueling is calculated and
displayed based on the total driving distance and the total
fuel consumption after refueling.
The value is updated every 10 seconds.
When refueling, be sure to stop your vehicle and turn the
engine switch off. Cruising Range
How far you can drive with the remaining fuel is
displayed.
Even though the display indicates sufficient miles to run, if the
fuel level on the fuel gauge approaches “E” or the low fuel level
warning light comes on, fill the fuel tank as soon as possible.
INFORMATION
 When you first start driving your new vehicle, the
correct cruising range may not be shown. One or
more refills of 10 gallons or more may be required for
the system to set its calibration.
 The cruising range displayed is calculated based on
past fuel consumption and may vary according to
your driving style and road condition.

TOUCH SCREEN
224Average Speed
The Average Speed is displayed. The average vehicle
speed is calculated and displayed based on the total
driving
distance and the total driving time after the engine
is started.
The displayed value is updated every 10 seconds.
To calculate from the beginning, touch the “Reset” switch.
Distance
The distance after engine starting is displayed.
When refueling, be sure to stop your vehicle and turn the
engine switch off.
Handsfree system
Handsfree system allows you to make or receive a call
without taking your hands off the steering wheel by
connecting your cellular phone.
This system supports the Bluetooth. Bluetooth is a wireless
data system by which you can call without your cellular phone
connecting with a cable or placing on a cradle.
If your cellular phone does not support the Bluetooth, this
system can not function.
CAUTION
While you are driving, do not use a cellular phone or
connect the Bluetooth phone.
NOTICE
Do not leave your cellular phone in the vehicle. The
temperature indoor may be high and damage the phone.

TOUCH SCREEN
232
G18012
Although you can register up to 4 Bluetooth phones in the
system, one Bluetooth phone can only function.
To connect the Bluetooth phone
G18013
When you select the engine switch in “ACC” or “IGON”
mode, the selected Bluetooth phone will be automatically
connected and the connection result is displayed.
Always leave the Bluetooth phone in a condition where
connection can be established.
This screen appears when the Bluetooth phone is first
connected after you select the engine switch in “ACC” or
“IG−ON”.

TOUCH SCREEN
233

To reconnect the Bluetooth phone
If the Bluetooth phone is disconnected with a poor
reception from the Bluetooth network when the engine
switch is selected in “ACC” or “IGON” mode, the system
automatically reconnects the Bluetooth phone. In this
case, the connection result is not displayed.
If the Bluetooth is disconnected on purpose such as you turned
your cellular phone off, this does not happen. Reconnect it by
the following methods.
 Select the Bluetooth phone again.
 Enter the Bluetooth phone. 
To confirm the Bluetooth information
You can confirm or change the detailed setting of the
Bluetooth phone.
G18009
Touch the “Settings” switch of Bluetooth to display
“Bluetooth Information” screen.

TOUCH SCREEN
246To change the phone book—
The system has two phone books. You can select either
phone book.
G18009
Touch the “Phone Book 1” or “Phone Book 2” switch.
To transfer the telephone number—
You can
transfer the telephone numbers in your Bluetooth
phone to the system. Up to 500 numbers can be registered
in one phone book.
Transfer it while the engine is running.
G18009
1. Touch the “Start Transfer” switch to display “Data
Transfer” screen.

TOUCH SCREEN
256
G18037
Depending on the position of the headlight switch, the
screen changes to either day mode or night mode.
To display the screen in the day mode even with the headlight
switch on, touch “DAY MODE” on the adjustment screen for
brightness and contrast control.
However, if the instrument panel light control switch is turned
fully to the right, mode switching cannot be done. It remains in
the day mode. In this case, “DAY MODE” is not shown on the
screen.
If the screen is set in the day mode with the headlight switch
turned on, this condition is memorized in the system even with
the engine turned off.
G18038
Color and tone adjustment
You can adjust the color and the tone while the DVD video and
video CD are being played.
COLOR “RED”: Strengthens the red color of the screen.
COLOR “GREEN”: Strengthens the green color of the screen.
TONE “+”: Strengthens the tone of the screen.
TONE “–”: Weakens the tone of the screen.

AIR CONDITIONING
259
1 Driver side temperature display (in degrees
Fahrenheit or Centigrade)
2 Passenger side temperature display (in degrees
Fahrenheit or Centigrade)
3 “DUAL” (temperature setting mode change) switch
4 “A/C” switch
5 Air flow control switches
6 Fan speed control switches
7 Air conditioning operation screen display button
8 “TEMP” (driver side temperature control) buttons
(At the independent mode that display shows
“DUAL”; mainly for driver and secondarily for front
passenger)
(At the linked mode that display does not show
“DUAL”; for driver)
9 “OFF” button
10 “AUTO” button
11 Micro dust and pollen filter button
12 Windshield air flow button
13 Air intake control button
14 “PASSENGER TEMP” (passenger side temperature
control) buttons
(Only for the independent mode that display shows
“DUAL”; mainly for front passenger and
secondarily for driver)
The automatic air conditioning automatically maintains
the set temperature.
In the automatic operation mode, the air conditioning selects
the most suitable fan speed, air flow, air intake and on −off of
the air conditioning according to the temperature.
The engine switch must be selected in “IG −ON” mode.
“CLIMATE”: Push this button to display switches for
automatic air conditioning control.
NOTICE
To prevent the battery from being discharged, do not
leave the air conditioning on longer than necessary
when the engine is not running.