Page 116 of 622
GAUGES, METERS AND SERVICE REMINDER INDICATORS
95
Pre Collision System Warning
G13031
If the pre collision system is malfunctioning, the
pre collision system warning light and master warning
light comes on, a warning tone sounds and the above
message appears.
If the above message appears, the pre− collision system may
not operate. Contact your Lexus dealer as soon as possible.
G13030
In the following conditions, the pre collision system
warning light blinks, the master warning light comes on,
a warning tone sounds, and the above message appears.
The millimeter wave radar sensor or the grille cover is
dirty.
Clean the grille or sensor with a soft cloth to remove the dirt.
The pre collision seat belts are activated repeatedly for
a short time.
The system turns of f temporarily for overheating protection. The above conditions do not indicate a malfunction. If the
problem is removed, the warning lights and message go out
and the system returns to normal.
Page 117 of 622
GAUGES, METERS AND SERVICE REMINDER INDICATORS
96
INSTRUMENT PANEL LIGHTCONTROL
The brightness of the instrument panel lights is
automatically adjusted at the maximum when the engine
switch is turned on.
Using the light control switch, you can also adjust the
brightness as you like. Perform the following operation.
Instrument panel control switches are located in the switch
box.
G13005
Light control switch
Push the button to use the switch box. And push the light
control switch upward to increase brightness and
downward to decrease it. However, if the brightness is automatically adjusted at the
maximum, pushing the switch cannot change the brightness.
And this switch cannot adjust the brightness of the outside
temperature
display and clock on the instrument panel as well
as the touch screen.
Pushing the “MAX” switch will turn the brightness of all
indicators on the instrument panel at the maximum. The
intensity of the instrument panel lights will not be reduced when
the headlight switch is on with the brightness adjusted at the
maximum using the “MAX” switch.
When the light control switch is turned to minimum, the foot
lights and inside door handle lights will turn off.
After operation, be sure to close the switch box to its original
position.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop, keep the switch box closed when not in
use while driving.
Page 178 of 622
OCCUPANT RESTRAINT SYSTEMS
157
16G017
This indicator comes on when the engine switch is
selected in “IG ON” mode. It goes off after about 6
seconds. This means the seat belt pretensioners are
operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
occupant detection sensor, front passenger’s seat belt buckle
switch, seat belt pretensioner assemblies, inflators, warning
light, interconnecting wiring and power sources. (For details,
see “Service reminder indicators and warning buzzers” on
page 72.)If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
When the engine switch is selected in “IG−ON” mode, the
light does not come on or remains on for more than 6
seconds.
The light comes on while driving.
If any seat belt does not retract or cannot be pulled out due
to a malfunction or activation of the relevant seat belt
pretensioner.
The seat belt pretensioner assembly or surrounding area
has been damaged.
Page 187 of 622
OCCUPANT RESTRAINT SYSTEMS
166
16G017
This indicator comes on when the engine switch is
selected in “IG ON” mode. It goes off after about 6
seconds. This means the SRS front airbags are operating
properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
occupant detection sensor, front passenger’s seat belt buckle
switch, seat belt pretensioner assemblies, inflators, warning
light, interconnecting wiring and power sources. (For details,
see “Service reminder indicators and warning buzzers” on
page 72.)If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
When the engine switch is selected in “IG−ON” mode, the
light does not come on or remains on for more than 6
seconds.
The light comes on while driving.
Page 197 of 622
OCCUPANT RESTRAINT SYSTEMS
176
16G017
The indicator comes on when the engine switch is
selected in “IG ON” mode. It goes off after about 6
seconds. This means the SRS side airbags and curtain
shield airbags are operating properly.
This warning light system monitors the airbag sensor
assembly, front airbag sensors, side and curtain shield airbag
sensor assemblies, curtain shield airbag sensor assemblies,
driver’s seat position sensor, driver’s seat belt buckle switch,
occupant detection sensor, front passenger’s seat belt buckle
switch, seat belt pretensioner assemblies, inflators, warning
light, interconnecting wiring and power sources. (For details,
see “Service reminder indicators and warning buzzers” on
page 72.)If any of the following conditions occurs, this indicates a
malfunction of the airbags or seat belt pretensioners. Contact
your Lexus dealer as soon as possible.
When the engine switch is selected in “IG−ON” mode, the
light does not come on or remains on for more than 6
seconds.
The light comes on while driving.
Page 244 of 622
TOUCH SCREEN
223
G18006
1Indicates a condition of Bluetooth connection.
“Blue” indicates excellent condition of Bluetooth connection.
“Yellow” indicates the condition easy to disconnect the
Bluetooth, causing a deterioration in voice.
Not displayed: no connection to the Bluetooth.
2 Indicates the receiving area.
“Rm” is displayed when receiving in Roaming area.
“Hm” is displayed when receiving in Home area.
3
Indicates the level of reception.
Too bad Excellent
The level of reception does not always correspond with the one
of your cellular phone.
4 “A” is displayed when calling in analogue.
“D” is displayed when calling in digital.
Nothing is displayed when the system can get no information
from your cellular phone.
INFORMATION
This system supports the following service.
HFP (Hands Free Profile) Ver. 1.0
OPP (Object Push Profile) Ver. 1.1
If your cellular phone does not support HFP, you cannot
enter the Bluetooth phone, and take OPP service indi-
vidually.
Page 261 of 622
TOUCH SCREEN
240
G18025
Touch the desired number to input the key.
To hang up the phone:Touch “
” or push of the telephone button.
This cannot be operated while you are driving.
G18026
If the continuous tone signal is registered in a phone
book, this screen appears. (If not registered, “Send” and
“Exit” is not displayed.)
Confirm the number displayed on the screen and touch
“Send” switch. The number to the marked sign will be
sent.
When you touch “Exit”, this function will be finished and normal
tone screen appears.
To hang up the phone:
Touch “
” or push of the telephone button.
The continuous tone signal is the marked sign (p or w) and the
number following tel ephone number. (ex. 056133p0123w#1
)
When you call the number registered in phone book and input
a code number and the like to operate an answering machine
or use a telephone service in bank, you can do this operation.
Page 310 of 622
AUDIO
289
Radio operation (XM satellite radio broadcast)
To listen to a satellite radio broadcast in your vehicle, an
additional genuine Lexus satellite receiver and antenna must
be purchased and installed, and the subscription to the XM
satellite radio is necessary.
(a) How to subscribe to an XM satellite radio
An XM satellite radio is a tuner designed exclusively to receive
broadcasts provided under a separate subscription.
Availability is limited to the 48 contiguous states.
How to subscribe:
You must enter into a separate service agreement with the XM
radio in order to receive satellite broadcast programming in the
vehicle. Additional activation and service subscription fees
apply that are not included in the purchase price of the vehicle
and optional digital satellite tuner. For complete information on
subscription rates and terms, or to subscribe to the XM radio,
visit XM on the web at www.xmradio.com
or call an XM’s
Listener Care at (800) 852 −9696. The XM radio is solely
responsible for the quality, availability and content of the
satellite radio services provided, which are subject to the terms
and conditions of the XM radio customer service agreement. Customers should have their radio ID ready; the radio ID can
be found by selecting the “channel 000” on the radio. For
details, see the “Displaying the radio ID” that follows.
All fees and programming are the responsibility of the XM
satellite radio and are subject to change.
Satellite tuner technology notice:
Lexus satellite radio tuners are awarded Type Approval
Certificates
from XM Satellite Radio Inc. on “October 14, 2004”
as proof of compatibility with the services offered by the XM
satellite radio.
(b) Displaying the radio ID
Each XM tuner is identified with a unique radio ID. You will
need the radio ID when activating XM service or when
reporting a problem.
If you select the “CH 000” using the “TUNE” knob, the ID code
of 8 alphanumeric characters appears. If you select another
channel, display of the ID code is canceled. The channel (000)
alternates the display between the radio ID and the specific
radio ID code.
