2006 Lexus GS430 emergency towing

IN CASE OF AN EMERGENCY
487
Before towing, release the
parking brake and put the
transmission in ”N”. The engine switch must be selected in
“ACC” or “IG −ON” mode.
CAUTION
If the engine is not running, the power assist for the
brakes and steering will not work so steering and
braking will be much harder than usual.
Emergency towing eyelet precautions:
 Before emergency towing, check that the eyelet is not
broken or damaged and that the installation bolts are not
loose.
 Fasten the towing cable or chain securely to the eyelet.
 Do not jerk the eyelet. Apply steady and even force.
 To avoid damaging the eyelet, do not pull from the side or
at a vertical angle. Always pull straight ahead.
CAUTION
If the emergency towing eyelet is used to get out when
your vehicle becomes stuck in the mud, sand or other
condition from which the vehicle cannot be driven out
under its own power, make sure to observe the
precautions mentioned below. Otherwise, excessive
stress will be put on the eyelet and the towing cable or
chain may break, causing serious injury or damage.
If the towing vehicle can hardly move, do not forcibly
continue the towing. Contact your Lexus dealer or a
commercial tow truck service for assistance.
 Tow the vehicle as straight ahead as possible.
 Keep away from the vehicle during towing.

IN CASE OF AN EMERGENCY
488Tips for towing a stuck vehicle:
The following methods are effective to use when your
vehicle is stuck in the mud, sand or other condition from
which the vehicle cannot be driven out under its own
power. Use extreme caution when towing the vehicle. In
addition, keep away from the vehicles and towing cable or
chain when towing.

Remove the sand and soil in the front and the back of the
tires.
 Place stones or wood under the tires.
(e) Installing towing eyelet
G40020
1. Remove the front towing eyelet cover on the front bumper
by using a flathead screwdriver. To protect the bodywork,
place a piece of rag over the cover.
G40021
2. Use the towing eyelet in the trunk. Secure it to the hole on
the bumper by turning clockwise. (For the eyelet location, see
page 474.)

IN CASE OF AN EMERGENCY
489
G40022
3. Tighten the towing eyelet securely by a wheel nut wrench.
CAUTION
When installing the eyelet on the vehicle, be sure to
tighten the eyelet securely. If the eyelet is loose, it may
come off when being towed and result in death or
serious injury.
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION SELECTOR LEVER
G40001
If you cannot shift the selector lever, use the shift lock
override button as follows:
1Turn the engine switch off. Make sure the parking brake
is applied. Pry up the cover with a flathead screwdriver
or equivalent.