STARTING AND DRIVING
377 NOTE:
* The detection range can be changed from about 50 cm
(1.5 ft.) for dual sensors and about 60 cm (2 ft.) for back
sensors.
Ask your Lexus dealer for details.
The intuitive parking assist may not work properly in the
following cases:
When the bumper is damaged.
When the part near the sensors is subjected to a strong
impact.
When an accessory is installed within the sensor detection
range.
When snowflakes or mud gets on the sensors.
(If removed, the system will work properly.)
When water is splashed from a high pressure car wash or
steam on the sensors.
When a sensor is covered with your hand.
When the vehicle is tilted.
In extreme hot or cold weather
(In extreme cold weather, the error display appears and the
system becomes inoperative.)
When driving on bumpy roads, slopes, gravelled roads or
grass.Devices issuing ultrasonic waves are operated around your
vehicle, such as a horn from another vehicle, motorcycle
engine, air braking sound from heavy−duty vehicles.
When another vehicle equipped with ultrasonic sensors
gets close to your vehicle.
When heavy rain or water is splashed over the vehicle.
(Drive carefully as the braking distance may be affected.)
When a radio antenna or fender pole is mounted on your
vehicle.
If towing eyelet is installed on your vehicle.
When you are driving towards a tall curb stone or curb stone
having right angle.
The detection range for an object such as a traffic sign may
be shortened.
An object just under the bumper cannot be detected.
Although an object lower than the location of sensors is
once detected, the detection might be stopped when your
vehicle gets closer to the object.
When an obstacle is very close to the sensors.
STARTING AND DRIVING
438Although the tires are equipped with tire pressure sensors,
the selector switch (see page 442) is set to other tire setting.
NOTICE
The use of non−genuine wheels will cause the tire
pressure sensors to transmit the electronic code in
different manner, resulting in the failure of the
system.
The use of tires other than originally installed with
genuine wheels may also cause the malfunction of
the system.
For vehicles sold in U.S.A.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
NOTICE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
