2006 KIA SPECTRA5 door lock

311
1
2
3
4
5
6
7
8
9
Knowing your vehicle
With central door lock switch
(if equipped)
It is operated by depressing the door
lock switch. If any door is open when
the switch is depressed, the door will
remain locked when closed. When pushing down on the front
portion (
➀) of the central door lock
switch, all vehicle doors will lock.
 When pushing down on the rear portion (
➁) of the switch, all vehicle
doors will unlock.
 However, if the key is in the ignition switch and any front door is open,
the doors will not lock when the
front portion of central door lock
switch is pressed.
CAUTION
 The doors should always befully closed and locked while
the vehicle is in motion to pre-
vent accidental opening of the
door. Locked doors will also
discourage potential intruders
when the vehicle stops or
slows.
 Be careful when opening doors and watch for vehicles,
motorcycles, bicycles or
pedestrians approaching the
vehicle in the path of the door.
Opening a door when some-
thing is approaching can
cause damage or injury.
1LDA20071LDN2007
Driver’s doorPassenger’s door (if equipped)
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 11

Knowing your vehicle12
3
1
2
3
4
5
6
7
8
9
Rear door child safety lockThe child safety lock is provided to
help prevent children from acciden-
tally opening the rear doors from
inside the vehicle. The rear door
safety locks should be used whenev-
er children are in the vehicle.
1LDA2008
WARNING
Leaving your vehicle unlocked
can invite theft or possible harm
to you or others from someone
hiding in your vehicle while you
are gone. Always remove the
ignition key, engage the parking
brake, close all windows and
lock all doors when leaving your
vehicle unattended.
WARNING
- Unattended
children
An enclosed vehicle can
become extremely hot, causing
death or severe injury to unat-
tended children or animals who
cannot escape the vehicle.
Furthermore, children might
operate features of the vehicle
that could injure them, or they
could encounter other harm,
possibly from someone gaining
entry to the vehicle. Never leave
children or animals unattended
in your vehicle.
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 12

313
1
2
3
4
5
6
7
8
9
Knowing your vehicle
1. Open the rear door.
2. Push the child safety lock locatedon the rear edge of the door to the
“lock” position. When the child
safety lock is in the “lock ( )”
position, rear door will not open
when the inner door handle is
pulled inside the vehicle.
3. Close the rear door.
4. To open the rear door, pull the out- side door handle.
Even though the doors may be
unlocked, the rear door will not open
by pulling the inner door handle (
➀),
until rear door child safety lock is
unlocked ( ).
Rear hatch (if equipped)Opening the rear hatch
 Rear hatch is locked or unlocked with a key.
 To open the rear hatch, insert the key into the lock (
➀), turn it to the
unlock position (
➁), and pull up the
rear hatch by pressing the handle
(
➂).
 You can also lock/unlock the latch (but not release it) with the central
door lock system (if equipped).
 If unlocked, the rear hatch can be opened by pressing the handle (
➂)
and pulling the hatch up.
WARNING
- Rear door
locks
If children accidentally open the
rear doors while the vehicle is in
motion, they could fall out and
be severely injured or killed. To
prevent children from opening
the rear doors from the inside,
the rear door safety locks
should be used whenever chil-
dren are in the vehicle.
1LDN3205
Lock
Unlock
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 13

Knowing your vehicle14
3
1
2
3
4
5
6
7
8
9
Power windows (if equipped)➀ Driver’s door power window switch
➁ Front passenger’s door power win-
dow switch
➂ Rear door (left) power window
switch
➃ Rear door (right) power window
switch
➄ Window opening and closing
(see page 3-15)
\b Automatic power window down
(Driver’s window, if equipped)
➆ Power window lock switch
(see page 3-15)
 Power window timer (if equipped)
The power windows can be operat-
ed for approximately 30 seconds
after the ignition key is removed or
turn to the ACC or LOCK position.
However, if the front doors are
opened, the power windows can-
not be operated even within the 30
seconds after the ignition key
removal.
WINDOWS
1LDA2010
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 14

315
1
2
3
4
5
6
7
8
9
Knowing your vehicle
Window opening and closing
The driver’s door has a master power
window switch that controls all the
windows in the vehicle. To open or
close a window, press down (
➄) or
pull up (
➄) the front portion of the
corresponding switch. Automatic power window down
(driver’s window, if equipped)
Depressing the power window switch
momentarily to the second detent
position (
\b) completely lowers the
driver’s window even when the
switch is released. To stop the win-
dow at the desired position while the
window is in operation, pull up the
switch momentarily to the opposite
direction of the window movement.
If the battery has been discharged
or disconnected, the automatic
power window system must be reset
as follows:
1. Turn the ignition key to ON posi- tion.
2. Close each window and continue pulling up on each power window
switch for at least 0.5 second after
the window is completely closed. Power window lock switch
 The driver can disable the power
window switches on a passenger
door by depressing the power win-
dow lock switch located on the dri-
ver’s door to LOCK (pressed).
 When the power window lock switch is ON, the driver’s master
control cannot operate the passen-
ger door power windows either.
1LDA20121LDA2011
1LDA2013
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 15

Knowing your vehicle16
3
1
2
3
4
5
6
7
8
9
Power windows (if equipped)
The ignition switch must be in the ON
position for power windows to oper-
ate. Each door has a power window
switch that controls that door’s win-
dow. However, the driver has a power
window lock switch which can block
the operation of passenger windows.
If you notice buffeting and pulsation
(wind shock) with either side window
open, you should open the opposite
window slightly to reduce the condi-
tion.✽ ✽
NOTICETo prevent the power window sys-
tem from the possibility of damage,
do not open or close two windows at
the same time. This will also ensure
the longevity of the fuse.
Manual windows (if equipped)Use the window crank to open and
close each window.
CAUTION
 Make sure heads and hands
are safely out of the way
before closing a window.
 Do not allow children to play with the power windows. Keep
the driver’s door power win-
dow lock switch in the LOCK
position (depressed). Serious
injury can result from uninten-
tional window operation by
the child.
 Do not extend face or arms outside through the window
opening while driving.
 Always double check to make sure all arms, hands and other
obstructions are safely out of
the way before closing a win-
dow.
3FDA2015
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 16

325
1
2
3
4
5
6
7
8
9
Knowing your vehicle
Removal
To remove the headrest, raise it as
far as it can go then press the
release button (
➀) while pulling
upward (
➁).
Rear seat Split folding rear seat (if equipped)
The rear seatbacks fold forward to
provide additional cargo space and
to provide access to the cargo area.
 To fold the rear seatback(s) down, pull the lock release lever, then fold
the seatback forward and down.
 To raise the seatback, lift and push it firmly until it clicks into place.
 When you return the seatback to its upright position, reposition the
rear safety belts so that they can
be used by rear seat passengers.
4 Door (if equipped)
1. Pull the lock release lever.
2. Move the rear center three-pointseat belts (if equipped) to the out-
side (
➀) so that they don’t interfere
with the seatback when lowering.
3. Fold the seatback forward and down firmly (
➁).
1LDA2034A
WARNING
To reduce the risk of head and
neck injuries, do not drive the
vehicle with the headrest
removed or improperly posi-
tioned.
1LDN20381LDN3025
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 25

Knowing your vehicle26
3
1
2
3
4
5
6
7
8
9
5 Door (if equipped)
1. Lift the front of seat cushion (
➀)
up.
2. Lift the rear of seat cushion up (
➁). 3. Move the seat cushion firmly until
it clicks (
➂).
4. Remove the headrest and put the headrest poles into the holes on
the rear of the seat cushion (
➃). 5. Pull the lock release lever (
➄).
6. Fold the seatback forward and down firmly (
\b).
1LDA2239/1LDA2239A
1LDA2240
1LDA22431LDA2244
1LDA22411LDA2242
Type A
Type B
LD CAN (ENG) new 3-1~.qxd 7/29/05 10:28 AM Page 26