Page 137 of 225
5-1
DRIVING TIPSFuel Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-2
Emission Control System . . . . . . . . . . . . . . . . . . . . . . . .5-3
Before Driving . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-4
Suggestions for Economical Operation . . . . . . . . . . . .5-5
Special Driving Conditions . . . . . . . . . . . . . . . . . . . . . . .5-7
Trailer Towing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-11
Overloading . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-11
Label Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-11
Homelink® Wireless Control System . . . . . . . . . . . . .5-12
5
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 1
Page 147 of 225
5-11
TRAILER TOWINGWe do not recommend using this vehicle
for trailer towing.OVERLOADINGLABEL INFORMATION
There are several important labels and
identification numbers located on your
vehicle. The label locations are identified
in the following illustrations.VEHICLE INDENTIFICATION
NUMBER (VIN)
Tire Specification/Pressure LabelThis can be found on the driver side door.
MMSA5001
MMSA7019
CAUTION
The gross axle weight rating
(GAWR) and the gross vehicle
weight rating (GVWR) for your
vehicle are on the manufacturer’s
label attached to the driver’s door
or are listed in the “Specifications”
section of this Owner’s Manual.
Exceeding these ratings can cause
an accident or vehicle damage. You
can calculate the weight of your
load by weighing the items (or
people) before putting them in the
vehicle. Be careful not to overload
your vehicle.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 11
Page 152 of 225
6-1
IN CASE OF AN EMERGENCYRoad Warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-2
Overheating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-2
Emergency Starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-3
Electrical Circuit Protection . . . . . . . . . . . . . . . . . . . . . .6-7
Towing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-14
If You Have a Flat Tire . . . . . . . . . . . . . . . . . . . . . . . . . .6-19
Changing tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-22
6
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 1
Page 154 of 225

assistance. If coolant is not boiling
out, allow the engine to idle and open
the hood to permit the engine to cool
gradually. If the temperature does not
go down with the engine idling, stop
the engine and allow sufficient time
for it to cool.
4. The coolant level should then be
checked. If the level in the reservoir
is low, look for leaks at the radiator
hoses and connections, heater hoses
and connections, radiator, and water
pump. If you find a major leak or
another problem that may have
caused the engine to overheat, do not
operate the engine until the problem
has been corrected. Call an
Authorized Kia Dealer for assistance.
If you do not find a leak or other
problem, carefully add coolant to the
reservoir.If the engine frequently overheats, have
the cooling system checked and repaired.
EMERGENCY STARTINGJUMP STARTINGJump starting can be dangerous if done
incorrectly. Therefore, to avoid harm to
yourself or damage to your vehicle or
battery, follow the jump starting
procedures on the next page. If in doubt,
we strongly recommend that you have a
competent technician or towing service
jump start your vehicle.
6-3
WARNING - Removing
Radiator Cap
Do not remove the radiator cap
when the engine and radiator
are hot. Scalding hot coolant
and steam may blow out under
pressure. This could cause
serious injury.
✻
NOTICE
Use only a 12volt jumper system.
You can damage a 12volt starting
motor, ignition system, and other
electrical parts by using a 24-volt
power supply (two 12-volt batteries
in series or a 24-volt motor
generator set).
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 3
Page 165 of 225
TOWINGIf emergency towing is necessary, we
recommend having it done by an
Authorized Kia Dealer or a competent
tow-truck service. Proper lifting and
towing procedures are necessary to
prevent damage to the vehicle. State and
local laws applicable to towing vehicles
must be followed.
IN CASE OF EMERGENCY
6-14
MMSA6007A
Wheel dolly
HORN10A Horn
HEAD LP HI15A Headlights (HI)
HEAD LP WASH20A -
DRL15A DRL
FR FOG15A Front fog lights
DIODE-1- Diode 1
SPARE30A Spare fuse
SPARE20A Spare fuse
SPARE15A Spare fuse
SPARE10A Spare fuse
DIODE-2- Diode 2
BLOWER30A Blower
PWR FUSE-230A Power fuse 2
PWR AMP20A Power amp
SUNROOF15A Sunroof
TAIL LP20A Tail lights
PWR FUSE-130A Power fuse 1
ECU10A ECU
RR HTD30A Rear window defroster
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 14
Page 166 of 225

As a general rule, towed vehicles should
be pulled with the driving wheels off the
ground. If excessive damage or other
conditions prevent towing the vehicle
with the driving wheels off the ground,
use wheel dollies.
With either an automatic or manual
transaxle:
1. Set the ignition switch in the ACC
position;
2. Place the shift lever in N (Neutral);
3. Release the parking brake.
TIE-DOWN HOOKS
(FOR FLATBED TOWING)
6-15
MMSA6008
✻
NOTICE
Do not tow the vehicle backward
with the front wheels on the
ground. This may cause internal
damage to the transaxle.✻
NOTICE
Do not tow with sling-type
equipment. Use wheel lift or flatbed
equipment.
Front
MMSA6009B/MMSA601A
Rear
CAUTION
Do not use the hooks under the
front or rear of the vehicle for
towing purposes. These hooks are
designed ONLY for transport
tiedown. If the tie-dwn hooks are
used for towing, the front/rear
bumper will be damaged and the
vehicle may break free from the
tow vehicle.
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 15
Page 167 of 225

TOWING WITH A VEHICLE
OTHER THAN A TOW TRUCK
If towing is necessary, we recommend
you to have it done by an Authorized Kia
dealer or a commercial tow truck service.
If towing service is not available in an
emergency, your vehicle may be
temporarily towed using a cable or chain
secured to the emergency towing hook.
Use extreme caution when towing the
vehicle.
A driver must be in the vehicle to steer it
and operate the brakes.
Towing in this manner may be done only
on hard-surfaced roads for a short
distance and at low speeds. Also, the
wheels, axles, power train, steering and
brakes must all be in good condition. Do not try to tow your vehicle when
the wheels are stuck in mud, sand or
similar substances that prevent the
vehicle from being driven out under
its own power.
Avoid towing a vehicle heavier than
the vehicle doing the towing.
The drivers of both vehicles should
communicate with each other
frequently.
IN CASE OF EMERGENCY
6-16Front
MMSA6009A/MMSA6010
Rear
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 16
Page 168 of 225

Before emergency towing, check that
the hook is not broken or damaged.
Fasten the towing cable or chain
securely to the hook.
Do not jerk the hook. Apply steady
and even force.
To avoid damaging the hook, do not
pull from the side or at a vertical
angle. Always pull straight ahead. Use a towing strap less than 5 m (16
feet) long. Attach a white or red cloth
(about 30 cm (12 inches) wide) in the
middle of the strap for easy visibility.
Drive carefully so that the towing
strap is not loosened during towing.
6-17
✻
NOTICE
• Attach a towing strap to the tow
hook.
Using a portion of the vehicle
other than the tow hooks for
towing may damage the body of
your vehicle.
Use only a cable or chain
specifically intended for use in
towing vehicles. Securely fasten
the cable or chain to the towing
hook provided.
CAUTION
Use extreme caution when towing
the vehicle.
Avoid sudden starts or erratic
driving maneuvers which would
place excessive stress on the
emergency towing hook and
towing cable or chain. The hook
and towing cable or chain may
break and cause serious injury
or damage.
If the towing vehicle can hardly
move, do not forcibly continue
the towing. Contact an
Authorized Kia dealer or a
commercial tow truck service
for assistance.
Tow the vehicle as straight
ahead as possible.
Keep away from the vehicle
during towing.
MMSA6011
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 17