2006 KIA Optima belt

POWER STEERING Power steering uses energy from the
engine to assist you in steering the
vehicle. If the engine is off or if the
power steering system becomes
inoperative, the vehicle may still be
steered, but it will require increased
steering effort.
Should you notice any change in the
effort required to steer during normal
vehicle operation, have the power
steering system checked by an
Authorized Kia Dealer.
TILT STEERINGA tilt steering wheel allows you to adjust
the steering wheel before you drive. You
can also raise it to the highest level to
give your legs more room when you exit
and enter the vehicle.
To tilt the wheel, hold the steering wheel
and pull the lock release lever.
Move the steering wheel to a comfortable
level.
DRIVING YOUR VEHICLE
4-18
MMSA3051
✻
NOTICE
Never hold the steering wheel
against a stop (extreme right or left
turn) for more than five seconds
with the engine running. Holding
the steering wheel for more than
five seconds in either position may
cause damage to the power steering
pump.
If the power steering drive belt
breaks or if the power steering
pump malfunctions, the steering
effort will become greatly
increased.
MS-CNA-Eng 4(~39).QXD 7/25/2005 5:16 PM Page 18

3. If leaks are found, if the warning
light remains ON, or if the brakes do
not operate properly, do not drive the
vehicle. Have it towed to an
Authorized Kia Dealer for a brake
system inspection and necessary
repairs.
To check bulb operation, the warning
light illuminates when the ignition switch
is in the ON position.
IMMOBILIZER
INDICATOR
(IF EQUIPPED)This light illuminates when the
immobilizer key is inserted and turned to
the ON position to start the engine.
If this light turns off or blinks when the
ignition switch is in the ON position
before starting the engine, have the
system checked by an authorized Kia
Dealer. AIR BAG WARNING This warning light will remain ON for
approximately 6 seconds each time you
turn the ignition switch ON. If the
system does not operate as described or
if the light comes on while the vehicle is
being driven, see an Authorized Kia
Dealer for immediate assistance.
SAFETY BELT WARNINGAs a reminder to the driver and
passenger, safety belt warning light will
blink for approximately 6 seconds each
time you turn the ignition switch ON.
If the driver's lap/shoulder belt is not
fastened when the key is turned ON or if
it is unfastened after the key is turned
ON, the safety belt warning light blinks
for approximately 6 seconds. SAFETY BELT WARNING
CHIME If the driver's seat belt is not fastened
when the ignition key is turned “ON” or
if it is disconnected after the key is ON,
the safety belt warning chime will sound
for approximately 6 seconds.
DRIVING YOUR VEHICLE
4-22
WARNING -
Brake
Warning Lights
Driving the vehicle with a
warning light ON is dangerous.
If the brake warning light
remains ON, have the brakes
checked and repaired
immediately.
AIR
BAG
MS-CNA-Eng 4(~39).QXD 7/25/2005 5:16 PM Page 22

CHARGING SYSTEM
WARNING
(IF EQUIPPED)This warning light indicates a
malfunction of either the generator or
electrical charging system.
If the warning light illuminates while
driving:
1. Drive to the nearest safe location and
carefully stop your vehicle.
2. With the engine OFF, check the
generator drive belt for looseness or
breakage.
3. If the belt is adjusted properly, a
problem exists somewhere in the
electrical charging system. Have an
Authorized Kia Dealer or other
competent locate and correct the
problem as soon as possible.
ENGINE OIL PRESSURE
WARNING This warning light indicates the engine
oil pressure is low.
If the warning light illuminates while
driving:
1. Drive safely to the side of the road
and stop.
2. With the engine OFF, check the
engine oil level. If the level is low,
add oil as required.
If the warning light remains ON after
adding oil or if oil is not available, call
an Authorized Kia Dealer.
LOW FUEL LEVEL
WARNING This warning light indicates the fuel tank
is near empty. The warning light will
come on when the fuel level has dropped
to about 8.5 L (2.2 US gal.).
Refuel as soon as possible.
4-23
✻
NOTICE
Do not drive the vehicle with a
loose or broken generator belt; the
engine could be damaged by over-
heating because this belt also drives
the water pump.
✻
NOTICE
Do not drive the vehicle when the
Engine Oil Warning Light is ON.
If the engine is not stopped as soon
as possible, severe engine damage
could result.
MS-CNA-Eng 4(~39).QXD 7/25/2005 5:16 PM Page 23

5-11
TRAILER TOWINGWe do not recommend using this vehicle
for trailer towing.OVERLOADINGLABEL INFORMATION
There are several important labels and
identification numbers located on your
vehicle. The label locations are identified
in the following illustrations.VEHICLE INDENTIFICATION
NUMBER (VIN)
Tire Specification/Pressure LabelThis can be found on the driver side door.
MMSA5001
MMSA7019
CAUTION
The gross axle weight rating
(GAWR) and the gross vehicle
weight rating (GVWR) for your
vehicle are on the manufacturer’s
label attached to the driver’s door
or are listed in the “Specifications”
section of this Owner’s Manual.
Exceeding these ratings can cause
an accident or vehicle damage. You
can calculate the weight of your
load by weighing the items (or
people) before putting them in the
vehicle. Be careful not to overload
your vehicle.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 11

7-3
MAINTENANCE SCHEDULEEngine Control systemI: Inspect these items and their related parts. If necessary,
Check the engine oil and coolant levels every week.
R: Replace or change.
NOTE :
Check the engine oil and coolant levels every week.
Kilometers or Time in Months, Whichever Comes First
km 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128Months 4 8 12 16 20 24 28 32 36 40 44 48 52 56 60 64
Engine oil & engine oil filter R R R R R R R R R R R R R R R R
Drive belts (tension)III I
Cooling system hoses & connectionsIIII I
Engine coolant II IIIRIIIIIRIIII
Fuel filterR
Fuel tank cap, lines, EVAP canister and hosesII
Fuel tank air filterIRIR I
Air cleaner element II IIIRIIIIIRIIII
MAINTENANCE
INTERVALS
MAINTENANCE
ITEM
x 1,000
(1)
(1)
(2)
(1) Refer to the lubricant and coolant specifications in the Owner’s Manual.
(2) More frequent maintenance is required if driving under dusty conditions.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 3

MAINTENANCE
7-4Engine Control System (cont.)I: Inspect these items and their related parts. If necessary,
correct, clean, refill, adjust or replace.
R: Replace or change.
Kilometers or Time in Months, Whichever Comes First
km 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128
Months 4 8 12 16 20 24 28 32 36 40 44 48 52 56 60 64
Ignition wiresII
Spark plugsR
Idle speedIIII I
Engine timing beltR
MAINTENANCE
INTERVALS
MAINTENANCE
ITEM
x 1,000
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 4

7-7
Chassis and Body(cont.)I : Inspect these items and their related parts. If necessary,
correct, clean, refill, adjust or replace.
L: Lubricate.
Kilometers or Time in Months, Whichever Comes First
km 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128Months 4 8 12 16 20 24 28 32 36 40 44 48 52 56 60 64
P
ower steering fluid & linesIIIIIIIIDriveshaft dust boots
IIIII
Seat belts, buckles & anchors
IIIIIIIIIIIIIIII
Locks, hinges & hood latchLLLLLLLLLLLLLLLL
MAINTENANCE
INTERVALS
MAINTENANCE
ITEM
x 1,000
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 7

7-29
TIRE SIZE DESIGNATIONA tire’s sidewall is marked with a tire
size designation. You will need this
information when selecting replacement
tires for your car. The following explains
what the letters and numbers in the tire
size designation mean.
Example tire size designation :
P205/60R15 82T
P- Applicable vehicle type (tires marked
with the prefix “P” are intended for use
on passenger cars; however, not all tires
have this marking).
205- Tire width in millimeters.
60- Aspect Ratio. The tire’s section
height as a percentage of tire width.
R- Tire construction code (radial).
15- Rim diameter in inches.
82- Load Index: A numerical code
associated with the maximum load the
tire can carry.
T- Speed Rating symbol. See the speed
rating chart in this section for additional
information.
✻
NOTICE
• When replacing tires, never mix
radial, bias-belted, and bias-type
tires. All four tires should be of
the same size, design and
construction. Use only the tire
sizes listed on the Tire Label
attached to the passenger’s door.
Make sure that all tires and
wheels are the same size and
have the same load-carrying
capacity. Use only tire and wheel
combinations recommended on
the Tire Label or by an
Authorized Kia Dealer. Failure
to follow these precautions can
adversely affect the safety and
handling of your vehicle.
• The use of any other tire size or
type may seriously affect ride,
handling, ground clearance, tire
clearance, and speedometer
alibration.
• Driving on worn-out tires is very
hazardous and will reduce
braking effectiveness, steering
accuracy, and raction.
• It is best to replace all four tires
on your vehicle at the same time.
If that is not possible, then
replace the two front or two rear
tires as a pair.
Replacing just one tire can
seriously affect vehicle handling.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 29