2006 KIA Optima air condition

DRIVING YOUR VEHICLE
4-52AIR CONDITIONING
SYSTEM OPERATING
TIPS:• If the vehicle has been parked in
direct sunlight during hot weather,
open the windows for a short time to
let hot air inside the vehicle escape.
• To help reduce moisture on the inside
of windows on rainy, humid days,
decrease the humidity inside the
vehicle by operating the air
conditioning system.
• During air conditioning system
operation, you may occasionally
notice a slight change in engine
speed at idle as the A/C compressor
cycles ON. This is a normal system
operating characteristic.
• Use the air conditioning system every
month if only for a few minutes.
• After air conditioning system use,
you may notice clear water dripping
(or even puddling) on the ground
under the passenger side of the
vehicle. This is a normal system
operating characteristic.• The air conditioning system includes
a function that will automatically turn
the A/C compressor OFF if engine
coolant temperature approaches an
overheating level. A/C compressor
operation will resume once engine
coolant temperature returns to the
“normal” range. Also, the A/C
compressor is automatically turned
off for a few seconds when the
accelerator is fully depressed.
• When operating the air conditioning
system use the outside (fresh) air
position.
• Operating the air conditioning system
in the recirculated air position does
provide maximum cooling, however,
continual operation in this mode may
cause the air inside the vehicle to
become stale.
MS-CNA-Eng 4(40~).QXD 7/25/2005 5:15 PM Page 52

If you don’t want the outside (fresh) air
position when operating in either of these
modes, you can turn off the system
operation by performing the following:
1. Make sure the engine is running or
the ignition switch is in the ON
position.
2. Turn the fan speed control knob to
the “0” position.
3. Turn the mode selection knob to the
defrost ( ) position.
4. Push the air intake control button
( ) at least 5 times within 3
seconds.
5. Then the indicator light on the air
intake control button ( ) will blink
3 times with 0.5 second intervals
between blinks.
If you want to return to the outside
(fresh) air position, repeat the procedure
above.
WINDSHIELD DEFROST-
ING AND DEFOGGING
(AUTOMATIC TYPE)TO DEFOG INSIDE WINDSHIELD1. Select any fan speed except OFF
( ) position.
2. Select desired temperature.
3. Press the defrost button ( ).
4. The air conditioning will be turned
on according to the detected ambient
temperature and outside (fresh) air
position will be selected.
If you don’t want the air conditioning or
outside (fresh) air position press the
corresponding button to cancel the
operation.
TO DEFROST OUTSIDE
WINDSHIELD 1. Set temperature to the extreme hot
(25°C~32°C) position.
2. Set the fan speed to the or
position.
3. Press the defrost button ( ).
4. The air conditioning will be turned
on according to the detected ambient
temperature and outside (fresh) air
position will be selected.
If you don’t want the air conditioning or
outside (fresh) air position press the
corresponding button to cancel the
operation.
• Before driving, clear all snow and ice
from the windshield, rear window,
outside rear view mirrors, and all side
windows.
• Clear all snow and ice from the hood
and the air inlet in the cowl grille to
improve heater and defroster
efficiency and to reduce the
probability of fogging on the inside
of the windshield.
DRIVING YOUR VEHICLE
4-56
A/C
1
2
34
MMSA4055
MS-CNA-Eng 4(40~).QXD 7/25/2005 5:15 PM Page 56

How to cancel forced air condi-
tioning operation and outside
(fresh) air position in floor-
defrost and defrost position ;1. Turn the ignition switch to the “ON”
position.
2. Set the fan speed control knob to the
position.
3. Select the defrost position pressing
defrost button ( ).
4. While holding the air conditioning
button A/C depressed, depress the
recirculated air position button ( )
at least 5 times within 3 seconds.5. The indicator light in the recirculated
air position button ( ) will blink 3
times with 0.5 second interval.
If you want to return to the automatic air
conditioning system and outside (fresh)
air position, repeat the same procedure.
Follow the same procedure if you want
to cancel or return to the forced outside
(fresh) air position when you start the
engine with recirculated air position
selected manually before the engine off.
4-57
A/C
MMSA4057
CAUTION
Do not use defrost position
during cooling operation in
extremely humid weather. The dif-
ference between the temperature of
the outside air and that of the
windshield could cause the outer
surface of the windshield to fog up,
causing loss of visibility. In this
case, set the mode selection knob to
the position and fan speed con-
trol knob to the lower speed.
MS-CNA-Eng 4(40~).QXD 7/25/2005 5:15 PM Page 57

5-3
EMISSION CONTROL
SYSTEM The vehicle emission control system is
covered by a written limited warranty.
Please see the warranty & consumer
information manual in your vehicle.VEHICLE MODIFICATIONSThis vehicle should not be modified.
Modification of your Kia could affect its
performance, safety or durability and
may even violate governmental safety
and emissions regulations.
In addition, damage or performance
problems resulting from any modification
may not be covered under warranty.
ENGINE EXHAUST GAS
PRECAUTIONS
(CARBON MONOXIDE)Engine exhaust gases contain carbon
monoxide. Though colorless and
odorless, it is dangerous and could be
lethal, if inhaled.
 Carbon monoxide can be present
with other exhaust fumes.
Therefore, if you smell exhaust
fumes of any kind inside your
vehicle, have it inspected and
repaired immediately by an
Authorized Kia Dealer. If at all
possible, do not drive with exhaust
fumes present. If you must, do so
only with all windows fully open.
Have your vehicle checked and
repaired immediately.
 Do not operate the engine in confined
or closed areas (such as garages) any
more than what is necessary to move
the vehicle in or out of the area. When the vehicle is stopped in an
open area for more than a short time
with the engine running, adjust the
ventilation system to draw outside air
into the vehicle.
Turn the engine off if you smell any
exhaust fumes.
 Never sit in a parked or stopped
vehicle for an extended time with the
engine running.
 When the engine stalls or fails to
start, excessive attempts to re-start
the engine may cause damage to the
emission control system.
OPERATING PRECAUTIONS
FOR CATALYTIC CONVERTERSYour vehicle is equipped with a catalytic
converter emission control device.
Therefore, the following precautions
must be observed:
 Use only UNLEADED FUEL.
 Do not park the vehicle over or near
flammable objects, such as dry grass,
paper, leaves, etc. Under certain
conditions, they could be ignited by a
hot exhaust system.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 3

 Keep the engine in tune and follow the
recommended periodic maintenance
schedule.
This will increase the life of all parts
and lower your operating costs.
 Do not use the air conditioner
unnecessarily.
 Slow down when driving on rough
roads.
 For longer tire life and better fuel
economy, always keep the tires
inflated to the recommended
pressures.
 Maintain a safe distance from other
vehicles to avoid sudden stops. This
will reduce wear on brake linings and
pads and save fuel because extra fuel
is required to accelerate back to
driving speed.
 Do not carry unnecessary weight in
the vehicle. Do not rest your foot on the brake
pedal while driving. This can cause
needless wear, possible damage to
the brakes, and poor fuel economy.
 Improper wheel alignment causes the
tires to roll at excessive angles,
which results in faster tire wear. It
takes more power to overcome this
improper alignment, which wastes
fuel.
 Open windows at high speeds can
reduce fuel economy.
 Crosswinds and headwinds reduce
fuel economy. To help offset some of
this loss, slow down when driving in
these conditions.
Keeping a vehicle in good operating
condition is important both for
economy and safety.
Therefore, have an Authorized Kia
Dealer perform scheduled inspections
and maintenance.
DRIVING TIPS
5-6
WARNING - Engine OFF
Motion
Never turn the engine off to
coast down hills or anytime the
vehicle is in motion. The power
steering and power brakes will
not function without the engine
running. Instead, downshift to
any appropriate gear for engine
braking effect.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 6

ROAD WARNINGHAZARD WARNING FLASHERThe hazard warning flasher serves as a
warning to other drivers to exercise
extreme caution when approaching,
overtaking, or passing your vehicle. It
should be used whenever emergency
repairs are being made or when the vehicle
is stopped near the edge of a roadway.Depress the flasher switch with the
ignition switch in any position.
All turn signal lights will flash
simultaneously.
• The hazard warning flasher will
operate whether your vehicle is
running or not.
 The turn signals do not operate when
the hazard flasher is on.
 Care must be taken when using the
hazard warning flasher while the
vehicle is being towed. Local
regulations may prohibit using it in
this manner.
OVERHEATINGIf your temperature gauge indicates
overheating, if you experience a loss of
power, or if you hear a loud knocking or
pinging noise, the engine has probably
overheated. You should follow these
procedures if you experience any of
these symptoms.
1. Turn the hazard warning flasher on,
then drive to the nearest safe location
and stop your vehicle; set the
automatic transaxle in P (Park), or
shift the manual transaxle to neutral
and apply the parking brake.
2. Make sure the air conditioner is off.
3. If coolant or steam is boiling out of
the radiator, stop the engine, then
turn the ignition switch to the ON
position. Do not restart the engine.
The radiator cooling fan will
automatically operate with the
ignition switch in the ON position. If
the cooling fan does not operate, call
an Authorized Kia Dealer for
IN CASE OF EMERGENCY
6-2
MMSA6001
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 2

IN CASE OF EMERGENCY
6-10
DESCRIPTION FUSE RATING PROTECTED COMPARTIMENTS
RR HTD IND10A Rear window defroster, Outside rear view mirror heater
HAZARD10A Hazard light, Turn signal lights
RR FOG15A Rear fog light
A/CON10A Air conditioning system
ETACS10A ETACS, Keyless entry system, Door lock system
DR LOCK15A Power door lock
P/SEAT (DRIVE)25A Power seat
T/LID OPEN15A Remote trunk lid
STOP LP15A Stop lights
H/LP10A Head light
A/BAG IND10A Air-bag
T/SIG10A Turn signal lights
A/CON SW10A Air conditioning system
ACC SOCKET15A Power outlet
S/HTR15A Seat heater
A/BAG15A Air-bag
B/UP10A Backup lights
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 10

7-3
MAINTENANCE SCHEDULEEngine Control systemI: Inspect these items and their related parts. If necessary,
Check the engine oil and coolant levels every week.
R: Replace or change.
NOTE :
Check the engine oil and coolant levels every week.
Kilometers or Time in Months, Whichever Comes First
km 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128Months 4 8 12 16 20 24 28 32 36 40 44 48 52 56 60 64
Engine oil & engine oil filter R R R R R R R R R R R R R R R R
Drive belts (tension)III I
Cooling system hoses & connectionsIIII I
Engine coolant II IIIRIIIIIRIIII
Fuel filterR
Fuel tank cap, lines, EVAP canister and hosesII
Fuel tank air filterIRIR I
Air cleaner element II IIIRIIIIIRIIII
MAINTENANCE
INTERVALS
MAINTENANCE
ITEM
x 1,000
(1)
(1)
(2)
(1) Refer to the lubricant and coolant specifications in the Owner’s Manual.
(2) More frequent maintenance is required if driving under dusty conditions.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 3