2006 KIA Magnetis oil

MAINTENANCE
7-38When choosing an oil, consider the range
of temperature your vehicle will be
operated in before the next oil change.
Then select the recommended oil
viscosity from the chart.EXTERIOR CAREEXTERIOR GENERAL
CAUTIONIt is very important to follow the
manufacturer’s directions when using
any chemical cleaner or polish. Read all
warning and caution statements that
appear on the label.FINISH MAINTENANCE
WASHINGTo help protect your vehicle’s finish from
rust and deterioration, wash it thoroughly
and frequently at least once a month with
special attention to the removal of any
accumulation of salt, dirt, mud, or other
foreign materials. Make sure the drainholes in the lower edges of the doors and
rocker panels are kept clear and clean.
Insects, tar, tree sap, bird droppings,
industrial fallout and similar deposits can
damage your vehicle’s finish if not
removed immediately.
Even prompt washing with plain water
may not completely remove all these
deposits. A mild soap, safe for use on
painted surfaces, can be used.
After washing, rinse the vehicle
thoroughly with lukewarm or cold water.
Do not allow soap to dry on the finish.
WAXINGWax the vehicle when water will no
longer bead on the paint.
Always wash and dry the vehicle before
waxing. Use a good quality liquid or
paste wax, and follow the manufacturer’s
instructions. Wax all metal trim as well,
to protect it and to maintain its luster.
Removing oil, tar, and similar materials
with a spot remover will usually strip the
wax from the finish. Be sure to re-wax
these areas even if the rest of the vehicle
does not yet need waxing.
✻
NOTICE
Do not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.
CAUTION
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water. If
braking performance is impaired,
dry the brakes by applying them
lightly while maintaining a slow
forward speed.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 38

MAINTENANCE
7-40ALUMINUM WHEEL
MAINTENANCEThe aluminum wheels are coated with a
clear protective finish.
• Do not use any abrasive cleaner,
polishing compound, solvent, or wire
brushes on aluminum wheels. They
may scratch or damage the finish.
• Use only a mild soap or neutral
detergent, and rinse thoroughly with
water. Also, be sure to clean the
wheels after driving on salted roads.
This helps prevent corrosion.
• Avoid washing the wheels with high-
speed car wash brushes.
INTERIOR CAREINTERIOR GENERAL
PRECAUTIONSPrevent caustic solutions such as
perfume and cosmetic oil from
contacting the dashboard; they may
cause damage or discoloration. If they do
contact the dashboard, wipe them off
immediately.UPHOLSTERY AND
INTERIOR TRIM CLEANINGVINYLFirst, remove dust and loose dirt from
vinyl with a whisk broom or vacuum
cleaner. Then, clean vinyl surfaces with a
vinyl cleaner.
FABRICFirst, remove dust and loose dirt from
fabric with a whisk broom or vacuum
cleaner. Then, clean with a mild soap
solution recommended for upholstery or
carpets. Remove fresh spots immediately
with a fabric spot cleaner. If a fresh spot
do not receive immediate attention, the
fabric may be stained and its color can be
affected. Also, its fire-resistant properties
may be reduced if the material is not
properly maintained.
CAUTION
After washing the vehicle, test the
brakes while driving slowly to see if
they have been affected by water.
CAUTION
Using anything but recommended
cleaners and procedures may affect
the fabric’s appearance and fire-
resistant properties.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 40

7-41
LAP/SHOULDER BELT
WEBBING CLEANINGClean the belt webbing with any mild
soap solution recommended for cleaning
upholstery or carpet. Follow the
instructions provided with the soap. Do
not bleach or re-dye the webbing
because this may weaken it.INTERIOR WINDOW
GLASS CLEANINGIf the interior glass surfaces of the
vehicle become fogged (that is, covered
with an oily, greasy or waxy film), they
should be cleaned with glass cleaner.
Follow the directions on the glass cleaner
container.
✻
NOTICE
Do not scrape or scratch the inside
of the rear window. This could
damage the rear window defroster
grid.
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 41

MAINTENANCE
7-42HEADLIGHT AIMING
ADJUSTMENTBefore performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground and
press the front bumper & rear
bumper down several times.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire, jack,
and tools). Have the driver sit in the
driver’s seat or use equivalent weight.4. Clean the headlight lenses and turn
on the headlight (Low beam).
5. Open the hood.
6. Draw a vertical line (through the
center of each headlight) and the
horizontal line (through the center of
each headlight) on the aiming screen.
1) Horizontal line dimension from
ground: 628 mm (24.72 in)
2) Distance between each vertical
line : 1,306 mm (49.17 in)
And then, draw a parallel line at 30
mm (1.18 in) place under the
horizontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a
Phillips screwdriver.
ADJUSTMENT AFTER
HEADLIGHT ASSEMBLY
REPLACEMENTIf the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should be
checked using the aiming screen as
shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of
light is parallel to center line of the
body and is aligned with point “P”
shown in the illustration.
MMSA7032
Vertical
aiming
HH W
P
MMSA7033
Horizontal line
21 mm (0.82 in)
Cut-off line
Ground line Vertical line
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 42

ENGINE
ELECTRICAL SYSTEMCAPACITIES
(Unit: Liter)
SPECIFICATIONS
8-4
Item 2400cc 2700cc
Battery MF68AH
Alternator 13.5V-95A/13.5V-110A (if equipped)
M/T 12V-1.2Kw
A/T 12V-1.2Kw
1.0~1.1 1.0~1.1
PGR5C-11 or PFR5N-11 or
RN10PYP4 RC10PYPB4 Starter
Gap
(mm)
Type Spark
plugItem 2400cc 2700cc
Bore*stroke(mm) 86.5×100 86.7×75
Displacement(cc) 2351 2656
Compression Ration 10±0.2 10±0.2
Firing order 1-3-4-2 1-2-3-4-5-6
Idle speed(rpm) 800±100 700±100
Item 2400cc 2700cc
Engine Oil 4.3 4.5
Coolant 6.3 6.9
6.5 7.1
2.1 2.1
7.8 7.8
Fuel tank 65
Transaxle
OilM/T
A/T
M/T
A/T
MS-CNA-Eng 8.QXD 7/25/2005 5:07 PM Page 4

9
INDEX
9-1
A
ir Bag - Supplemental Restraint System ................................3-42
Air Cleaner ..................................................................................7-21
Antenna .......................................................................................3-68
Automatic Heating and Cooling Control System .......................4-47
Automatic Transaxle ............................................................4-7, 7-19
B
attery.......................................................................................7-23
Before Driving ..............................................................................5-4
Brake System ..............................................................................4-12
Brakes and Clutch .......................................................................7-17
Bulb Replacement .......................................................................7-32
C
hanging tires ..........................................................................6-22
Climate Control System ..............................................................4-42
Cruise Control .............................................................................4-37
Cup Holders and Console Storage Compartment .......................3-63
D
oor Locks .................................................................................3-9
E
lectrical Circuit Protection .......................................................6-7
Emergency Starting .......................................................................6-3
Emission Control System ..............................................................5-3
Engine Compartment ..................................................................7-10
Engine Cooling System...............................................................7-14
Engine Oil and Oil Filter .............................................................7-12
Exterior Care ...............................................................................7-38
F
uel Filler Lid ...........................................................................3-55
Fuel Requirements ........................................................................5-2
G
auges ......................................................................................4-20
H
eadlight Aiming Adjustment .................................................7-42
Homelink® Wireless Control System.........................................5-12
Hood ............................................................................................3-54
How To Use This Manual .............................................................1-2
If You Have a Flat Tire .............................................................6-19
Ignition Switch ..............................................................................4-2
Immobilizer System ......................................................................3-6
Instrument Cluster .......................................................................4-19
Instrument Panel Overview ...........................................................2-3
Interior and Exterior Overview .....................................................2-2
Interior Care ................................................................................7-40
Interior Features ..........................................................................4-33
Interior Lights .............................................................................3-62K
eyless entry system .................................................................3-4
Keys ..............................................................................................3-3
L
abel Information .....................................................................5-11
Lightings .....................................................................................4-27
Lubricant Specifications .............................................................7-36
Lubricants and Fluids ..................................................................7-20
Luggage Net ................................................................................3-69
Ms-CNA-Eng-INDEX.qxd 7/25/2005 5:07 PM Page 1