2006 JEEP WRANGLER roof

26. Close the header latches and return the sun visor to
it’s secure position.HARD TOP
CAUTION!
•The hard top is not designed to carry any addi-
tional loads such as roof racks, spare tires, build-
ing, hunting, or camping supplies, and/or lug-
gage, etc. Also, it was not designed as a structural
member of the vehicle, and thus cannot properly
carry any additional loads other than environmen-
tal (rain, snow, etc.).
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 89
3

Hard Top Installation
NOTE:If the door frames are installed from soft top
usage, they must be removed prior to installation of the
hard top.
1. Inspect the hard top seals for damage and replace if
necessary.
2. Install the hard top using the same steps for removal
in reverse order.
NOTE: The hard top must be positioned properly to
ensure sealing. Set the hard top on the windshield frame
so that there is no overhang. Also, make sure that the
hard top is sitting flush with the body at the sides and
check to ensure that there is a uniform gap between the
lift glass and hard top.
SOFT TOP
CAUTION!
•The soft top is not designed to carry any addi-
tional loads such as roof racks, spare tires, build-
ing, hunting, or camping supplies, and/or lug-
gage, etc. Also, it was not designed as a structural
member of the vehicle, and thus cannot properly
carry any additional loads other than environmen-
tal (rain, snow, etc.).
94 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

10. Completely release the hooks on the rear side of the
windshield. Grasp the side bow behind the header and
lift top back.
11. As you begin to lower the top, wrap the sail panels so
that they rest on the roof of the vehicle. NOTE:
If your vehicle is equipped with a Dual Top,
prevent connector damage by ensuring that the hard top
wire harness is folded back and secured to the main
harness, using the attached Velcro  strap.
12. Make sure the sides of the top are folded inward as
the top continues to fold, and that the check straps are
clear of the vehicle.
100 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

16. Close the header latches and return the sun visor to
it’s secured position.SOFT TOP — SUNRIDER EQUIPPED MODELS
CAUTION!
•The soft top is not designed to carry any addi-
tional loads such as roof racks, spare tires, build-
ing, hunting, or camping supplies, and/or lug-
gage, etc. Also, it was not designed as a structural
member of the vehicle, and thus cannot properly
carry any additional loads other than environmen-
tal (rain, snow, etc.).
If the temperature is below 72°F (24°C) and/or the top
has been folded down for a period of time, the top will
appear to have shrunk when you raise it, making it
difficult to put up. This is caused by a natural contraction
of the vinyl coating on the fabric top.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 111
3

12. As you begin to lower the top, wrap the sail panels so
that they rest on the roof of the vehicle.
13. Make sure the sides of the top are folded inward as
the top continues to fold, and check straps are clear of the
vehicle. For Unlimited Models
— Tuck the top between the 2
bow and 2-1/2 bow and 2-1/2 bow and 3 bow as it folds.
For Wrangler Models — Tuck the top between the 2 bow
and 3 bow as it folds.
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Satellite Antenna
To ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items should be
placed as far forward as possible. Do not place items
directly on or above the antenna.
Reception Quality
Satellite reception may be interrupted due to one of the
following reasons.
•The vehicle is parked in an underground parking
structure or under a physical obstacle.
•Dense tree coverage may interrupt reception in the
form of short audio mutes.
•Driving under wide bridges or along tall buildings can
cause intermittent reception.
•Placing objects over or too close to the antenna can
cause signal blockage.
CD/DVD DISC MAINTENANCE
To keep the CD/DVD discs in good condition, take the
following precautions:
1. Handle the disc by its edge; avoid touching the
surface.
2. If the disc is stained, clean the surface with a soft cloth,
wiping from center to edge.
3. Do not apply paper, paper CD labels, or tape to the
disc; avoid scratching the disc.
4. Do not use solvents such as benzine, thinner, cleaners,
or antistatic sprays.
5. Store the disc in its case after playing.
6. Do not expose the disc to direct sunlight.
7. Do not store the disc where temperatures may become
too high.
UNDERSTANDING YOUR INSTRUMENT PANEL 171
4