2006 JEEP WRANGLER jump cable

9. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
nuts until each nut has been tightened twice. Correct
wheel nut tightness is 130 N·m (95 ft. lbs). If in doubt
about the correct tightness, have them checked with a
torque wrench by your authorized dealer or at a service
station.
10. Remove jack assembly and wheel blocks.
WARNING!
A loose tire or jack, thrown forward in a collision or
hard stop could endanger the occupants of the ve-
hicle. Always stow the jack parts and the spare tire in
the places provided.
11. Secure the tire, jack, and tools in their proper loca-
tions.
JUMP STARTING
WARNING!
To prevent personal injury or damage to clothing, do
not allow battery fluid to contact eyes, skin, or
fabrics. Do not lean over a battery when connecting
jumper cables or allow cable clamps to touch each
other. Keep open flames or sparks away from battery
vent holes. Always wear eye protection when work-
ing with batteries. Do not use a booster battery or
any other booster source that has a greater than
12–volt system, i.e. do not use a 24–volt power
source.
Your vehicle is equipped with a 12–volt battery. If it
becomes necessary to use a booster battery, with jumper
cables, to start the vehicle’s engine because it’s battery is
discharged, the following procedure should be followed:
258 WHAT TO DO IN EMERGENCIES

Set the parking brake, place an automatic transmission in
P (Park) (or N (Neutral) for a manual transmission). Turn
off lights, heater, and other electrical loads. Observe
charge indicator in the battery. If indicator is light or
yellow, replace the battery.
CAUTION!
Use the “Jump Starting” procedure only when the
charge indicator is dark in the center. Do not attempt
jump starting when the battery charge indicator is
bright or yellow. If the charge indicator is dark and
has a green dot in the center, failure to start is not
due to a discharged battery and the cranking system
should be checked.
1. Attach one end of the jumper cable to the positive
terminal of the discharged battery and the other end of
the same cable to the positive terminal of the booster
battery.
WARNING!
Do not permit vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
2. Connect one end of the other jumper cable to the
negative terminal of the booster battery. Connect the
other end of the jumper cable to a good ground on the
vehicle with the discharged battery. Make sure a good
connection is made, free of dirt and grease.
WHAT TO DO IN EMERGENCIES 259
6

WARNING!
•Do not connect the cable to the negative terminal
of the discharged battery. The resulting electrical
spark could cause the battery to explode.
•During cold weather when temperatures are be-
low freezing point, electrolyte in a discharged
battery may freeze. Do not attempt jump starting
because the battery could rupture or explode. The
battery temperature must be brought up above
freezing point before attempting to jump start.
3. Take care that the clamps from one cable do not touch
clamps from the other cable. Do not lean over the battery
when making the connection. The negative connection
must provide good electrical conductivity and current
carrying capacity.
4. After the engine is started or if the engine fails to start,
the cables must be disconnected in the following order: a. Disconnect the negative cable at the engine ground.
b. Disconnect the negative cable at the negative termi-
nal on the booster battery.
c. Disconnect the cable from the positive terminals of
both batteries.
260 WHAT TO DO IN EMERGENCIES

Dimmer Switch........................ 65
Replacing ............................ 310
Switch ............................... 64
Heater ............................... 172
Heater, Engine Block ..................... 184
High Beam Indicator ..................... 148
Hitches Trailer Towing ........................ 238
Holder, Cup ............................ 72
Hood Release ........................... 62
Hoses ............................. 289,290
Hydraulic Clutch Fluid .................... 294
Ignition Cables .............................. 277
Key ................................. 13
Illuminated Entry ........................ 17
Infant Restraint ........................ 34,35
Inflation Pressure Tires .................... 222 Inside Rearview Mirror
.................... 52
Instrument Cluster ....................... 146
Instrument Panel and Controls .............. 145
Instrument Panel Lens Cleaning ............. 301
Interior Appearance Care .................. 300
Interior Fuses .......................... 305
Interior Lights ........................... 64
Intermittent Wipers (Delay Wipers) ............ 67
Introduction ............................. 4
Jack Location ........................... 255
Jack Operation ....................... 254,256
Jacking Instructions ...................... 256
Jump Starting .......................... 258
Key, Programming ........................ 16
Key Release Button ....................... 14
Key, Replacement ........................ 16
Key, Sentry (Immobilizer) ................... 14
354 INDEX