2006 Hyundai H-1 (Grand Starex) sae 90

6VEHICLE MAINTENANCE REQUIREMENTS
14
G080N01P-GAT
o Brake Hoses and Lines
Visually check for proper installation,
chafing, cracks, deterioration and any leakage. Replace any deteriorated or damaged parts immediately.
G080O01P-GAT
o Brake Fluid
Check brake fluid level in the brake
fluid reservoir. The level should be between "MIN" and "MAX" marks on the side of the reservoir. Use onlyhydraulic brake fluid conforming SAE J1703.
G080P01P-GAT
o Rear Brake Drums and
Linings
Check for scoring, burning, leaking
fluid, broken parts, and excessive wear. G080Q01P-GAT
o Brake Pads, Calipers and
Rotors
Check the pads for excessive wear, discs for run out and wear, and cali- pers for fluid leakage. G080R01P-GAT
o Parking Brake
Inspect the parking brake system such as parking brake lever, cables, and so on. For detailed service procedures,refer to the Shop Manual.
G080S01P-GAT
o Exhaust Pipe Connections,
Muffler and Suspension Bolts
Check the exhaust pipe, muffler, and
suspension connections for loosenessor damage.
G080L01P-GAT
o Manual Transmission Oil Check manual transmission oil ac- cording to the maintenance schedule. NOTE: If the oil level is low, check for possible leaks before adding oil. Do not overfill. G080M03P-GAT
o Automatic Transmission Fluid The fluid level should be in the "HOT" range of the dipstick, after engine and transmission are at normal operatingtemperature. Check the Automatic Transmission Fluid level with the en- gine running and the transmission inneutral, with the parking brake properly applied. Use MOBIL DEXRON-II or DIAMOND ATF SP-I when adding orchanging fluid.

8DO-IT YOURSELF MAINTENANCE
8
Select engine oil of the proper SAE viscosity number according to the at-mospheric temperature.Recommended viscosity is given inthe following illustration. The engine oil quality should meet the following API classification: 2.6 N/A : CF-4 or ABOVE 2.5 4D56 : CF-4 or ABOVE 2.5 CRDi : CF-4 or ABOVE The engine oil quality should meet the following ACEA classification: 2.6 N/A : B2 or B3 2.5 4D56 : B2 or B3 2.5 CRDi : B4 or ABOVE NOTE: For diesel-powered vehicle SAE 0W-30 oil should be used only inareas where extremely cold tem- peratures of 10°C (50°F) or below are experienced. For diesel-poweredvehicle, if the atmospheric tempera- tures are 0°C (32°F) or below, SAE 30 oil must not be used.
G030A02O-GAT
Recommended Oil Gasoline Engine
G030B01JMEngine oil is essential to the perfor-
mance and service of the engine. It is suggested that you check the oil level at least once a week in normal use and more often if you are on a trip ordriving in severe conditions.
The engine oil quality should meet the
following classification.
API SJ, SL or ABOVE, ILSAC GF-3 or ABOVE NOTE:
o For good fuel economy, SAE 5W- 20 (5W-30), ILSAC GF-3 engine oil is preferred regardless of regional option and engine variation.
o If SAE 5W-20, ILSAC GF-3 engine oil is not available, secondaryrecommended engine oil for cor- responding temperature range can be used.
This oil should be used only inareas where the atmospheric tem-peratures are 0°C(32°F) or above.

8
DO-IT YOURSELF MAINTENANCE
17CHECKING THE BRAKE FLUID
I100A02P-GAT Check the brake fluid level in the reservoir. The brake fluid level must be be- tween the "MAX" and "MIN" marks on the reservoir. The fluid level falls slightly with wear of the brake pads but it does not indicate any abnormality. If the brake fluid level falls markedly in a short time, it indicates leaks from the brake system. In such a case,have your vehicle checked by an au- thorized HYUNDAI dealer. Use SAE J1703 (or DOT3 or DOT 4) or equivalent type brake fluid.
CAUTION:
Be sure to install the climate control air filter in the direction of the arrow sign. Otherwise, it may cause noise or deterioration.
!
HA12502
2. Remove the 5 clamps on the air in- take duct. HA12503
3. Replace the climate control air filter with a new one.
4. Installation is the reverse order of disassembly. I100A01P
B140E01P
1. Open the engine hood.

9 VEHICLE SPECIFICATIONS
4
OIL & GREASE STANDARDSAE 30 (ABOVE 0°C) SAE 20W-40 (ABOVE -10°C)SAE 15W-40 (ABOVE -15°C)SAE 10W-30 (-20°C ~ 40°C)SAE 5W-30 (-25°C ~ 40°C)SAE 0W-30 (BELOW 10°C) *1SAE 30 (0°C ~ 40°C)SAE 20W-40 (ABOVE -10°C)SAE 15W-40 (ABOVE -15°C)SAE 10W-30 (-20°C~ 40°C)SAE 5W-30 (-25°C~ 40°C)SAE 0W-30 (BELOW 10°C) *1
*1. Restricted by driving condition and area. SAE 5W-20, 5W-30SAE 10W-30 (ABOVE -18°C)SAE 15W-40 (ABOVE -13°C)SAE 20W-50 (ABOVE -7°C)
NORMAL DRIVING CONDITIONSEVERE DRIVING CONDITIONLUBRCATION CHART
J060A08P-GAT
ITEM
ENGINE OIL ENGINE OIL CONSUMPTIONQUANTITY (LITER)
Engine Oil : 6.1 at Oil Pan : 4.9
Engine Oil : 7.4 at Oil Pan : 6.6 (MAX) 4.9 (MIN)
Engine Oil : 4.3 at Oil Pan : 4.0 (MAX) 3.0 (MIN)
at Oil Filter : 0.3
Max. 1L/ 1,500 km Max. 1L/ 1,000 km
API CF-4 or ABOVE ACEA B2 or B3 API CF-4 or ABOVE ACEA B2 or B3 API CF-4 or ABOVE ACEA B4 or ABOVE API SJ, SL or ABOVE, ILSAC GF-3 or ABOVE
2.6 N/A(Diesel) 2.5 4D56 (Diesel) 2.5 CRDi (Diesel) 2.4 DOHC (Gasoline)
Recommends

9
VEHICLE SPECIFICATIONS
5
J060A08P-GAT QUANTITY (LITER)
Minibus, Van : 1.3 0.8
Minibus : 13, Van : 10, Truck : 7.2As requiredAs required
Minibus, Van : 2.6, Truck : 1.7 As required
OIL & GREASE STANDARD
HYUNDAI GENUINE PARTS MTF 75W/85 (API GL-4) MOBIL DEXRON-II or DIAMOND ATF SP-I DIAMOND ATF SP II PSF-3HIGH QUALITY ETHYLENE GLYCOL BASE FORALUMINUM RADIATORSAE J 1703 EQUIVALENTSAE J310a, MULTI-PURPOSE GREASE NLGI-2 OREQUIVALENT.API GL-4 (MS517-15) : SAE 90, 140API GL-5 (MS517-15) : SAE 80
ITEMS
MANUAL TRANSMISSION OIL AUTOMATIC TRANSMISSION OIL TRANSFER CASE OIL POWER STEERING OIL COOLANTCLUTCH & BRAKE FLUIDFRONT, REAR WHEEL BEARINGREAR AXLE STEERING GEAR BOX
GASOLINE DIESEL
GASOLINE
DIESEL 2.0
2.6 N/A : 2.4 2.5 4D56 : 2.42.5 CRDi : 3.2 7.53
2.6 N/A(long van): 8.5 2.6 N/A: 7 2.5 4D56 (2WD) : 7.92.5 4D56 (4WD) : 9.832.5 CRDi (2WD) : 8.32.5 CRDi (4WD) : 11.7