2006 Hyundai Elantra clock

6
DO-IT-YOURSELF MAINTENANCE
11CHANGING THE OIL AND FILTER
!
G040A04FC-GAT
Gasoline Engine
G040A03EThe engine oil and filter should be
changed at those intervals specified in the maintenance schedule in Sec- tion 5. If the vehicle is being driven in severe conditions, more frequent oiland filter changes are required.
The procedure for changing the oil
and filter is as follows:
1. Park the vehicle on level ground
and set the parking brake. Start the engine and let it warm up until the needle on the coolant temperature gauge moves above the lowestmark. Turn the engine off and place the gear selector lever in "P" (auto- matic) or reverse gear (manualtransaxle).
2. Open the hood and remove the engine oil filler cap.
3. Slide underneath the car and loosen
the drain plug by turning it counter-clockwise with a wrench of the proper size. Be sure that a drain pan is in position to catch the oil asit drains out, then remove the drain plug. WARNING:
Be very careful when draining the engine oil as it may be hot enough to burn you!
4. When the oil has stopped draining, replace the drain plug using a new gasket and retighten by turning it clockwise.
Drain plug tightening torque:
Oil filler cap
Drain plug
Oil filter
1.6 DOHC 1.8/2.0 DOHC 4.0 ~ 4.5 3.5 ~ 4.5
E.CExcept E.C
4.0 ~ 4.5
5. Remove the oil filter. You should be able to unscrew the filter with your hands. (If your hands are slip- pery, try to use a cloth between your hands and the filter to giveyourself a better grip.) A certain amount of oil will come out when you remove the filter, so be sure tohave your drain pan in place un- derneath it. kgf.m
F040A02TB
Oil filler cap
Drain plug
Oil filter
1.8/2.0 DOHC 1.6 DOHC

6
DO-IT-YOURSELF MAINTENANCE
13
!
Turn the engine off and place the gear selector lever in "P" (auto-matic) or reverse gear (manual transaxle).
2. Open the hood and remove the engine oil filler cap.
3. Slide underneath the car and loosen the drain plug by turning it counter-clockwise with a wrench of the proper size. Be sure that a drainpan is in position to catch the oil as it drains out, then remove the drain plug.
WARNING:
Be very careful when draining theengine oil as it may be hot enoughto burn you!
4. When the oil has stopped draining, replace the drain plug using a newgasket and retighten by turning itclockwise. Drain plug tightening torque: 3.5 ~ 4.5 kgf.m 8. Install a new copper washer of the
oil filter drain plug by the side oflower case and retighten by turn- ing it clockwise.
Tightening torque : 0.8~1.0 kgf.m
9. After mounting a new oil filter ele- ment and O-ring to upper cap, install the upper cap to lower case and retighten by turning it clock- wise. Do not over-tighten.
Tightening torque : 2.3~2.5 kgf.m
NOTE: Be careful not to be the element upside down when mounting the element.
10.Remove the engine oil level dip- stick.
11.Refill the crankcase with the rec- ommended engine oil. Refer to the specification in chapter 9 forengine oil capacity.
G040B01FC
5. Loosen the oil filter drain plug by turning it counterclockwise with a wrench of the proper size and drain out some oil in the oil filter. Be surethat a drain pan is in position to catch the oil.
6. Loosen the oil filter upper cap with a proper tool from the lower case until an O-ring is seen. Then, drainthe oil completely.
7. Pull out the oil filter upper cap with
element from the lower case.Using a clean cloth, remove anydirt or oil accumulated around thelower case.
Upper cap
Washer
Oil filter drain plug O-ring
Oil filter element
Lower case

6 DO-IT-YOURSELF MAINTENANCE
16
4. Turn the radiator cap counterclock-
wise without pressing down on it, until it stops. This relieves any pres- sure remaining in the cooling sys- tem. And remove the radiator cap by pushing down and turning coun-terclockwise.Fill the radiator with clean deminer-alized or distilled water. Continueto add clean demineralized or dis- tilled water in small quantities until the fluid level stays up in the radia-tor neck. G050D03E
G050D04E
G050D03A-AAT
To Change the Coolant
The coolant should be changed at
those intervals specified in the ve- hicle maintenance schedule in Sec- tion 5.
! CAUTION:
Engine coolant can damage the
finish of your car. If you spill en- gine coolant on the car, wash it off thoroughly with clean water.
1. Park the car on level ground, set the parking brake and remove the radia- tor cap when cool.
2. Be sure your drain receptacle is in
place. Open the drain cock on theradiator. Allow all the engine cool- ant to drain from the cooling sys- tem, then securely close the draincock.
3. Check Section 9 for the capacity of the cooling system in your car.Then, following the manufacturer's directions on the engine coolant container, add the appropriatequantity of coolant to the radiator.
!WARNING:
Remove the radiator cap when the
radiator is cool. 5. Start the engine, top off the radiator
with water and then add engine coolant to the reservoir until thelevel is between "L" and "F".
6. Replace the radiator and reservoir
caps and check to be sure the draincocks are fully closed and not leak- ing.

6 DO-IT-YOURSELF MAINTENANCE
18
!WARNING:
It is recommended that the engine
be cool or cold when changing the spark plugs. If the engine is hot, you could burn yourself on theinsulated connector, the spark plugs or the engine itself. HGK2574. When preparing to remove the old
spark plug, guide the socket down over the spark plug, being careful not to damage the ceramic insula- tor.
5. To remove the spark plug, turn the wrench handle in a counterclock-wise direction.
6. To install the new spark plug, guide
the socket down over the sparkplug, being careful not to damage the ceramic insulator.
HGK258
3. To remove the spark plug cable,
pull straight up on the insulated connector, not the cable. Pulling on the cable may damage the car- bon core conductor.
G060C01S-GAT Changing the Spark Plugs You will find it easier to change spark plugs if the engine is cold. Always change one spark plug at a time. This helps avoid getting the wires mixedup.
1. Remove the center cover on the
engine rocker cover.
2. Using a clean cloth, remove any dirt that has accumulated around the spark plug so it cannot fall intothe cylinder when the spark plug is removed. HGK256

6 DO-IT-YOURSELF MAINTENANCE
22
1. Using a wrench of the correct size,
loosen the oil filler plug by turning it counterclockwise and remove it with your fingers.
2. Use your finger or suitable tool to feel inside the hole. The oil levelshould be at its bottom edge. If it is not, check for leaks before addingoil. To refill the transaxle or bring the oil level up,add oil slowly until it reaches the proper level. Do notoverfill.
3. Replace the plug and washer, screw it in with your fingers and then tighten securely with the wrench.
G110A02E-AAT
AUTOMATIC TRANSAXLE
Transaxle fluid in the automatictransaxle should be checked at those intervals specified in the vehicle main- tenance schedule in Section 5.
G100B02A-AAT
To Check the Maunal Transaxle Fluid Level
G100B01L
Park the car on level ground with the
engine off. G110B04A-AAT
Recommended Fluid
Your Hyundai automatic transaxle is
specially designed to operate with HYUNDAI GENUINE ATF SP III, DIA- MOND ATF SP-III, SK ATF SP III orother brands approved by Hundai Motor Co,. Damage caused by a nonspecified fluid is not covered byyour new vehicle limited warranty. NOTE: Automatic transaxle fluid is a red in
color. As driving distance increases, the fluid color turns darkish red gradually. It is a normal condition and you should not judge the needto replace based upon the changing color.
You must replace the automatic
transaxle fluid in accordance withintervals specified in the vehicle maintenance schedule in section5.
!WARNING:
It is always better to check the
transaxle oil level when the engine is cool or cold. If the engine is hot, you should exercise great cautionto avoid burning yourself on hot engine or exhaust parts.

6
DO-IT-YOURSELF MAINTENANCE
39
HXDFL1011
7. Push the bulb spring to remove the headlight bulb. HXDFL1010
6. Turn the plastic cover counterclock- wise and remove it. 8. Remove the protective cap from
the replacement bulb and install the new bulb by matching the plas- tic base with the headlight hole. Retighten the bulb spring and re-connect the power cord.
9. Use the protective cap and carton to promptly dispose of the old bulb.
10.Check for proper headlight aim.
(1) High beam (2) Low beam (3) Front turn signal light HXDFL1013-1
(1)
(2)(3)
!
G270A03O
WARNING:
This halogen bulb contains gas under pressure and if impacted could shatter, resulting in flyingfragments. Always wear eye pro- tection when servicing the bulb. Protect the bulb against abrasionsor scratches and against liquids when lighted. Turn the bulb on only when installing in a head-light. Replace the headlight if dam- aged or cracked. Keep the bulb out of the reach of children anddispose of the used bulb with care.

6 DO-IT-YOURSELF MAINTENANCE
48
G200D01E-GAT Inner Panel
G280D01EFUSE
RATING
10A 10A15A 10A 10A10A10A 10A10A 10A 10A10A 30A 20A15A 15A 10A15A 10A 10A15A 20A 20A10A 15A 30A PROTECTED COMPONENTS
Turn signal lamps, Back-up lamp
Pre-excitation resistor, Instrument cluster (IND)SRS control
Hazard relay, Hazard lamps A/C Control
Shor t connector, Illumination lamps, Tail lamp (RH), Head lamp washer
Tail lamp (LH), Exterior lamps
B/Alarm relay
Digital clock, Power outside mirror & mirror folding, Audio
Cruise control, PCM, Vehicle speed sensor, Ignition coil ABS control
Instrument cluster (Air bag IND)
Defogger relay
Power antenna
Power door lock control, Sunroof
Stop lamps, Power window, Power outside mirror folding
Rear window & outside mirror defogger, A/C control
Cigarette lighter, Power outlet
Rear fog lamps
Head lamp, Head lamp washer, Fuel filter heating Rear wiper & washer
Front wiper & washer
Seat warmer
Blower & A/C control, ETACM, Sunroof controller, Electronic chrome mirror
Door lamps, Instrument cluster, Data link connector, Multipurpose check
connector, Room lamps, ETACM, Audio, Power connector
Power window
T/SIG
CLUSTER
A/BAG
HAZARD A/C SW
TAIL-RH TAIL-LH START
AUDIO
E C UA B S
A/BAG IND RR HTRA M P
S/ROOF
STOP
HTD MIR C/LIGHT
RR FOG I G N
R/WIPER
F/WIPER S/HTR
A/CON
ROOM LP
P/WINDOW
FUSE
FUSIBLE LINK
DESCRIPTION

10INDEX
2
A Airbag ........................................................................ 1-37
Air Cleaner Filter ....................................................... 6-19
Air Conditioning Care ....................................................................... 6-27
Operation ............................................................... 1-94
Switch ..................................................................... 1-94
Air Filter ........................................................ 1-103, 6-28
Antenna ................................................................... 1-137
Ashtray ...................................................................... 1-66
Audio Fault Code .................................................... 1-113
Automatic Heating and Cooling Control System ......1-96
B
Battery ............................................................. 2-20, 6-32 Brake Anti-lock system ..................................................... 2-14
Checking the brakes .............................................. 6-24
Fluid ....................................................................... 6-25
Pedal clearance ..................................................... 6-30
Pedal freepl ay ........................................................ 6-29
Practices ................................................................ 2-16
Breaking-In your New Hyundai ................................... 1-3
Bulbs Repl acement ................................................... 6-38
Bulbs Wat tage ........................................................... 6-45C
Care of Cassette Tapes ....................
..................... 1-135
Care of Disc ............................................................ 1-134
Cassette Tape Player Operation (H240, H280/H290) .................................................................. 1-112, 1-126
Catalytic Converter ...................................................... 7-3
CD Auto Changer (H260, H280/H290) ..........1-120, 1-131
Child Restraint System .............................................. 1-26
Cigarette Lighter ........................................................ 1-65
Clock ......................................................................... 1-64
Clutch
Checking the cluch fluid ............... .......................... 6-26
Pedal freepl ay ........................................................ 6-29
Combination Light Daytime running light ............................................. 1-59
Headlight flasher .................................................... 1-59
Headlight swi tch ..................................................... 1-58
High-beam swi tch .................................................. 1-59
Lane change si gnal ................................................ 1-58
Turn signal oper ation............................................. 1-58
Compact Disc Player Operation (H260, H280/H290)
................................................................. 1-117, 1-128
Cooling Fans ............................................................. 6-34
Corrosion protection Cleaning the interior ................................................. 4-5
Protecting your Hyundai from corrosion .................. 4-2
Washing and waxing ................................................ 4-4