2006 HONDA S2000 dead battery

µµ
µ
µ
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Turn the system on by
pushingthePWR/VOLknoborthe
FM/AM button. Adjust the volume
by turning the PWR/VOL knob.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the FM/AM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available.
You can use any of f ive methods to
f ind radio stations on the selected
band: the
preset buttons, and .
Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a lower f requency.
The seek f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
bar, then release it.
If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, press
the SCAN button again. Each preset button can
store one f requency on AM and two
f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
The preset f requencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed. Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM. Pickapresetbutton,andholdit
until you hear a beep. Usethetune,seek,orscan
function to tune the radio to a
desired station.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
The system will scan f or a station
with a strong signal. When it f inds
one, it will stop and play that station
f or about 5 seconds. 1.
2.
3.
4.
CONT INUED
To Play the Radio
To Select a Station
TUNE,SEEK,SCAN, AUTO SELECT
TUNE SEEK
Preset
SCAN
Playing the AM/FM Radio
Features
87
——y

y
(yy

µµ
The scan f unction gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order f or a f ew seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again. To store a channel:
Youcanstoreupto12
preset channels using the six preset
buttons. Each button stores one
channel f rom the XM1 band and one
channel f rom the XM2 band.
To store a channel: Pick the preset button you want
f or that channel. Press and hold
the button until you hear a beep.
Once a channel is stored, simply
press and release the proper preset
button to tune to it.
The presets will be lost if your
vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed. Repeat steps 2 through 3 to store
the f irst six channels.
Use the TUNE knob, the
CATEGORY bar, or the SCAN
buttons to tune to a desired
channel.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected. Press the CD/XM button. Either
XM1 or XM2 will show in the
display.
Press the CD/XM button again.
The available XM band will show.
Store the next six channels using
steps 2 through 3.
1.
2. 3.
4.
5.
CONT INUED
SCAN
Preset
Playing the XMSatellite Radio (Optional on U.S. Models)
Features
93
——y
y
(yy

Your vehicle’s audio system will
disable itself if it is disconnected
f rom electrical power f or any reason.
To make it work again, you must
enter a specif ic f ive-digit code in the
preset buttons. Because there are
hundreds of number combinations
possible f rom f ive digits, making the
system work without knowing the
exact code is nearly impossible.You will have to store your favorite
stations in the preset buttons after
the system begins working. Your
original settings were lost when the
power was disconnected.
If you lose the card, you must obtain
the code number f rom a dealer. To
do this, you will need the system’s
serial number. Youshouldhavereceivedacardthat
lists your audio system’s code and
serial numbers. It is best to store this
card in a saf e place at home. In
addition, you should write the audio
system’s serial number in this owner’s
manual. If your vehicle’s battery is
disconnected or goes dead, or the
radio f use is removed, the audio
system will disable itself . If this
happens, you will see ‘‘Code’’ in the
frequencydisplaythenexttimeyou
turn on the system. Use the preset
buttons to enter the five-digit code.
Thecodeisontheradiocodecard
included in your owner’s manual kit.
When it is entered correctly, the
radio will start playing.
If you make a mistake entering the
code, do not start over; complete the
f ive-digit sequence, then enter the
correct code. You have 10 tries to
enter the correct code. If you are
unsuccessf ul in 10 attempts, you
must then leave the system on for 1
hour bef ore trying again.
Radio T hef t Protection
102
——y
y
(y
y

If your vehicle battery has been
disconnected or gone dead, these
codes are erased. It takes at least
three days of driving under various
conditions to set the codes again.
If the indicator comes on repeatedly,
even though it may go of f as you
continue driving, have your vehicle
checked by a dealer as soon as
possible.
If this indicator comes on
while driving, it means one
of the engine’s emissions control
systems may have a problem. Even
though you may f eel no dif f erence in
your vehicle’s perf ormance, it can
reduce your f uel economy and cause
increased emissions. Continued
operation may cause serious damage.
Your vehicle has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics f or the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed.To check if they are set, turn the
ignition switch to the ON (II)
position, without starting the engine.
The malf unction indicator lamp will
come on f or 20 seconds. If it then
goes of f , the readiness codes are set.
If it blinks f ive times, the readiness
codes are not set. If possible, do not
take your vehicle for a state
emissions test until the readiness
codes are set. Ref er to
for more
inf ormation (see page ).
If you have recently ref ueled your
vehicle, the indicator coming on
could be due to a loose or missing
f uel f ill cap. Tighten the cap until it
clicks at least once. Tightening the
cap will not turn the indicator of f
immediately; it can take several days
of normal driving.
204
Malf unction Indicator L amp
State
Emissions T esting
Readiness Codes
T aking Care of t he Unexpect ed
183
If you keep driving with the
malf unction indicator lamp on, you can
damage your vehicle’s emissions
controls and engine. Those repairs may
not be covered by your vehicle’s
warranties.
——y

y
(y
y

If you take your vehicle f or a state
emissions test shortly af ter the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the on-
board diagnostics f or the emissions
systems. These codes are erased
when the battery is disconnected,
and set again only after several days
of driving under a variety of
conditions.
If the testing f acility determines that
the readiness codes are not set, you
will be requested to return at a later
date to complete the test. If you must
get the vehicle retested within the
next two or three days, you can
condition the vehicle f or retesting by
doing the f ollowing.Make sure the gas tank is nearly,
but not completely, f ull (around
3/4). Without touching the accelerator
pedal, start the engine, and let it
idle f or 20 seconds.
Keep the vehicle in Neutral.
Increase the engine speed to 2,000
rpm,andholditthereuntilthe
temperature gauge rises to at least
1/4of thescale(about3minutes).
Select a nearby lightly traveled
major highway where you can
maintain a speed of 50 to 60 mph
(80to97km/h)foratleast20
minutes. Drive on the highway in
5th.Donotusethecruisecontrol.
When traffic allows, drive for 90
seconds without moving theaccelerator pedal. (Vehicle speed
may vary slightly; this is okay.) If
you cannot do this f or a
continuous 90 seconds because of
traf f ic conditions, drive f or at least
30 seconds, then repeat it two
more times (for a total of 90
seconds).
Then drive in city/suburban
traffic for at least 10 minutes.
When traffic conditions allow, let
the vehicle coast f or several
seconds without using the
accelerator pedal or the brake
pedal.
If the testing f acility determines the
readiness codes are still not set, see
your dealer.
Make sure the vehicle has been
parked with the engine of f f or 6
hours or more.
Make sure the ambient
temperature is between 40° and
95°F.
State Emissions T esting
T esting of Readiness Codes
204
——y


y
(yy

ÎÎÎ
Changing Oil
........................................
How to .144
......................................
When to .139
...
Charging System Indicator .46,182
............
Checklist, Bef ore Driving .121
.....................................
Child Saf ety .28
..............................
Booster Seats .37
...................................
Child Seats .33
.....
Important Saf ety Reminders .31
..........................
Larger Children .36
.......................
Risk with Airbags .29
.............................
Small Children .32
.......................................
Child Seats .33
.......................
Cleaning Seat Belts .157
.................................................
Clock .54
...................................
Clutch Fluid .151
........................
CO in the Exhaust .201
............
Cold Weather, Starting in .122
......................
Compact Spare Tire .170
...............
Consumer Inf ormation .206
.............
Controls, Instruments and .43
..............................
Convertible Top .70
...............
Convertible Top Cover .72
..
Lowering the Convertible Top .70
................................
Maintenance .74
.....
Raising the Convertible Top .73 Coolant
........................................
Adding .146
....................................
Checking .112
.........................
Proper Solution .146
...................
Temperature Gauge .52
Crankcase Emission Control ........................................
System .201
................
Cruise Control Indicator .47
............
Cruise Control Operation .103
......................................
Cup Holder .78
.............
Customer Service Of f ice .206
..............................
Economy, Fuel .112
..................................
Emergencies .169
.............
Battery, Jump Starting .178
...........
Brake System Indicator .184
................
DANGER, Explanation of .ii
...................................
Dashboard .3,44
..............
Dashboard Lower Pocket .79
................
Daytime Running Lights .57
Daytime Running Lights
.......................................
Indicator .48
.................................
Dead Battery .178
.........
Def ects, Reporting Saf ety .208
................
Def ogger, Rear Window .59
................
Def rosting the Windows .85
..........................
Dif f erential Fluid .150
....................................
Dimensions .196 ...............
Dimming the Headlights .57
Dipstick
..................................
Engine Oil .111
..........................
Directional Signals .57
........
Disc Brake Wear Indicators .126
.....................
Disposal of Used Oil .146
...................
Do Not Tow a Trailer .129
Doors
..............
Locking and Unlocking .63
.......................
Monitor Indicator .47
......................
Power Door Locks .63
........
DOT Tire Quality Grading .198
Downshif ting, Manual
.............................
Transmission .123
...........
Driver and Passenger Safety .5
...........................................
Driving .119
....................................
Economy .112
........................
Driving Guidelines .120
..................
Dust and Pollen Filter .158
Index
D
E
II
——y

y
(y
y

ÎÎ
CONT INUED
..........
Taillights, Changing Bulbs .156
.
Taking Care of the Unexpected .169
Technical Descriptions
....
DOT Tire Quality Grading .198
.....
Emissions Control Systems .201
Three Way Catalytic
...............................
Converter .203 .......................
Temperature Gauge .52
...................
Tensioners, Seat Belts .18
................
Thef t Protection, Radio .102
..
Three Way Catalytic Converter .203
............................
Time, Setting the .54
....................................
Tire Chains .165
.........
Tire, How to Change a Flat .171
.................................
Tire Labeling .200
...............................................
Tires .161
..............................
Air Pressure .162
...................................
Balancing .163
........................................
Chains .165
.........................
Checking Wear .162
.................
Compact Spare Tire .170
....
DOT Tire Quality Grading .198
......................................
Inf lation .161
..................................
Inspection .162
...................................
Replacing .164
........................
Rotation, Do not .163
...........................................
Snow .165
............................
Specif ications .197
...........................................
Wear .163
...................
Tools, Tire Changing .171
Shif ting
..............
Manual Transmission .123
Side Turn Signal, Bulb ..............................
Replacement .155
...............................
Signaling Turns .57
.....................................
Snow Tires .165
..................................
Sound System .86
Spare Tire ......................................
Inf lating .162
............................
Specif ications .197
....................................
Spark Plugs .196
................................
Specif ications .196
................................
Speed Control .103
................................
Speed Limiter .124
..........
SRS, Additional Inf ormation .20
...
Additional Safety Precautions .27
.............................
Airbag Service .27
......
Airbag System Components .20
How the SRS Indicator
.......................................
Works .25
How Your Front Airbags .........................................
Work .22
.............................
SRS Indicator .25,47
...................................
Start Button .122.......................
Starting the Engine .122
In Cold Weather at High ..................................
Altitude .122
................
With a Dead Battery .178
..............
State Emissions Testing .204
........
Steam Coming f rom Engine .179
Steering Wheel
.............
Anti-theft Column Lock .62
.....................
Stereo Sound System .86
....................
Storing Your Vehicle .167
................................
Stuck Vehicle .191
Supplemental Restraint System ..................................
Servicing .27
.........................
SRS Indicator .25,47
...................
System Components .20
..................................
Synthetic Oil .144
Index
T
INDEX
VII
——y


y
(yy