2006 HONDA RIDGELINE lock

This indicator has two f unctions:This indicator comes on when you
turn the ignition switch to ON (II).
It is a reminder to check the
parking brake. A beeper sounds if
you try to drive with the parking
brake not fully released. Driving
with the parking brake not fully
released can damage the brakes
and tires. This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0).
If it remains on af ter you have
fully released the parking brake
while the engine is running, or if it
comes on while driving, there
could be a problem with the brake
system. For more inf ormation, see
page . This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II), and when
the ignition switch is turned to
START (III). If it comes on at any
other time, there is a problem with
theABS.If thishappens,haveyour
vehicle checked at a dealer. With
this on, your vehicle still has normal
braking ability but no anti-lock
brakes. For more inf ormation, see
page .
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to ON (II). It will then go of f
if you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine will not start (see
page ).
1.
2.
280 203
78
Parking Brake and Brake System
Indicator
Anti-lock Brake System
(A BS) Indicator
Immobilizer System
Indicator
Instrument Panel Indicators
60
U.S. Canada
—
—y
y
(yy

This indicator monitors the
temperature of the automatic
transmission f luid. It should come on
f or a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on while driving, it means the
transmission fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the indicator
goes out.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on at any other time, there is a
problem in the 4WD system. Take
the vehicle to your dealer to have it
checked.
If the indicator blinks while driving,
the VTM-4 fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the indicator
goes out.
This indicator reminds you that the
exterior lights are on. It comes on
when you turn the headlight control
dial to either the or
position.
If you turn the ignition switch to
ACCESSORY (I) or LOCK (0)
without turning of f the headlight
control dial, this indicator remains on.
A reminder chime will also sound
when you open the driver’s door. Lights On Indicator A/T Temperature
IndicatorVTM-4 Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
63
Continuing to drive with the A/T
temperature indicator on may cause
serious damage to the transmission.
Continuing to drive with the VTM-4
indicator blinking may cause serious
damage to the system.
—
—y
y
(yy

This indicator reminds you that the
bed lights are on. With the shif t lever
in the Park position, they come on
when you push the light switch on
the dashboard, swing open the
tailgate, or open the In-Bed Trunk.This indicator reminds you that the
In-Bed Trunk is open. If you do not
close it, the indicator stays on for
about3minutes. See page f or
more inf ormation.
This indicator reminds you that the
back window is not completely
closed when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0). With the ignition
switch in the ACCESSORY (I)
position, it goes of f af ter about 30
seconds. With the ignition switch in
the LOCK (0) position, it goes of f
af ter about 3 minutes.
If you remove the ignition key and
open the driver’s door without
closing the back window, you will
hear f ive beeps and see the indicator
blink. If you do not close the back
window bef ore the beeper stops, the
indicator stops blinking but remains
on. It will go of f af ter about 3
minutes. See page f or more
inf ormation.
If you turn the ignition switch to
ACCESSORY (I) or LOCK (0)
without turning of f the bed lights,
this indicator will remain on, and
then go of f af ter20minutes. See
page f or more inf ormation.
103
92
117
Instrument Panel Indicators
Back Window Open
Indicator
Bed L ights On Indicator In-Bed T runk Open
Indicator
66
—
—y
y
(y
y

Î
Î
Î
Î
Î
Î To use the horn, press the pad around the ‘‘H’’ logo.
If equipped.
1:
2:
Controls Near the Steering Wheel
Inst rument s and Cont rols
71
HAZARD WARNING
BUTTON
(P.76)
SHIFT LEVER
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
CRUISE BUTTON
CRUISE
CONTROLS
HORN
STEERING WHEEL
ADJUSTMENT VTM-4LOCK
Vehicle with navigation system is shown. BED LIGHT SWITCH MULTI-CONTROL LEVER
(WINDSHIELD WIPERS/
WASHERS/TURN SIGNALS/
HEADLIGHT HIGH BEAMS)
MOONROOF SWITCH
SEAT HEATERS
INTERIOR LIGHT
CONTROL SWITCH
(P.105)
(P.72) (P.117)
(P.206)
(P.163)
(P.159) (P.76)(P.163)
(P.115)
INSTRUMENT PANEL
BRIGHTNESS
(P.75)
(P.193) (P.198)
(P.101)
HEADLIGHT CONTROL
DIAL
(P.73) RESET BUTTON
SELECT BUTTON (P.67)
(P.67)
REMOTE AUDIO
CONTROLS
1
2
2
2
——y


y
(yy

µIf you remove the key f rom the
ignition switch with the headlight
control dial on, but do not open the
door, the lights will turn of f af ter 10
minutes.
The lights will turn on again when
you unlock or open the driver’s door.
If you unlock the door, but do not
open it within 30 seconds, the lights
will go of f . With the driver’s door
open, you will hear a lights-on
reminder chime.
Turning the dial to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, and license plate lights.
Turning the dial to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on and remove
the key from the ignition switch, you
will hear a reminder chime when you
open the driver’s door.
When the dial is in the ‘‘ ’’ or
‘‘ ’’ position, the lights on
indicator comes on as a reminder.
This indicator stays on if you leave
the lights on and turn the ignition
switch to ACCESSORY (I) or LOCK
(0). This f eature turns of f the headlights,
parking lights, taillights, and license
plate lights within 30 seconds of
removing the key from the ignition
switch and closing the driver’s door.
This feature activates if you leave
the headlight control dial in the
‘‘ ’’ or ‘‘ ’’ position, remove
the key, then open and close the
driver’s door.
Headlights
Automatic Lighting Of f Feature
Headlights
74
—
—y
y
(yy

If you do not insert the key in the
ignition switch af ter opening the
driver’s door, the illumination turns
of f about 30 seconds af ter you close
the door.
If you insert the key but do not turn
the ignition switch to ON (II), the
illumination turns of f in about 10
seconds.
The instrument panel brightness is
dimmedwhenyouturntheheadlight
controldialto‘‘ ’’or
‘‘ ’’ position to reduce glare at
night. To cancel it, turn the
instrument panel brightness control
dial upward f ully until you hear a
click.
The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver’s door.
The brightness will increase slightly
when you insert the key in the
ignitionswitch,thengotonormal brightness when you turn the
ignition switch to ON (II).
The dial on the instrument panel
controls the brightness of the
instrument panel lights and the
console compartment light. Turn the
dial to adjust the brightness.
With the headlight control dial of f ,
the high beam headlights and the
high beam indicator come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
switch of f , even if you set the
parking brake.
The headlights revert to normal
operation when you turn them on
with the headlight control dial.
Canadian models only
Instrument Panel Brightness
Daytime Running L ights
Headlights, Instrument Panel Brightness
Inst rument s and Cont rols
75
INSTRUMENT PANEL
BRIGHTNESS CONTROL DIAL
—
—y
y
(yy

Push the lever up to lock the
steering wheel in position.
Make sure you have securely
locked the steering wheel in place
by trying to move it up and down.
Make any steering wheel adjustment
bef ore you start driving.
Pushtheredbuttontoturnonthe
hazard warning lights (f our-way
flashers). This causes all four
outside turn signals and both turn
indicators in the instrument panel to
f lash. Use the hazard warning lights
if you need to park in a dangerous
area near heavy traffic, or if your
vehicle is disabled. Move the steering wheel so it
points toward your chest, not
toward your f ace. Make sure you
can see the instrument panel
gauges and indicators. Push the lever on the lef t side of
the steering column all the way
down.3.
4.
1.
2.
Hazard Warning Button, Steering Wheel A djustment
Steering Wheel A djustment
Hazard Warning Button
76
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
inacrash.
Adjust the steering wheel only
when the vehicle is stopped.
—
—y
y
(y
y

These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
boxlockedwhenyouleaveyour
vehicle and the valet key at a parking
f acility.
You can also keep the In-Bed Trunk
locked by using the main switch in
theglovebox(seepage ). Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a lost key replaced. Use
only Honda-approved key blanks.
94
Keys
Inst rument s and Cont rols
77
VALET KEY
(LIGHT GRAY)
MASTER KEY
WITH REMOTE
TRANSMITTER
KEY
NUMBER
TAG
—
—y

y
(yy