2006 HONDA RIDGELINE ignition

When you press the hazard warning
button, both turn signal indicators
blink. All turn signals on the outside
of the vehicle should f lash.This monitor includes two f unctions;
the door open indicator and the
tailgate open indicator. This monitor
works with the ignition switch in any
position.
The specif ic door indicator comes on
in this monitor if any door is not
closed tightly.
Thetailgateindicatorcomeson
whenthetailgateisswungopenorif
it is not closed completely af ter you
swing it closed.If the tailgate is swung open or is not
closed tightly, you will hear six beeps
and see the indicator blinking when
you turn the ignition switch to the
ON (II) position. The beeper also
sounds and the indicator blinks when
you move the shif t lever out of Park
or neutral position.
The tailgate open indicator does not
monitor the tailgate when it is
dropped open.
If the driver does not f asten the seat
belt and the tailgate is swung open,
the seat belt reminder alarm will
sound at first, then the tailgate open
reminder beeper will sound.
For more inf ormation on the tailgate,
see page .
The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages and ).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
91
246
247
Turn Signal and
Hazard Warning
Indicators
Door and T ailgate Open Monitor
Instrument Panel Indicators
Inst rument s and Cont rols
61
——y


y
(yy

This indicator comes on when you
turn the ignition switch to ON (II)
with the headlight switch off and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This indicator comes on when you
set the cruise control. See pagef or inf ormation on operating the
cruise control. This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator is located in the f uel
gauge. It comes on as a reminder
that you must ref uel soon.
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page ).
This indicator comes on when the
washer f luid level is low. Add washer
f luid when you see this indicator
(see page ).
When the indicator comes on, there
is about 3.30 U.S. gal (12.5
)of fuel
remaining in the tank bef ore the
needle reaches E. There is a small
reserve of f uel remaining in the tank
when the needle does reach E.
163 72
75
240
Canadian models only
‘‘Daytime Running
Lights’’ Indicator
Cruise Control Indicator High Beam Indicator L ow Fuel Indicator
Washer Level Indicator
Instrument Panel Indicators
62
LOW FUEL INDICATOR
—
—y
y
(yy

This indicator monitors the
temperature of the automatic
transmission f luid. It should come on
f or a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on while driving, it means the
transmission fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the indicator
goes out.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on at any other time, there is a
problem in the 4WD system. Take
the vehicle to your dealer to have it
checked.
If the indicator blinks while driving,
the VTM-4 fluid temperature is too
high. Pull to the side of the road
when it is saf e, shif t to Park, and let
the engine idle until the indicator
goes out.
This indicator reminds you that the
exterior lights are on. It comes on
when you turn the headlight control
dial to either the or
position.
If you turn the ignition switch to
ACCESSORY (I) or LOCK (0)
without turning of f the headlight
control dial, this indicator remains on.
A reminder chime will also sound
when you open the driver’s door. Lights On Indicator A/T Temperature
IndicatorVTM-4 Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
63
Continuing to drive with the A/T
temperature indicator on may cause
serious damage to the transmission.
Continuing to drive with the VTM-4
indicator blinking may cause serious
damage to the system.
—
—y
y
(yy

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
If itcomesonandstaysonatany
other time, or if it does not come on
when you turn the ignition switch to
ON (II), there is a problem with the
VSA system. Take your vehicle to a
dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have VSA
traction and stability enhancement.
See page for more information
on the VSA system.This indicator has three f unctions:
Itcomesonasareminderthatyou
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). For more
inf ormation, see page . This indicator reminds you that it is
time to take your vehicle in for
scheduled maintenance. The
maintenance main items and sub
items will be displayed in the
inf ormation display. See page f or
more inf ormation on the
maintenance minder.
This indicator goes of f when your
dealer resets it after completing the
required maintenance service.
1.
2.
3.
205 205
205 225
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator Maintenance Minder
Indicator
Instrument Panel Indicators
64
—
—y


y
(yy

If this indicator comes on and stays
on at any other time, or if it does not
come on when you turn the ignition
switch to ON (II), there is a problem
with the TPMS. With this indicator
on, the low tire pressure indicator
and the tire pressure monitor will not
come on when a tire loses pressure.
Take the vehicle to your dealer to
have the system checked.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are extremely low on
pressure.
If this happens, pull to the side of the
road when it is saf e, check which tire
has lost the pressure on the tire
pressure monitor, and determine the
cause. If it is because of a f lat tire,
replace the flat tire with the compact
spare (see page ), and have the
f lat tire repaired as soon as possible.
If two or more tires are underinf lated,
call a prof essional towing service
(see page ). Ref er to page
f or more inf ormation. This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
The appropriate tire indicator will
come on along with the low tire
pressure indicator if a tire is
extremely underinf lated or has
suddenly lost pressure. See for what to
do if this indicator comes on. This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
264
199 286 Tire Pressure Monitoring
System (T PMS) Indicator
Low Tire Pressure
Indicator T ire Pressure Monitor
Low
Tire Pressure Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
65
—
—y
y
(yy

This indicator reminds you that the
bed lights are on. With the shif t lever
in the Park position, they come on
when you push the light switch on
the dashboard, swing open the
tailgate, or open the In-Bed Trunk.This indicator reminds you that the
In-Bed Trunk is open. If you do not
close it, the indicator stays on for
about3minutes. See page f or
more inf ormation.
This indicator reminds you that the
back window is not completely
closed when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0). With the ignition
switch in the ACCESSORY (I)
position, it goes of f af ter about 30
seconds. With the ignition switch in
the LOCK (0) position, it goes of f
af ter about 3 minutes.
If you remove the ignition key and
open the driver’s door without
closing the back window, you will
hear f ive beeps and see the indicator
blink. If you do not close the back
window bef ore the beeper stops, the
indicator stops blinking but remains
on. It will go of f af ter about 3
minutes. See page f or more
inf ormation.
If you turn the ignition switch to
ACCESSORY (I) or LOCK (0)
without turning of f the bed lights,
this indicator will remain on, and
then go of f af ter20minutes. See
page f or more inf ormation.
103
92
117
Instrument Panel Indicators
Back Window Open
Indicator
Bed L ights On Indicator In-Bed T runk Open
Indicator
66
—
—y
y
(y
y

This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.
There are two trip meters: TRIP A
and TRIP B. Switch between these
displays by pressing the SELECT
button repeatedly. Each trip meter
works independently, so you can
keep track of two dif f erent distances.To reset a trip meter, display it, and
then press and hold the RESET
button until the number resets to
‘‘0.0’’. Both trip meters will reset if
the vehicle’s battery goes dead or is
disconnected. And both continue to
track mileage, even when only one is
displayed.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. Driving
uphill or make turns can cause the
needle to f luctuate or the low f uel
indicator to come on early. The
needle returns to the bottom after
you turn of f the ignition.
Trip Meter Fuel Gauge
Gauges
68
SELECT BUTTON
RESET BUTTON
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
—
—y
y
(yy

If your f uel f ill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
message appears in the odometer
display af ter you start the engine.
The message goes f rom CHECK to
FUEL CAP repeatedly. You will also
hear a beep.
Turn the engine of f , and conf irm the
f uel f ill cap is installed. If it is, loosen
the cap, then retighten it at least 3
clicks. When you restart the engine,
the message appears again. To clear
the message, press and hold the
RESET button until the odometer
display returns.If the system still detects a loose or
missing f uel f ill cap, the malf unction
indicator lamp (MIL) comes on.
Turn the engine of f , and check or
retighten the f uel f ill cap at least 3
clicks. The MIL goes out af ter 3 days
of normal driving once the cap is
tightened or replaced. If it does not
go out, have your dealer inspect the
vehicle. For more inf ormation, see
page .
The inf ormation display in the
instrument panel shows you the
engine oil lif e and maintenance
service items when the ignition
switch is in the ON (II) position. This
inf ormation helps to keep you aware
of the periodic maintenance your
vehicle needs f or continued trouble-
f ree driving. Ref er to page f or
more inf ormation.
279 225
Check Fuel Cap Indicator Maintenance Minder Display
Gauges
70
—
—y
y
(yy